LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES:CAUSES EYE BURNS. SKIN:MAY CAUSE
MODERATE IRRITATION INGESTION:MAY CAUSE NAUSEA, VOMITING.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:INHALATION:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE
O*2/ARTF RESP) . EYES:FLUSH WITH LARGE AMOUNT OF WATER FOR AT LEAST
15 MINUTES. SKIN:FLUSH WITH LARGE AMOUNT OF WATER. VINEGAR MAY BE
USED TO EASE SKIN IRRITATION. INGESTION:INDUCE VOMITING.
===================== Fire Fighting Measures =====================
Flash Point:145F,63C
Extinguishing Media:WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:MAY FORM TOXIC MATERIALS. CARBON DIOXIDE,
HYDROGEN HALIDE, CARBON MONOXIDE.
Respiratory Protection:IF TLV OF THE PRODUCT IS EXCEEDED, AN NIOSH/MSHA
APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE OF PROPER
ENVIRONMENTAL CONTROL.
Ventilation:RECOMMENDED.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:EMERGENCY EYE WASH & DELUGE SHOWER WHICH
MEET ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EYE PROT:AND FULL LENGTH FACE SHIELD .
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.53
Evaporation Rate & Reference:FASTER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:98.5
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
ACIDS, STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM HEAT, SPARKS AND OPEN
FLAMES, DIRECT SUNLIGHT.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.
Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS . ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.