Updated February 20, 2007
I soeicosane
Material Safety Data Sheet ( MSDS)
1. Product Identification Eye Contact: No significant health hazards identified.
Product Name: Isoeicosane Skin Contact: No significant health hazards identified.
INCI Name: Permethyl 102A Ingestion: Ingestion may cause gastrointestinal irritation and diar-
rhea.
Chemistry: Hydrocarbons, C4, 1,3-butadiene-free, polymd, pentaiso-
butylene fraction, hydrogenated Primary Route of Entry: none specified
CAS Number: 93685-79-1
EINECS Number: 297-627-7 8. First Aid Measures
Eyes: Immediately flush eyes with a copious amount of water for at
least 15 minutes. Seek medical attention if irritation occurs.
2. Physical & Chemical Properties
Melting Point: -49C Skin: Immediately flush skin with plenty of water.
Boiling Point: 275 to 335 C Inhalation: Remove to fresh air. Get medical attention if symptoms
appear.
Non-Volatiles: not determined
Viscosity: Dynamic: 0 Pa-S (20.2 cP) Ingestion: Do not induce vomiting unless directed to do so by medi-
cal personnel. Never give anything by mouth to an unconscious
Specific Gravity: 830 kg/m3 (0.8 g/cm3) at 20 C
person. If large quantities of this material are swallowed, seek medi-
Solubility in water: negligible <0.1 g/l at 20 C
cal attention immediately.
Refractive Index: not determined
Appearance & Odor: liquid, clear, colorless, odorless
9. Fire Fighting Measures
3. Stability & Reactivity Flash Point: 130 C (closed cup)
Conditions to Avoid: Keep away from heat, sparks and flame Extinguishing Media: In case of fire, use water, fog, foam, dry
chemical or Co2 extinguisher or spray.
Incompatibility: Reactive with oxidizing agents
Thermal Decomposition: not measured Fire Fighting Procedures: This material is combustible/flammable
and is sensitive to fire, heat and static discharge. This material is not
Hazardous Polymerisation: will not occur
explosive as defined by established regulatory criteria. Fire fighters
should wear self-contained positive pressure breathing apparatus
4. Handling & Storage
(SCBA) and full turnout gear. Fire fighters protective clothing will
Handling: Keep away from heat, sparks and flame. Keep container
closed. Use only with adequate ventilation. To avoid fire or explosion, provide limited protection.
dissipate static electricity during transfer by earthling and bonding con-
tainers and equipment before transferring material. Use explosion proof 10. Toxicological Information
electrical (ventilating, lighting, and material handling) equipment. Wash General: No component of this product at levels greater than or
thoroughly after handling. equal to 0.1% is identified as carcinogenic, mutagenic, reproductive
toxin or teratogenic or embryotoxic.
Storage: Keep container in a cool, well ventilated area. Avoid all pos-
sible sources of ignition (spark or flame). Acute oral LD50: >5000 mg/kg, oral, rat
11. Disposal Consideration
Avoid contact of spilled material and runoff with soil and surface
5. Accidental Release Measures
Immediately contact emergency personnel. Keep unnecessary person- waterways. Consult an environmental professional to determine if
nel away. Use suitable protective equipment. If emergency personnel state or federal regulations would classify spilled or contaminated
are unavailable, contain spilled material. For small spills add absorbent materials as hazardous waste. Use only approved transporters,
(soil may be used in the absence of other suitable materials) and use a recyclers, treatment, storage or disposal facilities. Comply with all
non-sparking or explosion proof means to transfer material to a sealed, local, regional and national laws pertaining to waste management.
appropriate container for disposal. For large spills dike spilled material
or otherwise contain material to ensure runoff does not reach a water- 12. Transport Information
way. Minimize contact of spilled material with soils to prevent runoff to DOT Shipping Name: Not classified as hazardous.
surface waterways. Wear suitable protective clothing and gloves. Sug- ADR/RIC Code: Not classified as hazardous.
gested protective clothing might not be sufficient; consult a specialist Sea Transport IMDG Code: Not classified as hazardous.
before handling this product. Air Transport IATA: Not classified as hazardous.
6. Exposure Controls & Personal Protection 13. Regulatory Information
Respiratory Protection: None required, use of adequate ventilation is Risk phrases: This product is not classified according to the EU
good industrial practice. regulations.
Protective Clothing: Avoid prolonged or repeated contact with the EU Regulations: Classification and labeling have been performed
skin. Wear suitable protective clothing. Wear gloves that cannot be according to EU directives 1999/45/EC and 67/548/EEC as
penetrated by chemicals or oil. Nitrile gloves (0.35 mm). Breakthrough amended and adapted.
time: 8 hours. Other regulations: Australian, Canada, China, EC, Japan, Korea,
Philippine and U.S. inventories: Listed on inventory.
Other Protective Measures: Local exhaust ventilation should be pro-
vided. Ensure that eyewash stations and safety showers are close to
the workstation site. Wash hands, forearms, and face thoroughly after 13. Disclaimer
handling compounds and before eating, smoking, using the lavatory or This information relates only to the specific material designated and
at the end of the day. may not be valid for such material used in combination with any
other materials or in any other process. Such information is to be the
best of the company s knowledge and believed accurate and reliable
7. Hazards Identification
General: No significant health hazards identified.
Inhalation: No significant health hazards identified.
|