LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SLIGHT SKIN IRRITATION.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:EYE: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. SKIN: WASH
CONTACT AREAS WITH SOAP AND WATER. INHAL: REMOVE TO FRESH AIR.
SUPPORT BRTHG (GIVE O*2/ARTF RESP) . INGEST: IF UNCOMFORTABLE SEEK
MEDICA L ASSISTANCE.
===================== Fire Fighting Measures =====================
Flash Point Method:COC
Flash Point:>395F,>202C
Lower Limits:0.6%
Upper Limits:7%
Extinguishing Media:CARBON DIOXIDE, FOAM, DRY CHEMICAL AND WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE.
Spill Release Procedures:ABSORB ON FIRE RETARDANT TREATED SAWDUST,
DIATOMACEOUS EARTH, ETC. SCRAPE UP AND REMOVE. DISPOSE OF @ AN
APPROPRIATE WASTE DISPOSAL FACILITY I/A/W CURRENT APPLICABLE LAWS &
REGULATIONS, AND PRODUCT CH ARACTERISTIC AT TIME OF DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:NONE SPECIFIED BY MANUFACTURER.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Respiratory Protection:NO SPECIAL REQUIREMENTS UNDER ORDINARY
CONDITIONS OF USE AND WITH ADEQUATE VENTILATION. USE NIOSH/MSHA
APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:NO SPECIAL REQUIREMENTS UNDER ORDINARY CONDITIONS OF USE
AND WITH ADEQUATE VENTILATION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:GOOD PERSONAL HYGIENE PRACTICE SHOULD ALWAYS BE
FOLLOWED.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Waste Disposal Methods:DISSOLVE WASTE IN A SOLVENT AND DISPOSE BY
SUPERVISED INCINERATION IN COMPLIANCE WITH APPLICABLE FEDERAL,
STATE AND LOCAL LAWS AND REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.