LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:SKIN:PRLNG/FREQUENT CONTACT MAY
CAUSE DEFAT, DRYNESS W/IRRIT & POSSIBLE IRRIT. STYRENE MAY BE
ABSORBED THRU SKIN IN TOX AMTS. EYES:MAY CAUSE TEARING & IRRIT.
INHAL:VAPORS MAY CAUSE NOSE, THROAT & RESP TRACT IRRIT. HIGH CONCS
MAY CAUSE HDCH & NAUSEA. RPTD HIGH CONC EXPOS MAY CAUSE LIVER &
KIDNEY (EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE:GROUP 2B(IARC).
Effects of Overexposure:HLTH HAZ:DMG. INGEST:MAY CAUSE GI DISTURBANCES,
PAIN & DISCOMFORT. CHRONIC:INHAL:RPTD EXPOSURE TO HIGH
CONCENTRATION MAY CAUSE LIVER & KIDNEY DAMAGE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:SKIN:WASH W/SOAP & WATER. EYES:FLUSH W/WATER FOR AT LEAST 15
MINUTES. GET MD. INHAL:REMOVE VICTIM FROM EXPOSURE. IF VICTIM IS
UNCONSCIOUS GIVE ARTF RESP/O*2 AS NEEDED. GET MD. INGEST:DO NOT
INDUCE VOM IT (ASPIRATION HAZARD). GET IMMED MED ATTN.
===================== Fire Fighting Measures =====================
Flash Point Method:CC
Flash Point:88.0F,31.1C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:WATER SPRAY, FOAM, DRY CHEMICAL OR CO*2.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:AT ELEVATED TEMPS SUCH AS IN A FIRE,
POLYMERIZATION MAY TAKE PLACE. IF CONTAINED, VIOLENT RUPTURE MAY
RESULT.
Spill Release Procedures:REMOVE SOURCES OF IGNITION. ABSORB SPILL
W/ABSORBENT MATERIAL SUCH AS VERMICULITE OR SAND.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:AVOID STORAGE ABOVE 100F. STORE ONLY
IN ORIGINAL CONTAINERS.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Respiratory Protection:A NIOSH/MSHA APPROVED CANISTER TYPE RESPIRATOR
MUST BE WORN TO PREVENT INHALATION OF VAPORS OR SPRAY MISTS WHEN
TLV/PEL IS EXCEEDED. WEAR NIOSH/MSHA APPROVED DUST MASK WHEN
SANDING CURED PRODUCT.
Ventilation:GENERAL VENTILATION IS REQUIRED DURING NORMAL USE.
Protective Gloves:PLASTIC/CHEM RESISTANT GLOVES.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FCSHLD.
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
HCC:F4
Boiling Pt:B.P. Text:295F,146C
Vapor Pres:4.3 @ 20C
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN BUTYL ACETATE
Solubility in Water:NIL
Appearance and Odor:CLEAR LIQUID, AROMATIC ODOR.
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS & OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT & DIRECT SUNLIGHT.
Hazardous Decomposition Products:HEATING TO DECOMPOSITION MAY CAUSE
EMISSION OF IRRITATING SUBSTANCES.
Conditions to Avoid Polymerization:ELEVATED TEMPERATURES.
Waste Disposal Methods:SMALL QUANTITIES CAN BE REACTED W/APPROPRIATE
HARDENER TO SOLIDIFY. DISPOSE OF I/A/W ALL FEDERAL, STATE & LOCAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.