Name:VOC: 4.19 LB/GAL LESS WATER & NEGLIGIBLY PHOTOCHEMICALLY
REACTIVE MATERIAL. 503 G/L LESS WATER (CALCULATED)
RTECS #:9999999VO
Other REC Limits:NONE SPECIFIED
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES
Health Hazards Acute and Chronic:ACUTE: INGEST: GASTROINTESTINAL IRRIT,
NAUSEA, VOMIT. ASPIRATION OF MATR'L INTO LUNG MAY CAUSE CHEMICAL
PNEUMONITIS. INHAL: NOSE/THROAT IRRIT, CENTRAL NERVOUS SYSTEM
DEPRESSION. EYE: SEVERE IRRIT. SKI N: SENSITIZATION (ALLERGIC
REACTION), DEFATTING AND IRRIT. CHRONIC: SILICOSIS, INJURY TO
LIVER, KIDNEYS & BLOOD,*
Explanation of Carcinogenicity:CHROMIUM & CERTAIN CHROMIUM
COMPOUNDS--POTENTIAL CARCINOGENS (NTP). IARC LISTS CRYSTALLINE
SILICA (LIMITED CARCINOGEN).
Effects of Overexposure:HEADACHES, DIZZINESSS, NAUSEA AND CONFUSION.
METAL OXIDES MAY RESULT IN "METAL FUME FEVER" SYMPTOMS--A FLU-LIKE
ILLNESS W/FEVER, CHILLS, & COUGH.
*DERMATITIS, PER MANENT BRAIN AND NERVOUS SYSTEM
DAMAGE.DELIBERATE MISUSE BY CONCENTRATION AND INHALING PRODUCT MAY
BE HARMFUL OR FATAL.
Medical Cond Aggravated by Exposure:PREEXISTING RESPIRATORY CONDITIONS
MAY BE AGGRAVATED.
======================= First Aid Measures =======================
First Aid:INGESTION: DON'T INDUCT VOMITTING. CALL POISON CONTROL
CTR/HOSPITAL EMERGENCY ROOM/DOCTOR IMMED. INHALATION: REMOVER TO
FRESH AIR IMMED. NOT BREATHING--START ARTIFICIAL RESPIRATION. KEEP
WARM & QUIET. GET MED AID IMMED. EYE: FLUSH W/LRG AMTS--WATER (15
MIN), OCCASIONALLY LIFTING LIDS APART. GET MED AID. SKIN: REMOVE
CONTAMINATED CLOTHING. WASH W/SOAP & WATER. IF IRRITATION
PERSISTS--GET MED AID.
===================== Fire Fighting Measures =====================
Flash Point:572F,300C
Autoignition Temp:Autoignition Temp Text:300 C
Lower Limits:1.0
Upper Limits:8.0
Extinguishing Media:USE NFPA CLASS B(CO2, ALL PURPOSE DRY CHEMICAL OR
ALCOHOL FOAM) FOR LIQUID FIRES. POLYMER FOAM PREFERRED FOR LARGE
FIRES
Fire Fighting Procedures:DURING EMERGENCY CONDITIONS, OVEREXPOSURE TO
DECOMPOSITION PRODUCTS MAY CAUSE A HEALTH HAZARD. SYMPTOMS MAY NOT
BE IMMEDIATELY APPARENT. GET MEDICAL ATTENTION.
Unusual Fire/Explosion Hazard:WATER MAY BE INEFFECTIVE, USE TO COOL
CONTAINERS (FOG NOZZLE PREFERABLE) TO PREVENT PRESSURE BUILD-UP &
AUTO-IGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT.
Spill Release Procedures:NO SPECTATORS. REMOVE IGNITION SOURCES. DIKE &
CONTAIN SPILL WITH INERT MATERIAL (SAND/EARTH/ETC). TRANSFER
LIQUIDS TO COVERED METAL CONTAINERS. PREVENT CONTAMINATION OF
SEWERS, STREAMS & GROUNDWATER W/SPILLED MATERIAL OR USED
ABSORBENT.
====================== Handling and Storage ======================
Handling and Storage Precautions:DO NOT STORE ABOVE 90 F.
Other Precautions:DO NOT INGEST. CLOSE CONTAINERS AFTER USE. KEEP AWAY
FROM CHILDREN. DO NOT BREATHE SANDING DUST. AVOID SKIN CONTACT.
DON'T WASH OR REUSE EMPTY CNTNRS. CONTAINERS SHOULD BE GROUNDED &
BONDED TO RECEIVI NG CNTNR. DO NOT WELD, BRAZE OR CUT.*
Respiratory Protection:RESTRICTED VENT--NIOSH APPROVED CHEMICAL
CARTRIDGE RESPIRATOR. IF SPRAYING, A MECHANICAL PREFILTER MAY BE
REQUIRED. IF TLV ARE EXCEEDED USE A NIOSH/MSHA APPROVED RESPIRATOR
WITH AN APPROPRIATE PROTECT ION FACTOR. SEE OSHA 29 CFR 1910.134.
Ventilation:GEN DILUTION/LOCAL EXHAUST--SUFF TO KEEP CONC--HAZARD
INGRED BELOW LEL. VENT SMOKE FROM WELD/CUT/BRAZING COATED MATR'L.
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:SAFETY SPECTACLES
Other Protective Equipment:EYEWASH FACILITY, SAFETY SHOWERS
Supplemental Safety and Health
*ON EMPTY CONTAINERS. NEVER USE PRESSURE TO EMPTY. DRUM IS NOT A
PRESSURE VESSEL.
HCC:F2
Boiling Pt:B.P. Text:139 TO 240F
Melt/Freeze Pt:M.P/F.P Text:-50F,-46C
Decomp Temp:Decomp Text:1832F,1000C
Vapor Pres:22MMHG@68F
Vapor Density:> AIR
Spec Gravity:1.3
pH:4 TO 7
Viscosity:>200 CST
Evaporation Rate & Reference:SLOWER THAN DIETHYL EHTER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID; SOLVENT ODOR
Percent Volatiles by Volume:59
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS. OXIDIZING MATERIALS. ACCELERATORS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT (>100 F) AND SOURCES
OF IGNITION.
Hazardous Decomposition Products:BURNING, WELDING, CUTTING--PROD &
COATED MATERIALS WILL PRODUCE SMOKE, CO2, CO, OXIDES OF CHROMIUM, &
METAL OXIDES.
Conditions to Avoid Polymerization:HAZARDOUS POLYMERIZATION MAY OCCUR
WITH THE ADDITION OF EXCESS HARDENER.
Waste Disposal Methods:DISPOSE IN ACCORD W/FEDERAL, STATE & LOCAL LAWS.
INCINERATE IN EPA PERMITTED FACILITY. DON'T INCINERATED CLOSED
CNTNRS. FOLLOW PRECAUTIONS FOR DISPOSAL OF FLAMMABLE MATERIALS.
DISPOSE OF CONTAMINATED ABSORBENT IN HAZARDOUS WASTE LANDFILL.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.