=====================  Product Identification  =====================

MSDS NAME:ZE-3 ZYGLO EMULSIFIER
NIIN:01-264-0836
Kit Part:Y
MSDS Number: BGRTK
=== Responsible Party ===
Company:MAGNAFLUX CORPORATION
Address:7300 W LAWRENCE AVE
City:CHICAGO
State:IL
ZIP:60656-3504
Country:US
Info Phone Num:708-867-8000
Emergency Phone Num:708-867-8000
Preparer's Name:BRUCE C. GRAHAM
CAGE:37676
=== Contractor Identification ===
Company:ILLINOIS TOOL WORKS INC MAGNAFLUX DIV
Address:3624 WEST LAKE AVENUE
Box:City:GLENVIEW
State:IL
ZIP:60025
Country:US
Phone:847-657-5300/
CAGE:37676

=============  Composition/Information on Ingredients  =============

Name:MINERAL OIL (EXPOSURE REGULATED AS 'OIL MIST')
CAS:8012-95-1
RTECS #:PY8030000
Fraction by Wt: 50.0%
OSHA PEL:5 MG/M3
ACGIH TLV:5 MG/M3/10 STEL;9192

Name:"NOT HAZARDOUS" INGREDIENTS
Fraction by Wt: 50%
Other REC Limits:NONE ESTABLISHED

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:NO	Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:MAY IRRITATE EYES.SEE
    OVEREXPOSURE SYMPTOMS.
Effects of Overexposure:INHALATION:NOT LISTED BY
    MANUFACTURER.HOWEVER,FINE SPRAY/MIST MAY CAUSE IRRITATION TO
    BREATHING PASSAGES; EYES:LIQUID/MIST CAUSES IRRITATION;
    SKIN:PROLONGED OR REPEATED CONTACT CAUSES IRRITATION BY DI SSOLVING
    SKIN OILS; INGESTION:NOT NOTEDBY MANUFACTURER.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY THE MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INHALATION:REMOVE TO FRESH AIR; SKIN:REMOVE CONTAMINATED
    CLOTHES.WASH OFF PROMPTLY WITH SOAP AND WATER.USE SOOTHING
    LOTION.GET MEDICAL HELP IF IRRITATION PERSISTS; EYES:IMMEDIATELY
    RINSE EYES WITH COP IOUS AMOUNT OF WATER.GET MEDICAL ASSISTANCE IF
    IRRITATION PERSISTS; INGESTION:NOT STATED BY MANUFACTURER.GET
    MEDICAL ATTENTION IF INGESTED.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:325F/163C
Extinguishing Media:CARBON DIOXIDE,FOAM
Fire Fighting Procedures:KEEP CONTAINERS COOL WITH WATER SPRAY.
Unusual Fire/Explosion Hazard:WHEN INVOLVE IN COMBUSTION,MAY EMIT TOXIC
    GASES AT OR ABOVE DECOMPOSITION TEMPERATURE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE IGNITION SOURCES.SM QTY:WIPE UP OR MOP
    UP BUT DO NOT BREATHE VAPORS.PLACE RAGS IN CLOSED DRUMS; LG
    QTY:WEAR PERSONAL SAFETY EQUIPMENTS.DIKE AREA FAR AHEAD.ABSORB
    LIQUID WITH COMMERCIAL ABSORBEN T.TRANSFER WASTE MATL IN SALVAGE
    TANKS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE AWAY FROM HEAT SOURCES IN WELL
    VENTILATED AREA.AVOID AGAINST PHYSICAL DAMAGE TO CONTAINERS.KEEP
    CONTAINERS TIGHTLY CLOSED.
Other Precautions:DO NOT BREATHE VAPORS.DO NOT SMOKE WHILE USING.DO NOT
    HEAT ABOVE 130F(54C).AVOID FREQUENT OR PROLONGED SKIN CONTACT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH APPROVED RESPIRATORS FOR CONFINED
    AREAS.
Ventilation:GENERAL ROOM VENTILATION TO KEEP BELOW TLV LIMITS.
Protective Gloves:USE NITRILE RUBBER GLOVES IF NEEDED.
Eye Protection:FULL GOGGLES/SAFETY GLASSES W/SIDESHIELD
Other Protective Equipment:NOT KNOWN
Work Hygienic Practices:WASH OFF PROMPTLY WITH WATER.AVOID SKIN
    CONTACT.
Supplemental Safety and Health
NSN IS FOR A 2 PARTS SET OF MIL-I-25135D I/A/W QPL-25135-15,THE SET
    UNDER TYPE I,METHOD B,LEVEL 2 MAY CONSIST OF ZL-2C OR ZL-2D
    PENETRANT AND ZE-3 OR ZE-4B EMULSIFIER.THIS ENTRY DESCRIBES
    ZE-3;THE QPL  ALSO INDICATES THAT THIS PRODUCT CAN GO IN SEVERAL
    OTHER KITS OF TYPE I,METHOD A,B,C,D & LEVEL 1,2,3,4;KEY1:N1

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:>450F/>232C
Vapor Pres:0.3 @100F
Vapor Density:>1.0
Spec Gravity:0.75
pH:8.0
Solubility in Water:NEGLIGIBLE
Appearance and Odor:VISCOUS PINK LIQUID

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE STATED BY MANUFACTURER.
Stability Condition to Avoid:HEAT,HIGH TEMPERATURES.
Hazardous Decomposition Products:EMITS OXIDES OF CARBON IF BURNING.

====================  Disposal Considerations  ====================

Waste Disposal Methods:INCINERATE OR DISPOSE OF AS EPA HAZARDOUS WASTE
    D001 (IGNITABLE WASTE),IN ACCORDANCE WITH ALL APPLICABLE
    FEDERAL,STATE,LOCAL REGULATIONS;IF LOCAL AUTHORITIES PROHIBIT
    DUMPING RINSINGS DOWN THE SEWER,P URIFY RINSINGS WITH MAGNAFLUX
    WASTEWATER TREATMENT

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***