===================== Product Identification =====================
MSDS NAME:259S ADDITIVES FOR TOPCOATS
NIIN:01-129-1125
MSDS Number: BGTQH
=== Responsible Party ===
Company:EI DUPONT/AUTOMOTIVE PRODS DEPT
Address:1007 MARKET ST BRANDYWINE BLDG 3332
City:WILMINGTON
State:DE
ZIP:19898
Country:US
Info Phone Num:(800) 441-7515
Emergency Phone Num:(800) 441-7515
CAGE:EO478
=== Contractor Identification ===
Company:DU PONT E I DE NEMOURS & CO FABRICATED PROD DEPT
Address:1007 MARKET ST BRANDYWINE BLDG 3332
Box:City:WILMINGTON
State:DE
ZIP:19898
Country:US
Phone:800-441-3637
CAGE:90227
Company:EI DUPONT/AUTOMOTIVE PRODS DEPT
Address:1007 MARKET ST BRANDYWINE BLDG 3332
City:WILMINGTON
State:DE
ZIP:19898
Country:US
Phone:(800) 441-7515
CAGE:EO478
============= Composition/Information on Ingredients =============
Name:POLYDIMETHYL SILOXANE (LATEX), DIMETHICONE 350, LATEX
CAS:9016-00-6
RTECS #:TQ2690000
Name:XYLENE, DIMETHYLBENZENE, XYLOL
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 98%
Other REC Limits:100 PPM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM, SKIN
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:WEIGHT PER GALLON IN POUNDS: 7.20-11.41
RTECS #:9999999WG
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGESTION: GASTROINTESTINAL DISTRESS.
INHALATION: NOSE/THROAT IRRITATION, EYE WATERING, HEADACHES,
NAUSEA, DIZZINESS & LOSS OF COORDINATION. EYES: IRRITATION OR
BURNING. SKIN: IRRIATION, DISCOMFORT & DERMATITIS.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INGESTION: GASTROINTESTINAL DISTRESS.
INHALATION: PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. EYES:
IRRITATION OR BURNING. SKIN: IRRITATION, DISCOMFORT & DERMATITIS.
======================= First Aid Measures =======================
First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: FLUSH W/PLENTY OF
WATER FOR AT LEAST 15 MINS. SKIN: WASH W/SOAP & WATER. OBTAIN
MEDICAL ATTENTION IN ALL CASES.
===================== Fire Fighting Measures =====================
Flash Point Method:CC
Flash Point:100F
Lower Limits:0.9%
Upper Limits:13.1%
Extinguishing Media:WATER SPRAY, FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:USE FULL PROTECTIVE EQUIP & SCBA. USE WATER
FROM FOG NOZZLES TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE
BUILD UP.
Unusual Fire/Explosion Hazard:WHEN HEATED >100F, EMITS FLAMMABLE VAPORS
WHICH, WHEN MIXED W/AIR CAN BURN OR BE EXPLOSIVE. FINE MISTS/SPRAYS
MAY BE FLAMMABLE AT TEMPS <100F.
================== Accidental Release Measures ==================
Spill Release Procedures:VENTILATE AREA. REMOVE SOURCES OF IGNITION.
WEAR PROTECTIVE EQUIPMENT. CONFINE & REMOVE W/INERT ABSORBENT.
====================== Handling and Storage ======================
Handling and Storage Precautions:KEEP AWAY FROM HEAT/SPARKS/OPEN FLAME.
CLOSE CONTAINER AFTER EACH USE. GROUND CONTAINERS WHEN POURING.
DON'T STORE >120F. OBSERVE LABEL PRECAUTIONS.
Other Precautions:DON'T SAND, FLAME CUT, BRAZE OR WELD DRY COATING
W/OUT A NIOSH/MSHA APPROVED RESPIRATOR OR APPROPRIATE VENTILATION.
AVOID CONTACT W/SKIN & BREATHING OF VAPOR OR MISTS. DON'T PERMIT
ANYONE W/OUT PROTEC TION IN THE PAINTING AREA.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:FOR USE W/PAINTS DURING APPLICATION & UNTIL ALL
VAPORS/SPRAY MISTS ARE EXHAUSTED USE A PROPERLY FITTED
VAPOR/PARTICULATE RESPIRATOR NIOSH/MSHA (TC-23). IN CONFINED SPACES
USE A POSITIVE PRESSURE SUPPL IED AIR RESPIRATOR (TC-19C).
Ventilation:SUFFICIENT IN VOLUME & PATTERN TO KEEP AIR
Evaporation Rate & Reference:LESS THAN ETHER
Solubility in Water:MISCIBLE
Percent Volatiles by Volume:53-99%
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:HEAT, SPARKS, OPEN FLAME, TEMPS >120F OR
OTHER SOURCES OF IGNITION
Hazardous Decomposition Products:CO, CO2, SMOKE
==================== Disposal Considerations ====================
Waste Disposal Methods:DON'T ALLOW MATERIAL TO CONTAMINATE GROUND WATER
SYSTEMS. INCINERATE ABSORBED MATERIAL IN ACCORDANCE WITH FEDERAL,
STATE, & LOCAL REQUIREMENTS. DON'T INCINERATE IN CLOSED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|