===================== Product Identification =====================
MSDS NAME:UNSATURATED POLYESTER RESIN
NIIN:00-633-8373
MSDS Number: BBRNS
=== Responsible Party ===
Company:CHEMICAL COMMODITIES AGENCY INC/HIGHLAND, CA 92346
Emergency Phone Num:(714) 864-2310
CAGE:60777
=== Contractor Identification ===
Company:CHEMICAL COMMODITIES AGENCY, INC.
Address:27447 PACIFIC STREET
Box:City:HIGHLAND
State:CA
ZIP:92346-2640
Country:US
Phone:909-864-2310
CAGE:60777
============= Composition/Information on Ingredients =============
Name:STYRENE, MONOMER (SARA III)
CAS:100-42-5
RTECS #:WL3675000
Fraction by Wt: <50%
OSHA PEL:100 PPM
ACGIH TLV:S,50PPM/100STEL;9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:UNSATURATED POLYESTER
Fraction by Wt: >50%
===================== Hazards Identification =====================
Effects of Overexposure:IRRITATING EYES & RESPIRATORY PASSAGES. CAN
CAUSE A DEPRESSANT ACTION ON THE CENTRAL NERVOUS SYS.
======================= First Aid Measures =======================
First Aid:IN ALL CASES OF OVEREXPOSURE, CALL A PHYS. REMOVE FROM
EXPOSURE TO WELL VENTILATED AREA. IF SKIN CONTACT: WASH THOROUGHLY
W/SOAP/WATER. IN CASE OF EYE CONTACT, FLUSH W/WATER. IF TAKE
INTERNALLY, DON'T INDUCE VOMITING. IF RESP PROBLEMS ARISE OXYGEN.
===================== Fire Fighting Measures =====================
Flash Point:89F SETA FLASH
Extinguishing Media:DRY CHEMICAL, CO2, FOAM
Fire Fighting Procedures:SAME PROCEDURES USED FOR FUEL OIL FIRE.
Unusual Fire/Explosion Hazard:STYRENE WILL POLYMERIZE READILY AT
ELEVATED TEMPERATURES SUCH AS FIRE CONDITIONS.
================== Accidental Release Measures ==================
Spill Release Procedures:EXTINGUISH ALL SOURCES OF IGNITION; INSURE
ADEQUATE VENTILATION; CLEAN SPILLS BY ABSPTION WITH INERT MATERIALS
SUCH AS VERMICULITE OR SAND. WASH AREA WELL WH TRISODIUM PHOSPHATE
AND WATER, DISPOSAL MU ST CONFORM TO LOCAL, STATE RULATIONS
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN A COOL DRY PLACE AWAY FROM
HEAT SPARKS OR OPEN FLAME. AVOID BUILD UP OF RESIN ON CLOTNG AND
SHOES. ALWAYS MIX SEPARATELY.
Other Precautions:OPEN DRUMS SLOWLY TO RELIEVE ANY INTERNAL PRESSURE.
IN BULK STORAGE TANKS, CHECK VENTS & FLAME ARRESTORS FOR PLUGGING
BY FORTION OF POLYMER SOLIDS. GROUND ALL CONTAINERS WHEN USING.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:SCBA APPROVED BY THE U.S. BUREAU OF MINES WHEN
TLV EXCEEDED.
Ventilation:LOCAL EXHAUST
Protective Gloves:NEOPRENE
Eye Protection:SAFETY GLASSES/MASK
Other Protective Equipment:SAFETY SHOWERS & EYE WASH STATIONS SHOULD BE
AVAILABLE.
Supplemental Safety and Health
MSDS DATED: 4/20/82.
================== Physical/Chemical Properties ==================
Boiling Pt:B.P. Text:295F
Vapor Pres:20C
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:CLEAR AMBER LIQUID.
Percent Volatiles by Volume:<50%
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
PEROXIDES AND STRONG OXIDIZING AGENTS AND STRONG ACIDS
Stability Condition to Avoid:PROLONGED EXPOSURE TO HEAT & SUNLIGHT
Hazardous Decomposition Products:CO2 AND CO2, LOW MOLECULAR WEIGHT
HYDROCARBONS.
Conditions to Avoid Polymerization:SUNLIGHT/OPEN
FLAMES/CONTAMINATION/PROLONGED STORAGE >100F.
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE OF MATERIALS AND SOAKED RAGS IN FLAME
PROOF CONTAINERS IN ACCORDANCE WITH LOCAL STATE AND FEDERAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|