sulfonated divinylbenzene/styrene copolymer, na ion form water bp:100c/212f vp:17 @ 68f evap rate:<1 (bac *1) % supdat:state & local emergency planning committies under ing 3: iii section 304. other prec:explosion. consult a source knowledgeable in the ing 5:pack column w/dry ion exchange resins. dry beads ing 6: to shatter. vent:ventilation:manual of recomended practice published by ing 8:hygienists for information on the design,
LD50 LC50 Mixture:LD50 (ORAL RAT): >5000 MG/KG
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: TOXICITY DATA FOR A
COMPOSITIONALLY SIMILAR MATERIAL ARE LISTED BELOW. EYE CONTACT:
MATERIAL CAN CAUSE THE FOLLOWING: - IRRITATION. CHRONIC: NONE
SPECIFIED BY MANUFACTURER.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR.
SUPPORT BREATHING (GIVE O*2/ARTIFICIAL RESPIRATION) . SKIN:FLUSH
W/COPIOUS AMOUNTS OF WATER. CALL MD . EYE CONTACT:FLUSH EYES WITH
A LARGE AMOUNT OF WATER FOR AT LEAST 15 MINUTES. CALL PHYSICIAN IF
IRRITATION PERSISTS.
===================== Fire Fighting Measures =====================
Extinguishing Media:USE THE FOLLOWING EXTINGUISHING MEDIA WHEN FIGHTING
FIRES INVOLVING THIS - CARBON DIOXIDE - DRY CHEMICAL - WATER SPRAY.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:COMBUSTION GENERATES TOXIC FUMES OF THE
FOLLOWING: - SULFUR OXIDES.
Spill Release Procedures:FLOOR MAY BE SLIPPERY; USE CARE TO AVOID
FALLING. TRANSFER SPILLED MATL TO SUITABLE CNTNRS FOR
RECOVERY/DISP. RELEASE OF THIS MATL TO AIR, LAND,/H*2O ARE NOT
REPORTABLE TO NATIONAL RESPONSE CENTER UND ER THE COMPREHENSIVE
ENVIRONMENTAL (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:THE MIN REC STOR TEMP FOR THIS MATL IS
OC/32F. THE MAX REC STOR TEMP FOR THIS MATL IS 60C/140F. AVOID RPTD
FREEZE-THAW CYCLES; BEADS MAY FRACTURE.
Other Precautions:THE MAX REC OPERATING TEMP FOR THIS MATL IS
150C/300F. PROPERLY DESIGNED EQUIP IS VITAL IF THESE ION EXCHANGE
RESINS ARE TO BE USED IN CONJUNCT W/STRONG OXIDIZING AGENTS SUCH AS
NITRIC ACID TO PVNT RA PID BUILD-UP OF PRESS & POSS (ING 5)
Respiratory Protection:A RESPIRATORY PROTECTION PROGRAM MEETING OSHA
1910.134 AND ANSI Z88.2 REQUIREMENTS MUST BE FOLLOWED WHENEVER
WORKPLACE CONDITIONS WARRANT A RESPIRATOR'S USE. NONE REQURIED
UNDER NORMAL OPERATING CONDI TIONS.
Ventilation:VENT SYS EMPLOYED IS DEPENDENT ON USER'S SPECIFIC APPLICATN
OF THIS MATL. REFER TO CURRENT EDITION OF INDUSTRIAL(ING 8)
Protective Gloves:COTTON OR CANVAS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
PH:7-9 AQUEOUS SLURRY. WASTE DISP METH:DEFINITION OF IGNITABILITY,
CORROSIVITY/REACTIVITY, & IS NOT LISTED IN 40 CFR 261.33. THE
TOXICITY CHARACTERISTIC (TC), HOWEVER, HAS NOT BEEN EVALUATED BY
THE TO XICITY CHARACTERISTIC LEACHING PROCEDURE (TCLP). SPILL
PROC:RESPONSE, COMPENSATION, & LIABILITY ACT (CERCLA)/TO(ING 3)
Boiling Pt:B.P. Text:SEE ING 2
Melt/Freeze Pt:M.P/F.P Text:SEE ING 2
Vapor Pres:SEE ING 2
Vapor Density:SEE ING 2
Spec Gravity:1.1-1.4
pH:SUPDAT
Evaporation Rate & Reference:SEE ING 2
Solubility in Water:PARCTICALLY INSOL
Appearance and Odor:BEADS
Percent Volatiles by Volume:ING 2
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS, PARTICULARY CONCENTRATED
NITRIC ACID.
Stability Condition to Avoid:SEE STORAGE & HANDLING INFORMATION SECTION
FOR SPECIFIED CONDITIONS. AVOID TEMPERATURES ABOVE 200C/392F.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD THE
FOLLOWING: - MONOMER VAPORS - SULFUR OXIDES.
Waste Disposal Methods:UNUSED RESIN MAY BE INCIND/LANDFILLED IN
FACILITIES MEETING LOCAL, STATE, & FED REGS. FOR CONTAMD RESIN,
USER MUST DETERM HAZ & USE APPROP DISP METH. WHEN DECISION IS MADE
TO DISCARD THIS MATL AS SUPP LIED, IT DOES NOT MEET RCRA'S
CHARACT(SUPDAT)
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.