FLOCON庐 135 (AS-135)
Material Safety Data Sheet
Issue Date: 11/8/04 Revision Date: 8/25/05 Supersedes: 8/25/05
1. Chemical Product and Company Identification
FLOCON庐 135
Product Name:
General Use: Reverse osmosis antiscalant
Emergency Telephone Numbers: For Chemical Emergency, Spill Leak Fire Exposure or
Accident - Call CHEMTREC Day or Night
DOMESTIC NORTH AMERICA 800-424-9300
INTERNATIONAL, CALL 703-527-3887 (collect calls
accepted)
2. Composition/ Information on Ingredients
Chemical Name CAS # Wt.% PEL TWA
Trade Secret # 1 No data No data Not set
COMMENTS:
Our company is withholding the specific chemical identity under provision of the OSHA Hazard Communication
Rule Trade Secrets (1910.1200(1)). The specific chemical identity will be made available to health
professionals in accordance wit 29 CFR 1910.1200 (1) (2) (3) (4). This Material Safety Data Sheet provides
information for employee training and hazard identification. New Jersey Trade Secret Number: BL-5129-P.
3. Hazards Identification
Health Effects:
Material is stable and non-hazardous under normal conditions of use. In fire conditions, toxic vapors
of phosphorous oxides and carbon monoxide, and carbon dioxide may be released. No significant
health effects anticipated.
Acute Effects:
Eyes: This product may be mildly irritating to eyes.
However, it is unlikely to cause any more than mild
transient discomfort. It is also unlikely to cause any
lasting effects.
Skin: Data suggests that this product should present no
significant problems.
If Swallowed: Data suggests that this product should present no
significant problems.
If Inhaled: Data suggests that this product should present no
significant problems. LD50 Oral (Rat) >5,000mg/kg
4. First Aid Measures
Page 1 of 5
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above information and data.
Revised 10/18/2005
Flocon 135 (AS-135) MSDS (continued)
If poisoning occurs, contact a Doctor or Poison Control Center.
Eyes: If product gets in eyes, flush with plenty of water. Get medical attention if
irritation occurs and persists.
Skin: If product gets on skin, wash with plenty of soap and water. Get medical
attention if irritation occurs and persists.
If Swallowed: If swallowed, do NOT induce vomiting. Drink plenty of water. Never give
anything by mouth to an unconscious person. If any discomfort persists,
obtain medical attention.
If Inhaled: Remove to fresh air. If breathing difficulty or discomfort occurs and
persists, obtain medical attention.
5. Fire Fighting Measures
Flash Point and Method: Does not burn.
Flammable Limits: Not applicable. This product does not burn.
Extinguishing Media: This product does not burn. Use extinguishing media
suited to the materials that are burning.
Fire/ Explosion Hazards: There is no risk of an explosion from this product under
normal circumstances if it is involved in a fire.
Fire Fighting Procedures: When fighting fires involving significant quantities of this
product, wear safety boots, non-flammable overalls,
gloves, hat and preferably, goggles.
Hazardous Decomposition Fire decomposition products from this product may form
Products: carbon monoxide, carbon dioxide, and phosphorous
oxides. Likely to decompose only after heating to dryness
followed by further strong heating.
6. Handling and Storage
HANDLING:
Avoid the generation of mists in occupied areas.
STORAGE:
Containers should be kept closed in order to minimize contamination. Keep from extreme heat and
open flames, and make sure that the product does not come into contact with substances listed
under "Materials to avoid" below.
Materials to avoid: bases, nitrites, sulfites.
No special transport requirements. This product has no UN classification.
7. Exposure Controls/ Personal Protection
Engineering Controls:
Under normal conditions of use, exposure should not be a significant concern. Use with general
room ventilation or local exhaust when airborne contamination is expected. Under unusual or
emergency conditions, the personal protective equipment indicated below is recommended.
Page 2 of 5
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above information and data.
Revised 10/18/2005
Flocon 135 (AS-135) MSDS (continued)
PERSONAL PROTECTIVE EQUIPMENT
Eyes and Face: Use chemical-type goggles or face shield.
Respiratory: Use MSHA/NIOSH approved dust/mist respiratory protection when
airborne mist is expected.
Protective Clothing: Use impervious gloves. Wear impervious apron and gauntlets when
splashing is expected during liquid transfers. Wear normal workshoes
except in conditions of spills where rubber overshoes
or boots would be required.
Spill or Leaks: Isolate area. Wear prescribed protective clothing and equipment.
Dike to confine spill. Absorb with an absorbent. Shovel waste into
an approved container. To decontaminate spill area, tools and
equipment, wash with water and add to drums of waste already
collected. Open dumping or burning of this material or its packaging
is prohibited. If spilled material cannot be disposed of by use
according to label instructions, an acceptable method of disposal is to
incinerate in accordance with local, state and national environmental
laws, rules, standards and regulations. However, because acceptable
methods of disposal may vary by location and regulatory
requirements may change, the appropriate agencies should be
contacted prior to disposal.
Whenever possible, our company encourages recycling of containers.
Always wash hands before smoking, eating or using the toilet. Wash contaminated clothing and
other protective equipment before storing or re-using.
8. Physical and Chemical Properties
Odor Slight odor.
Appearance Clear, Colorless liquid.
Corrosiveness Corrosiveness: Not corrosive. pH 3.5-4.5
Viscosity Viscosity: 45mm2/sec at 25掳C
Boiling Point Approximately 101-103掳C at 100kPa.
Melting Point Approximately -5掳C.
Freezing Point -3掳C to -1掳C
Specific Gravity 1.13 to 1.18@20潞C
Solubility in Water Miscible @25潞C (% by wt.)
pH 3 to 5
Percent Volatile Not Available.
Vapor Pressure 24 mmHg @25掳C (water)
Vapor Density (Air = 1): 0.020 @25潞C
Oxidizing Properties Not Available
Odor Threshold Not Available
Coeff. Oil/Water Not Available
Density Not Available
Page 3 of 5
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above information and data.
Revised 10/18/2005
Flocon 135 (AS-135) MSDS (continued)
9. Stability and Reactivity
Stability: Stable.
Polymerization: Will not occur.
Hazardous Decomposition Thermal decomposition and burning may produce carbon
Products: monoxide, carbon dioxide and phosphorous
oxides.
Incompatible Materials: Alkaline materials, acid reactive salts such as nitrites and
sulphites, mild steel.
10. Toxicological Information
EYE EFFECTS: Non-irritant (rabbit)
SKIN EFFECTS: Non-irritant (rabbit)
ORAL LD50: >5000 mg/kg (rat)
ACUTE EFFECTS FROM OVEREXPOSURE: Product is non-irritating to the eyes and skin.
CHRONIC EFFECTS FROM OVEREXPOSURE: A 90-day toxicity study was conducted in rats with the
material administered daily by oral gavage at 0, 100, 500, and 2500 mg/kg/day. The no observed
effect level (NOEL) was 200 mg/kg/day, with changes in levels of phosphorus in blood and urine
being reported at 500 mg/kd/day. Bone damage and kidney degeneration which did not reverse
during recovery were reported at 2500 mg/kg/day. Product was not genotoxic in standard tests.
CARCINOGENICITY:
IARC: Not listed
NTP: Not listed
OSHA: Not listed
OTHER: ACGIH: Not listed
11. Ecological Information
ECOTOXICOLOGICAL INFORMATION:
Rainbow Trout: 96 hour LC50 > 1000 ppm (solids)
Zebra Fish: 96 hour LC50 > 1000 ppm (solids)
Brown Shrimp: 96 hour LC50 > 10,000 ppm
Daphnia Magna: 24 hour EC50 > 320 ppm
Algae: (Scenedesmus subspicatus) EBC50 (0-72 hour) = 130 ppm
CHEMICAL FATE INFORMATION:
Effluent data -
BOD: Modified OECD test 301E-Not Biodegradable
OECD Closed Bottle Test 301D-Not Biodegradable
COD: 1.113 g Oxygen/g
12. Transport Information
U.S. DOT (DEPARTMENT OF TRANSPORTATION)
Page 4 of 5
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above information and data.
Revised 10/18/2005
Flocon 135 (AS-135) MSDS (continued)
PROPER SHIPPING NAME: Not regulated
PRIMARY HAZARD CLASS/DIVISION: Not applicable
UN/NA NUMBER: None
PLACARDS: Not required
LABEL: Not required
OTHER SHIPPING INFORMATION:
DOT Marking: Not required
Hazardous Substance/RQ: Not applicable
49 STCC Number: Not available
SPECIAL SHIPPING NOTES:
IMDG: Not regulated
IATA: Not regulated
Keep container tightly closed. Protect against physical damage.
STATE REGULATIONS
PROPOSITION 65: This product does not contain any substance(s) which are defined by the state
of California to cause cancer, birth defects, or other reproductive effects.
HMIS Rating
Key
HEALTH 1
4= Severe
FLAMMABILITY 0
3= Serious
REACTIVITY 0 2= Moderate
PROTECTION 1= Slight
Flammability
0
1 0
Health: Reactivity
None
The contents and format of this MSDS are in accordance with OSHA Hazard Communication Standard and
Canada鈥檚 Workplace Hazardous Information System (WHMIS).
National Fire Protection Association (NFPA)
Hazardous Materials Identification System (HMIS)
MANUFACTURER DISCLAIMER: IMPORTANT: This information is given without a warranty or guarantee. No
suggestions for use are intended or shall be construed as a recommendation to infringe any existing patents or violate any
federal, state, local or international laws. Safe handling and use is the responsibility of the customer. Read the label before
using this product. This information is true and accurate to the best of our knowledge.
Page 5 of 5
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above information and data.
Revised 10/18/2005
|