**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 106-32-1 |Ethyl caprylate | 99 | 203-385-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes moderate skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Water may be ineffective.
Material is lighter than water and a fire may be spread by the use of
water. Combustible liquid. Vapors may be heavier than air. They can
spread along the ground and collect in low or confined areas.
Containers may explode when heated.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. This material is lighter than water and insoluble in
water. The fire could easily be spread by the use of water in an
area where the water cannot be contained. Use agent most appropriate
to extinguish fire.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Sweep up
or absorb material, then place into a suitable clean, dry, closed
container for disposal. Remove all sources of ignition. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Avoid contact with eyes, skin, and clothing. Empty
containers retain product residue, (liquid and/or vapor), and can be
dangerous. Keep container tightly closed. Keep away from heat,
sparks and flame. Avoid ingestion and inhalation. Use with adequate
ventilation. Do not pressurize, cut, weld, braze, solder, drill,
grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a cool, dry place. Keep container closed when not
in use. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 106-32-1:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: Clear, Colorless Liquid
Odor: Pineapple-Like Odor
pH: Not available.
Vapor Pressure: 0.2 mmHg @ 25 C
Viscosity: Not available.
Boiling Point: 206.0 - 208.0 deg C @ 760.00m
Freezing/Melting Point: -47 deg C
Autoignition Temperature: Not available.
Flash Point: 75 deg C ( 167.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: .8780g/cm3
Molecular Formula: C10H20O2
Molecular Weight: 172.27
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Acids, bases, strong oxidizing agents, strong reducing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 106-32-1: RH0680000
LD50/LC50:
CAS# 106-32-1: Draize test, rabbit, skin: 500 mg/24H Moderate; Oral,
rat: LD50 = 25960 mg/kg.
Carcinogenicity:
Ethyl caprylate -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 106-32-1: 1
Canada
CAS# 106-32-1 is listed on Canada's DSL List.
CAS# 106-32-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 106-32-1 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 11/10/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Trolox, 97%
| 53188-07-1 |
|
Poly(2,2-Dimethyl-1,3-Propylene Succinate) Approximate M.W. 16.000
| 28776-65-0 |
|
1-Benzyl-2-methylimidazole, 95%(gc)
| 13750-62-4 |
|
2-Phenyl-2-imidazoline, 98+%
| 936-49-2 |
|
Pyridazine, 98+%
| 289-80-5 |
|
Butyraldehyde, P.A. Contains Less Than 1% Butyric Acid
| 123-72-8 |
|
2,3-Dimethoxyphenol, 99%
| 5150-42-5 |
|
4-Octylbenzaldehyde, 99% (GC)
| 49763-66-8 |
|
4-Aminophenethyl alcohol, 97% (gc)
| 104-10-9 |
|
2,6-Dinitrotoluene, 99%
| 606-20-2 |
|
Methanethiol, 99.5+%
| 74-93-1 |
|
Benzanilide 98%
| 93-98-1 |
|
2-Amino-6,8-Dihydroxypurine, Tech., ca.85% (HPLC)
| 5614-64-2 |
|
2-Dimethylaminoethyl Methacrylate, 99% (GC), Stabilized
| 150-76-5 |
|
Butyric Acid, Sodium Salt, 99%
| 156-54-7 |
|
N,n',n",n"'-tetraacetylglycoluril, 98+%
| 10543-60-9 |
|
2-Ethylhexyl Acetate, 99% (GC)
| 103-09-3 |
|
Alpha, Alpha, Alpha-Trifluoro-O-Toluic Acid, 98%
| 433-97-6 |
|
Deuterium Oxide, 99.8 Atom % D
| 7789-20-0 |
|
Phenothiazine-10-carbonyl chloride 98%
| 18956-87-1 |
|
4-Chloro-2-Nitrotoluene, 99%
| 89-59-8 |
|
1,12-Dodecanedicarboxylic Acid, 98%
| 821-38-5 |
|
Lead(II) carbonate, basic, -325 mesh
| 1319-46-6 |
|
4'-Chloro-2'-Fluoroacetanilide , 99+%(TLC)
| 59280-70-5 |
|
2-Benzoylbenzoic acid, 98+%
| 85-52-9 |
|
d-(+)-Galactosamine Hydrochloride, 99%
| 1772-03-8 |
|
2-Benzylpyridine, 98%
| 101-82-6 |
|
Trypan Blue
| 72-57-1 |
|
Ethyl caprylate, 99+%
| 106-32-1 |
|
4-(Hydroxymercury)benzoic acid sodium salt
| 138-85-2 |
|
(2S,3S),(2S,3R)-2-Amino-3-Hydroxy-4-Methyl Pentanoic Acid, 99+% e.e.
| 0-01-1 |
|
Ethylenediamine-N,N'-diacetic acid, 98+%
| 5657-17-0 |
|
2-Acetoxy-3,3-dichlorotetrahydrofuran 98+%
| |
|
2-Nitroaniline, 98%
| 88-74-4 |
|
DL-Homatropine Hydrobromide, 98.5-100.5% (on Dry Subst.)
| 51-56-9 |
|
4-Methyl-3-nitroanisole, 99%
| 17484-36-5 |
|
Chromotrope 2b
| 548-80-1 |
|
3-Hydroxytyramine hydrobromide, 99%
| 51-61-6 |
|
1,4-Bis(2-Hydroxyethoxy)-2-Butyne
| 1606-85-5 |
|
Oxonic acid, potassium salt, 97.5%
| 2207-75-2 |
|
(-)-Chiracamphox
| 165038-32-4 |
|
Iminodiacetonitrile, 98%
| 628-87-5 |
|
Heptanoyl chloride, 99%(titr.)
| 2528-61-2 |
|
Azocarmine G (Cert)
| 25641-18-3 |
|
New Coccine
| 2611-82-7 |
|
(2-Fluorophenyl)(4-methoxy-3-nitrophenyl) methanone, 95%
| |
|
1-Chloropropane, 99%
| 540-54-5 |
|
2-Methylglutaric acid, 99%
| 18069-17-5 |
|
3,4,5-Trimethoxyaniline, 97%
| 24313-88-0 |
|
5-Chloro-2-(trichloromethyl)benzimidazole , 95%
| 3584-66-5 |
|
|