**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 100-66-3 |Anisole | 99.0 | 202-876-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 10 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Flammable. Irritating to eyes, respiratory system and skin.Flammable
liquid.Hygroscopic (absorbs moisture from the air).
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes moderate skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
Causes respiratory tract irritation. Vapors may cause dizziness or
suffocation.
Chronic:
Laboratory experiments have resulted in mutagenic effects.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Antidote:
None reported.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Water runoff can cause environmental damage. Dike
and collect water used to fight fire. Vapors may form an explosive
mixture with air. Vapors can travel to a source of ignition and
flash back. Will burn if involved in a fire. Use water spray to keep
fire-exposed containers cool. Water may be ineffective. Material is
lighter than water and a fire may be spread by the use of water.
Containers may explode in the heat of a fire. Flammable liquid and
vapor. Vapors may be heavier than air. They can spread along the
ground and collect in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Water may be ineffective. This material is lighter than
water and insoluble in water. The fire could easily be spread by the
use of water in an area where the water cannot be contained. Do NOT
use straight streams of water.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. A vapor suppressing foam
may be used to reduce vapors.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Use
spark-proof tools and explosion proof equipment. Empty containers
retain product residue, (liquid and/or vapor), and can be dangerous.
Keep away from heat, sparks and flame. Avoid ingestion and
inhalation. Do not allow contact with water. Do not pressurize, cut,
weld, braze, solder, drill, grind, or expose empty containers to
heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Flammables-area. Store protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use process enclosure, local exhaust ventilation, or other
engineering controls to control airborne levels below recommended
exposure limits. Facilities storing or utilizing this material should
be equipped with an eyewash facility and a safety shower.
Exposure Limits
CAS# 100-66-3:
Russia: 10 mg/m3 TWA
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear straw colored
Odor: Agreeable, aromatic odor.
pH: Not available.
Vapor Pressure: 10 mm Hg @ 42.2 C
Viscosity: 1.52 cps @ 15 C
Boiling Point: 154 deg C @ 760.00mm Hg
Freezing/Melting Point: -37 deg C
Autoignition Temperature: 475 deg C ( 887.00 deg F)
Flash Point: 41 deg C ( 105.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: .9950g/cm3
Molecular Formula: C7H8O
Molecular Weight: 108.14
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Mechanical shock, incompatible materials, ignition sources,
temperatures above 50C (122F), exposure to moist air or water.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 100-66-3: BZ8050000
LD50/LC50:
CAS# 100-66-3: Draize test, rabbit, skin: 500 mg/24H Moderate;
Inhalation, mouse: LC50 = 3021 mg/m3/2H; Inhalation, mouse: LC50 =
3020 mg/m3/2H; Inhalation, rat: LC50 = >5000 mg/m3; Inhalation, rat:
LC50 = 8949 mg/m3/2H; Oral, mouse: LD50 = 2800 mg/kg; Oral, mouse:
LD50 = 2900 mg/kg; Oral, rat: LD50 = 3700 mg/kg; Oral, rat: LD50 =
5290 mg/kg.
Carcinogenicity:
Anisole -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Ecotoxicity:
Bacteria: Phytobacterium phosphoreum: EC50 = 18.8 mg/L; 30 Minutes;
Microtox testEstimate BCF value = 24. This value along with its
metabolism in aquatic organisms would indicate that Anisole has a low
potential for bioconcentration in fish and aquatic organisms.
Estimate Koc value = 35. This value suggests that Anisole is highly
mobile in soil and may readily leach. It was biodegradable in a
screening test and therefore may readily biodegrade in soil.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: ANISOLE
Hazard Class: 3
UN Number: 2222
Packing Group: III
IMO
Shipping Name: ANISOLE
Hazard Class: 3.3
UN Number: 2222
Packing Group: III
RID/ADR
Shipping Name: ANISOLE
Hazard Class: 3
UN Number: 2222
Packing group: III
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 10 Flammable.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 33 Take precautionary measures against static
discharges.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 100-66-3: 2
Canada
CAS# 100-66-3 is listed on Canada's DSL List.
CAS# 100-66-3 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 100-66-3 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 5/03/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|