| MSDS | : | 0567 EPOXY SPRAY GLOSS WHITE | | CAS | : | 64742-89-8
1330-20-7
68131-77-1
74-98-6
75-28-5
67-64-1
71-55-6 | | NAME | : | light aliphatic naphtha, vm & p naphtha, lacolene *93/3*
xylene, dimethylbenzene, xylol
hydrocarbon resin
propane
isobutane, 2-methylpropane
acetone; dimethyl ketone
methyl chloroform (1,1,1-trichloroethane) (chlorothene nu),
|
| |
|
|
===================== Product Identification =====================
MSDS NAME:0567 EPOXY SPRAY GLOSS WHITE
NIIN:00F031258
MSDS Number: BSMYM
=== Responsible Party ===
Company:MAJOR PAINT COMPANY
Address:4300 W 190TH ST
Box:2868
City:TORRANCE
State:CA
ZIP:90509-2868
Country:US
Info Phone Num:213-542-7701
Emergency Phone Num:213-542-7701
CAGE:MAJOR
=== Contractor Identification ===
Company:MAJOR PAINT CO
Address:4300 W 190TH ST
Box:City:TORRANCE
State:CA
ZIP:90509-2868
Country:US
Phone:310-542-7701
CAGE:0V1C9
Company:MAJOR PAINT COMPANY
Address:4300 WEST 190TH STREET
Box:2868
City:TORRANCE
State:CA
ZIP:90509-2868
Country:US
Phone:310-542-7701
CAGE:MAJOR
============= Composition/Information on Ingredients =============
Name:LIGHT ALIPHATIC NAPHTHA, VM & P NAPHTHA, LACOLENE *93/3*
CAS:64742-89-8
OSHA PEL:300 PPM
ACGIH TLV:300 PPM
Name:XYLENE, DIMETHYLBENZENE, XYLOL
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 4%
Other REC Limits:100 PPM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM, SKIN
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:HYDROCARBON RESIN
*93-3*
CAS:68131-77-1
OSHA PEL:15 MG/CUM
ACGIH TLV:10 MG/CUM
Name:PROPANE
CAS:74-98-6
RTECS #:TX2275000
Other REC Limits:1800 MG/CUM
OSHA PEL:1000 PPM
ACGIH TLV:SIMPLE ASPHYXIANT
Name:ISOBUTANE, 2-METHYLPROPANE
CAS:75-28-5
RTECS #:TZ4300000
Other REC Limits:1000 PPM
OSHA PEL:1800 MG/CUM
ACGIH TLV:800 PPM
Name:ACETONE; DIMETHYL KETONE
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 9%
OSHA PEL:2400 MG/CUM
ACGIH TLV:750 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS
Name:METHYL CHLOROFORM (1,1,1-TRICHLOROETHANE) (CHLOROTHENE NU),
AEROTHANE TT, CHLOROTHENE
CAS:71-55-6
RTECS #:KJ2975000
Fraction by Wt: 32%
Other REC Limits:450 PPM STEL
OSHA PEL:350 PPM
ACGIH TLV:1910 MG/CUM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ozone Depleting Chemical:1
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: NOSE & THROAT IRRITATION.
CNS DEPRESSION. SKIN: PROLONGED CONTACT MAY CAUSE
IRRITATION/DISCOMFORT/DERMATITIS. ORGANIC SOLVENTS ABSORBED. EYES:
IRRITATION/BURNING. INGESTION: GI IRRITATION. PETROLEUM
DISTILLATES CAUSE INFLAMMATION/DAMAGE/DEATH. OVEREXPOSURE TO
SOLVENTS MAY CAUSE PERMANENT BRAIN/CNS DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INHALATION:
HEADACHE/DIZZINESS/NAUSEA/STAGGERING GAIT/LASSITUDE/LOSS OF
COORDINATION/CONFUSION/UNCONSCIOUSNESS. EYES: EYE
WATERING/HEADACHES/NAUSEA/DIZZINESS. SKIN:
DRYNESS/REDNESS/DEFATTING.
Medical Cond Aggravated by Exposure:EYE, SKIN, & RESPIRATORY DISORDERS
======================= First Aid Measures =======================
First Aid:INHALATION: REMOVE TO FRESH AIR. IF NECESSARY, GIVE CPR
(MOUTH-TO-MOUTH). EYES: IMMEDIATELY FLUSH W/WATER FOR AT LEAST 15
MINS. SKIN: WASH W/SOAP & WATER. INGESTION: DON'T INDUCE VOMITING.
KEEP HEAD L OWER THAN WAIST. ASPIRATION OF VOMITUS MAY RESULT IN
CHEMICAL/PULMONARY EDEMA. OBTAIN MEDICAL ATTENTION IN ALL CASES.
===================== Fire Fighting Measures =====================
Flash Point Method:CC
Flash Point:<20F
Lower Limits:1%
Upper Limits:13%
Extinguishing Media:FOAM, CO2, & DRY CHEMICAL
Fire Fighting Procedures:AVOID CONFINED SPACES. WEAR FULL PROTECTIVE
EQUIPMENT INCLUDING A POSITIVE PRESSURE NIOSH-APPROVED SCBA. WATER
MAY BE UNSUITABLE AS AN EXTINGUISHING MEDIUM.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR/ACCUMULATE IN
LOW AREA/TRAVEL TO IGNITION SITES. HEAT MAY CAUSE CANS TO
BURST/PROPELL CONTENTS. USE FOG NOZZLES TO PREVENT BUILD-UP.
================== Accidental Release Measures ==================
Spill Release Procedures:VENTILATE AREA. REMOVE SOURCES OF IGNITION.
WEAR APPROPRIATE CLOTHING/GEAR. PREVENT SKIN CONTACT & BREATHING OF
VAPOR. CONFINE IMMEDIATELY & REMOVE W/INERT ABSORBENT SUCH AS CLAY
OR SAND.
====================== Handling and Storage ======================
Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP FROM
IGNITION SOURCES. CAP CONTAINER AFTER EACH USE. DON'T STORE >120F.
STORE IN DRY, WELL VENTILATED PLACE.
Other Precautions:DON'T EXPOSE TO DIRECT SUNLIGHT TO AVOID BURSTING.
DON'T SPRAY NEAR OR FLAME. AVOID UNNECESSARY CONTACT. DON'T
INGEST/INHALE VAPORS. DON'T PUNCTURE CONTAINERS. DON'T SAND/FLAME
CUT/BRAZE/WELD DRY COAT ING W/OUT PROTECTION. KEEP COOL.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF TLV/PEL LIMITS EXCEEDED, WEAR A PROPERLY
FITTED VAPOR/PARTICULATE OR POSITIVE PRESSURE AIR SUPPLIED
RESPIRATOR APPROVED BY NIOSH/MSHA FOR USE W/PAINTS DURING
APPLICATION.
Ventilation:SUFFICIENT IN VOLUME & PATTERN TO KEEP CONTAMINANTS BELOW
LIMITS. USE ONLY EXPLOSION-PROOF EQUIPMENT W/FLAMMABLES.
Protective Gloves:NEOPRENE/PROTECTIVE CREAMS
Eye Protection:GOGGLES/SAFETY GLASSES W/SPLASH GUARDS
Other Protective Equipment:SIDE SHIELDS, FACE SHIELD, APRON, COVERALLS,
WORK CLOTHES, EYE WASHES, SAFETY SHOWERS
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING/SHOES
BEFORE REUSE. WASH AFTER HANDLING/BEFORE EATING/SMOKING. USE CARE
TO HANDLE.
Supplemental Safety and Health
INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING & INHALING VAPORS OF
THIS PRODUCT MAY BE HARMFUL OR FATAL. CONTENTS UNDER PRESSURE.
================== Physical/Chemical Properties ==================
Boiling Pt:B.P. Text:-43 TO 279F
Vapor Density:>1
Spec Gravity:0.9
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:AEROSOL CAN.
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ACIDS & BASES, SELECTED AMINES
Stability Condition to Avoid:HEAT OR SUNLIGHT, SOURCES OF IGNITION, HOT
METAL SURFACES, TEMPS >120F
Hazardous Decomposition Products:CO, CO2, UNIDENTIFIED ORGANIC
COMPOUNDS
==================== Disposal Considerations ====================
Waste Disposal Methods:DON'T ALLOW MATERIAL TO CONTAMINATE GROUND WATER
SYSTEMS. PLACE IN NON-LEAKING CONTAINERS. DISPOSE OF ABSORBED
MATERIAL IN ACCORDANCE W/ALL FEDERAL, STATE, & FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|