===================== Product Identification =====================
MSDS NAME:ALPHA 620F FLUX, TYPE RMA
NIIN:00-069-5815
MSDS Number: BCXGM
=== Responsible Party ===
Company:ALPHA METALS
Address:600 ROUTE 440
City:JERSEY CITY
State:NJ
ZIP:07304
Country:US
Info Phone Num:201-434-6778
Emergency Phone Num:201-434-6778/800-424-9300(CHEMTREC)
CAGE:96613
=== Contractor Identification ===
Company:FRYS METALS INC (FORMER ALPHA METALS)
Address:600 ROUTE 440
Box:City:JERSEY CITY
State:NJ
ZIP:07304
Country:US
Phone:201-434-6778
CAGE:96613
============= Composition/Information on Ingredients =============
Name:ISOPROPYL ALCOHOL (SARA III)
CAS:67-63-0
RTECS #:NT8050000
Fraction by Wt: 25-50%
OSHA PEL:400 PPM; 500 STEL
ACGIH TLV:400 PPM; 500 STEL
Name:P-MENTHA-1,8-DIENE; (TERPENE SOLVENT)
CAS:138-86-3
RTECS #:OS8100000
Fraction by Wt: 10-25%
OSHA PEL:N/K
ACGIH TLV:N/K
Name:2,4-PENTANEDIOL, 2-METHYL; (HEXYLENE GLYCOL)
CAS:107-41-5
RTECS #:SA0810000
Fraction by Wt: 10-25%
OSHA PEL:25 PPM, C
ACGIH TLV:25 PPM, C
===================== Hazards Identification =====================
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAN CAUSE NASAL
IRRITATION, DIZZINESS, NAUSEA, HEADACHE. INGESTION: CAN CAUSE
GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING AND DIARRHEA. SKIN:
PROLONGED OR REPEATED CONTACT CAN CAUSE DEFA TTING AND DERMATITIS.
EYES: CAN CAUSE SEVERE IRRITATION, TEARING, BLURRED VISION.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:INHALATION: REMOVE INDIVIDUAL TO FRESH AIR. IF BREATHING IS
DIFFICULT, ADMINISTER OXYGEN. INGESTION: CALL MD OR POISON CONTROL
CENTER IMMEDIATELY. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS
PERSON . SKIN: WASH EXPOSED AREA WITH SOAP ANDWATER. REMOVE
CONTAMINATED CLOTHING. EYES: FLUSH EYES WITH LARGE AMOUNT OF WATER
LIFTING UPPER & LOWER LIDS OCCASIONALLY. GET MEDICAL ATTENTION.
===================== Fire Fighting Measures =====================
Flash Point Method:TCC
Flash Point:65.0F,18.3C
Lower Limits:1.2%
Upper Limits:12%
Extinguishing Media:CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT . COOL EXPOSED CONTAINERS WITH WATER.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR & MAY TRAVEL
ALONG GROUND. NEVER USE WELLDING TORCH ON OR NEAR METAL CONTAINERS
(EVEN EMPTY).
================== Accidental Release Measures ==================
Spill Release Procedures:VENT IF IN ENCLSD AREA. SM SPILL: ABSORB LIQ
ON PAPER, VERMICULITE, FLOOR ABSORB/OTHER ABSORB MATL & TRANSFER TO
HOOD. LG SPILL: ELIM ALL IGNIT SOURCES. PERSONS NOT WEARING PROT
EQUIP SHOULD BE EXCLUD ED FROM AREA. DIKE AREA OF SPILL TO PVNT
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:OBSERVE PREC FOR FLAMM LIQ. KEEP CNTNR
CLSD WHEN NOT IN USE. STORE AWAY FROM IGNIT SOURCES IN COOL, DRY
AREA. USE ADEQ VENT. READ ALL CNTNR (SUPDAT)
Other Precautions:SINCE EMPTY CONTAINERS MAY RETAIN PRODUCT RESIDUES
(VAPOR, LIQUID/SOLID) ALL LABELED HAZARD PRECAUTIONS MUST BE
OBSERVED. FOR INDUSTRIAL USE ONLY. KEEP OUT OF REACH OF CHILDREN.
DO NOT TAKE INTERNALLY .
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF THRESHOLD LIMIT VALUE IS EXCEEDED, USE
NIOSH/MSHA APPROVED RESPIRATOR FOR ORGANIC VAPORS.
Ventilation:USE ADEQUATE VENTILLATION TO MAINTAIN BELOW TLV.
Protective Gloves:RESISTANT, I.E. RUB, NEOPRENE/PLASTIC.
Eye Protection:CHEMICAL GOGGLES
Other Protective Equipment:EYE BATH
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC: SPREADING. PUMP LIQ TO SALVAGE TANK. TAKE UP REMAINING LIQ
ON ABSORB MATL. SHOVEL INTO CNTNRS. HNDLG/STOR PREC: LABELING.
AVOID USE OF BRASS DRUM SPIGOTS. USE POLYETHYLENE, POLYPROPYLENE,
TEFLON OR STAINLESS STEEL.
================== Physical/Chemical Properties ==================
HCC:F2
Boiling Pt:B.P. Text:185F;85C
Vapor Pres:30
Vapor Density:2.5
Spec Gravity:0.907
Evaporation Rate & Reference:2.7 (BUAC=1)
Solubility in Water:SLIGHT
Appearance and Odor:CLEAR, AMBER LIQUID WITH MILD NON-RESIDUAL ODOR.
Percent Volatiles by Volume:63(WT)
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:HEAT, SPARKS AND OPEN FLAMES.
Hazardous Decomposition Products:CARBON DIOXIDE AND CARBON MONOXIDE.
==================== Disposal Considerations ====================
Waste Disposal Methods:INCINERATE ABSORBED MATERIAL IAW FEDERAL, STATE
AND LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|