Search   
MSDS 
:
 Trimethylacetaldehyde
CAS 
:
 630-18-2
SYNONYMS 
:
 Pivalaldehyde
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 630-18-2 |Trimethylacetonitrile | 98.0 | 211-133-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: F
Risk Phrases: 11

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Highly flammable.The toxicological properties of this material have
not been fully investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause digestive tract disturbances.
Inhalation:
May cause respiratory tract irritation. Vapors may cause dizziness
or suffocation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. Use water
spray to keep fire-exposed containers cool. Extremely flammable
liquid and vapor. Containers may explode in the heat of a fire.
Vapors may be heavier than air. They can spread along the ground
and collect in low or confined areas. Will be easily ignited by
heat, sparks or flame.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Water may be ineffective. Do NOT use straight streams of
water.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation. A
vapor suppressing foam may be used to reduce vapors. Water spray may
reduce vapor but may not prevent ignition in closed spaces.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Ground and bond containers when transferring material. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Refrigerator/flammables. Regularly check inhibitor levels to maintain
peroxide levels below 1%. After opening, purge container with
nitrogen before reclosing. Periodically test for peroxide formation
on long-term storage. Addition of water or appropriate reducing
materials will lessen peroxide formation.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate general or local explosion-proof ventilation to keep
airborne levels to acceptable levels.
Exposure Limits
CAS# 630-18-2:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Wear a NIOSH/MSHA or European Standard EN 149
approved full-facepiece airline respirator in the
positive pressure mode with emergency escape
provisions.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear slightly yellow
Odor: none reported
pH: ~6
Vapor Pressure: 210 mm Hg @ 20C
Viscosity: Not available.
Boiling Point: 74 deg C @ 730.00mmHg
Freezing/Melting Point: 6 deg C
Autoignition Temperature: Not available.
Flash Point: -15 deg C ( 5.00 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: Slightly soluble.
Specific Gravity/Density: .7930g/cm3
Molecular Formula: C5H10O
Molecular Weight: 86.13

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures. On long term
storage, substances with similar functional groups form explosive
peroxides.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Oxidizing agents
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: May occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 630-18-2 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Trimethylacetonitrile -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F
Risk Phrases:
R 11 Highly flammable.
Safety Phrases:
S 7 Keep container tightly closed.
S 16 Keep away from sources of ignition - No
smoking.
WGK (Water Danger/Protection)
CAS# 630-18-2: No information available.
Canada
CAS# 630-18-2 is listed on Canada's NDSL List.
CAS# 630-18-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 630-18-2 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 8/10/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Propargyl bromide, 80 wt% solution in toluene, stabilized 106-96-7
Carbowax PEG 8000 25322-68-3
1-Bromopentane, 98% 110-53-2
Hydrindantin dihydrate, 96% 5950-69-6
Benzylacetone, 98% 2550-26-7
2-Amino-5-Chlorobenzophenone Oxime, Mixture of Syn and Anti Isomers 18097-52-4
Trimethylacetaldehyde 630-18-2
Polyvinyl Alcohol 9002-89-5
Tetraphenyltin, 97% 595-90-4
Potassium Metal 7440-09-7
1-Chloro-2-Fluorobenzene, 99% 348-51-6
Potassium Acetate 127-08-2
5-Fluorocytosine, 99+% 2022-85-7
Trichloroisocyanuric Acid, 99% (Titr.) 87-90-1
Potassium Bitartrate 868-14-4
Solketal, 97+%(GC) 100-79-8
Aluminum Potassium Sulfate Dodecahydrate 7784-24-9
1,4-Naphthoquinone-2-Sulfonic Acid, Potassium Salt 34169-62-5
1,2,3,4-Tetrahydro-1-Naphthylamine 2217-40-5
12-Crown-4, 97+% 294-93-9
Dimethyl Nitroterephthalate, 99% 5292-45-5
3-Nitrobenzamide, 98% 645-09-0
3-Pyridinesulfonic acid, 98% (titr.) 636-73-7
2-Methyltetrahydrofuran 99+% stabilized with 1% Butylated 96-47-9
Potassium Bicarbonate 298-14-6
Cyclobutyl-4-fluorophenyl ketone, 98% 31431-13-7
1-Triphenylphosphoranylidene-2-Propanone, 99% 1439-36-7
Methyl 3,5-Dimethoxy-4-Hydroxybenzoate, 98% 884-35-5
2-Amino-5-Iodobenzoic Acid, 99% 5326-47-6
5-Bromo-2-Chlorobenzoic Acid, 98% 21739-92-4
Potassium Bromide 7758-02-3
2-Acetylbenzoic acid, 99% 577-56-0
Potassium carbonate anhydrous 584-08-7
Potassium chlorate 3811-04-9
2-Bromohexadecanoic acid, 98%. 18263-25-7
Diphenylmercury 587-85-9
Potassium chloride 7447-40-7
2-(Tert-Butylamino)ethanol, 99+% 4620-70-6
Potassium chromate 7789-00-6
Potassium Citrate Monohydrate 6100-05-6
2-Methoxybenzyl alcohol, 99% 612-16-8
Chromium (III) Potassium Sulfate Dodecahydrate 7788-99-0
Potassium Cyanide 151-50-8
Oxalyl chloride, 98% 79-37-8
Amberlyst 15(wet) ion-exchange resin 9037-24-5
Potassium dichromate 7778-50-9
Potassium ferricyanide 13746-66-2
Potassium Ferrocyanide Trihydrate 14459-95-1: Oral, rat
3-Sulfobenzoic Acid Disodium Salt Mono- Hydrate 14995-40-5
Methylene Blue 61-73-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net