Search   
MSDS 
:
 Diethylammonium Diethyl dithio-Carbamate
CAS 
:
 1518-58-7
SYNONYMS 
:
 Diethylammonium Diethyldithiocarbamate.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 1518-58-7 |Diethylammonium diethyl dithio-carbama| 100 % | 216-175-3 |
| |te | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Hygroscopic (absorbs
moisture from the air).The toxicological properties of this material
have not been fully investigated.

Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
Causes respiratory tract irritation. The toxicological properties of
this substance have not been fully investigated. Can produce delayed
pulmonary edema.
Chronic:
Effects may be delayed.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Avoid ingestion and
inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Keep
refrigerated. (Store below 4C/39F.) Store protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 1518-58-7:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Powder
Color: white to off-white
Odor: none reported
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 82.00 - 84.00 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C9H22N2S2
Molecular Weight: 222.42

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, strong
oxidants, exposure to moist air or water.
Incompatibilities with Other Materials:
Moisture, strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, oxides of nitrogen, irritating and toxic fumes and
gases, carbon dioxide, hydrogen sulfide, sulfur oxides (SOx),
including sulfur oxide and sulfur dioxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 1518-58-7: EZ5425000
LD50/LC50:
Not available.
Carcinogenicity:
Diethylammonium diethyl dithio-carbamate -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 1518-58-7: No information available.
Canada
CAS# 1518-58-7 is listed on Canada's DSL List.
CAS# 1518-58-7 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1518-58-7 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/12/1997 Revision #4 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Copper (II) Sulfide 1317-40-4
Copper (I) Cyanide 544-92-3
Copper (I) Iodide 7681-65-4
3-Amino-1-Propanol, 99% 156-87-6
Copper (I) Oxide 1317-39-1
Curcumin 458-37-7
Iso-Cyanatobenzene 103-71-9
Cyclohexane-1,2-dione 765-87-7
Cyclohexylamine 108-91-8
p-Cymene 99-87-6
L-Cysteine 52-90-4
L-Cysteine Hydrochloride Monohydrate 52-89-1
5-Fluorouracil, 99% 51-21-8
Poly(Ethyl Methacrylate), Sec. Stand., Aver. M.W.340000, Aver. 9003-42-3
gamma-Cyclodextrin 17465-86-0
Dabsyl Chloride 56512-49-3
Dansyl Aziridine 51908-46-4
Dansyl Hydrazine 33008-06-9
1-Decanesulfonic Acid, Sodium Salt 13419-61-9
N-(P-Aminobenzoyl)-L-Glutamic Acid Diethyl Ester, 99% 13726-52-8
Dextrin 9004-53-9
Diacetyl 431-03-8
1,2-Diaminoethane 16889-59-1
Diaminoethane tetra-Acetic Acid Diammonium Salt 20824-56-0
Diaminoethane tetra-Acetic Acid Dipotassium Salt Dihydrate 2001-94-7
Diaminoethane tetra-Acetic Acid Disodium Salt 139-33-3
Diaminoethane tetraacetic acid, tetrasodium salt tetrahydrate 64-02-8
2,4-Diaminophenol dihydrochloride 137-09-7
Dibenzo-18-crown-6 ether 14187-32-7
1,3-Dibromopropane 109-64-8
2,6-Di-tert-butyl-p-cresol 128-37-0
Di-n-butyl ether 142-96-1
Di-iso-butyl ketone 108-83-8
Dichloroacetic Acid 79-43-6
2,3-Dichloro-5,6-dicyanobenzoquinone 84-58-2
Dichlorofluorescein 76-54-0
1,1-Dichloromethyl Methyl Ether 4885-02-3
2,4-Dichlorophenol 120-83-2
Dicyclohexylamine 101-83-7
Dicyclohexylcarbodi-imide 538-75-0
Diethanolamine 111-42-2
1,1-Diethoxyethane 105-57-7
d-(-)-Lactic acid, lithium salt, 98% 27848-81-3
Diethylammonium Diethyl dithio-Carbamate 1518-58-7
Diethyl Carbonate 105-58-8
Di(2-ethylhexyl)phthalate 117-81-7
Diethyl Malonate 105-53-3
Diethyl oxalate 95-92-1
Diethyl Pyrocarbonate 1609-47-8
Diethyl Sulfate 64-67-5

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com