=====================  Product Identification  =====================

MSDS NAME:5485 LATEX SATIN PORCH & FLOOR ENAMEL, TINT BASE
Status Code:A
MSDS Number: CLSLK
=== Responsible Party ===
Company:SEARS ROEBUCK AND CO
Address:233 S WACKER DR
City:CHICAGO
State:IL
ZIP:60684
Country:US
Info Phone Num:216-566-2902
Emergency Phone Num:216-566-2917
CAGE:53800
=== Contractor Identification ===
Company:SEARS ROEBUCK AND CO
Address:233 S WACKER DR
Box:City:CHICAGO
State:IL
ZIP:60684
Country:US
Phone:216-566-2902
CAGE:53800

=============  Composition/Information on Ingredients  =============

Name:QUARTZ
CAS:14808-60-7
RTECS #:VV7330000
= Wt:19.
OSHA PEL:.1MG/M3 AS RESP.DUST
ACGIH TLV:0.1 MG/M3

=====================  Hazards Identification  =====================

Reports of Carcinogenicity:NTP:YES    IARC:YES	  OSHA:NO
Health Hazards Acute and Chronic:IRRITATION OF EYES, SKIN AND UPPER
    RESPIRATORY SYSTEM. IN A CONFINED AREA VAPORS IN HIGH CONCNETRATION
    MAY CAUSE HEADACHE, NAUSEA OR DIZZINESS.
Explanation of Carcinogenicity:CRYSTALLINE SILICS (QUARTZ,
    CRISTOBALITE) IS LISTED BY IARC AND NTP. LONG TERM EXPOSURE TO HIGH
    LEVELS OF SILICA DUST, WHICH CAN OCCUR ONLY WHEN SANDING OR
    ABRADING THE DRY FILM, MAY CAUSE LUNG DAMAGE  (SILICOSIS) AND
    POSSIBLE CANCER.
Effects of Overexposure:REDNESS AND ITCHING OR BURNING SENSATION MAY
    INDICATE EYE OR EXCESSIVE SKIN EXPOSURE.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE FROM EXPSOURE. RESTORE BREATHING. KEEP
    WARM AND QUIET. SKIN: WASH AFFECTED AREA WITH SOAP AND WATER.
    REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE RE-USE. EYE: FLUSH
    EYES W/LARGE  AMOUNTS OF WATER FOR 15 MINUTES. INGESTION: GET
    MEDICAL ATTENTION. OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:DRY CHEMICAL, ALCOHOL FOAM, CARBON DIOXIDE
Fire Fighting Procedures:FULL PROTECTIVE EQUIPMENT INCLUDING SCBA
    SHOULD BE USED. WATER SPRAY MAY BE INEFFECTIVE. IF WATER IS USED,
    FOG NOZZLES ARE PREGERABLE. WATER MAY BE USED TO COOL CLOSED
    CONTIANERS TO PREVENT PRESSURE B UILD-UP AND POSSIBLE AUTOIGNITION
    OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
    BUILD-UP OF PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AND
    REMOVE WITH INERT ABSORBENT.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE ONLY W/ADEQUATE VENTILATION. AVOID
    BREATHING VAPOR AND SPRAY MIST. AVOID CONTACT WITH SKIN AND EYES.
    WASH HANDS AFTER USING.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF PERSOAL EXPOSURE CANNOT BE CONTROLLED BELOW
    APPLICABLE LIMITS BY VENTILATION, WEAR A PROPERLY FITTED ORGANIC
    VAPOR/PARTICULATE RESPIRATOR APPROVED BY NIOSH/MSHA FOR PROTECTION
    AGAINST INGREDIENTS.
Ventilation:LOCAL EXHAUST PERFERABLE. GENERAL EXHAUST ACCEPTABLE IF THE
    EXPOSURE IS MAINTAIN BELOW APPLICABLE LIMITS.
Protective Gloves:RECOMMENDED GLOVES FOR MATERIALS LISTED IN SECTION II
Eye Protection:SAFETY SPECTACLE WITH UNPERFORATED SIDE SHIELDS.
Work Hygienic Practices:WHEN SANDING OR ABRADING THE DRIED FILM, WEAR A
    DUST/MIST RESPIRATOR APPROVED BY NIOSH/MSHA FOR DUST WHICH MAY BE
    GENERATED FROM THIS PRODUCT, UNDERLYING PAINT, OR THE ABRASIVE.
Supplemental Safety and Health
COATING MAY CONTAIN MATERIALS CLASSIFIED AS NUISANCE PARTICULATES WHICH
    MAY BE PRESENT AT HAZARDOUS LEVELS ONLY DURING SANDING/ABRADING OF
    DRIED FILM. IF NO SPECIFIC DUSTS ARE LISTED APPLICABLE LIMITS  FOR
    NUISANCE DUSTS ARE ACGIH TLV 10 MG/M3 (TOTAL DUST), OSHA PEL 15
    MG/M3 (TOTAL DUST), 5 MG/M3 (RESPIRABLE FRACTION)

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:212-477 F
Vapor Density:>AIR
Spec Gravity:1.16
VOC Pounds/Gallon:80
pH:9.5
VOC Grams/Liter:.67
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:LATEX PAINT
Percent Volatiles by Volume:70

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN
Stability Condition to Avoid:NONE KNOWN
Hazardous Decomposition Products:BY FIRE: CO AND CO2

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM THIS PRODUCT IS NOT HAZARDOUS AS
    DEFINED UNDER THE RCRA. INCINERTE IN APPROVED FACILITY. DO NOT
    INCINERATE CLOSED CONTAINER. DISPOSE OF IN ACCORDANCE W/LOCAL,
    STATE & FEDERAL REGULATIONS.

===================  MSDS Transport Information  ===================

Transport Information:TRICHLOROETHYLENE SOLUTION, CLASS 6.1, UN1710.

=====================  Regulatory Information  =====================

SARA Title III Information:NONE
State Regulatory Information:THIS PRODUCT CONTAINERS CHEMICALS KNOWN TO
    THE STATE OF CALIFORNIA TO CAUSE CANCER.

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***