diglycidyl ether of bisphenol a (dgba epoxy resins). aluminum (sara iii).osha pel 5 mg/m3 for respirable silica amorphous(siliconized silica).osha pel & acgih tlv triphenyl phosphite
LD50 LC50 Mixture:NOT KNOWN
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN CONTACT MAY CAUSE SENSITIZATION
IN CERTAIN INDIVIDUALS.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES:CAN CAUSE IRRITATION.SKIN:CAN CAUSE
IRRITATION.INGESTION:EFFECTS ARE UNKNOWN.INHALATION:UNLIKELY UNLESS
HEATED.
Medical Cond Aggravated by Exposure:PREEXISTING EYE AND SKIN DISORDERS
MAY BE AGGRAVATED BY EXPOSURE.
======================= First Aid Measures =======================
Eyes:FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15
MINUTES.SEEK MEDICAL ATTENTION. SKIN:REMOVE WITH SOAP AND WATER,IF
REDNESS OR RASH DEVELOPS SEEK MEDICAL ATTENTION.LAUNDER
CONTAMINATED CLOTHING BEFORE REUSE. INGESTION:SEEK MEDICAL
ATTENTION. INHALATION:REMOVE TO FRESH AIR,IF BREATHING IS LABORED
SEEK MEDICAL ATTENTION.
===================== Fire Fighting Measures =====================
Flash Point Method:PMCC
Flash Point:>392F,>200C
Lower Limits:NOT KNOWN
Upper Limits:NOT KNOWN
Extinguishing Media:USE WATER SPRAY,CARBON DIOXIDE,DRY CHEMICAL,OR
FOAM.
Fire Fighting Procedures:WEAR SELF-CONTAINED BREATHING APPARATUS
(SCBA).
Unusual Fire/Explosion Hazard:NONE
Spill Release Procedures:DIKE AND CONTAIN.ABSORB OR SCRAPE UP EXCESS.
Neutralizing Agent:NOT KNOWN
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN CLOSED CONTAINERS.USE ONLY
WITH ADEQUATE VENTILATION.
Other Precautions:AVOID PROLONGED OR REPEATED SKIN CONTACT.USE GOOD
GENERAL HOUSEKEEPING PROCEDURES.SANDING CURED EPOXY COMPOUNDS
GENERATES DUST.DO NOT INHALE DUST.
Respiratory Protection:IF HEATED USE SELF CONTAINED BREATHING
APPARATUS.RESPIRATORY PROTECTION IS REQUIRED WHEN SANDING CURED
EPOXY COMPOUNDS.
Ventilation:LOCAL EXHAUST:RECOMMENDED IN CONFINED SPACE.MECHANICAL
(GENERAL):USUALLY ADEQUATE.
Protective Gloves:NEOPRENE,RUBBER OR PLASTIC.
Eye Protection:SAFETY GOGGLES
Other Protective Equipment:CLEAN LONG LEG,LONG SLEEVE CLOTHING.
Work Hygienic Practices:WASH THOROUGHLY BEFORE EATING,SMOKING OR
APPLYING MAKE-UP.
Supplemental Safety and Health
NOT KNOWN
Boiling Pt:B.P. Text:NOT KNOWN
Melt/Freeze Pt:M.P/F.P Text:NOT KNOWN
Decomp Temp:Decomp Text:NOT KNOWN
Vapor Pres:NOT KNOWN
Vapor Density:NOT KNOWN
Spec Gravity:1.40 (WATER=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:METALLIC GRAY PASTE WITH MILD ODOR.
Percent Volatiles by Volume:NIL
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
AMINES UNDER UNCONTROLLED CONDITIONS. INCOMPATIBLE WITH STRONG
OXIDIZERS, AND STRONG LEWIS OR MINERAL ACIDS.
Stability Condition to Avoid:NOT KNOWN
Hazardous Decomposition Products:OXIDES OF NITROGEN AND CARBON,ACIDS
AND ALDEHYDES WHEN BURNED.
Conditions to Avoid Polymerization:WILL NOT OCCUR.
Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH
FEDERAL,STATE,AND LOCAL REGULATIONS.COORDINATE WITH SUPPORTING
INSTALLATION AND/OR MACOM ENVIRONMENTAL OFFICE PRIOR TO DISPOSAL .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.