===================== Product Identification =====================
MSDS NAME:YC5119 SELECTRON
NIIN:00F031343
MSDS Number: BSNDQ
=== Responsible Party ===
Company:PPG INDUSTRIES
Address:ONE GATEWAY CENTER
City:PITTSBURGH
State:PA
ZIP:15222-1416
Country:US
Info Phone Num:412-434-3131
Emergency Phone Num:304-843-1300
CAGE:PPGIN
=== Contractor Identification ===
Company:PPG INDUSTRIES
Address:4325 ROSANNA DR
City:ALLISON PARK
State:PA
ZIP:15101-5000
Country:US
Phone:412-492-5555/304-843-1300
CAGE:PPGIN
Company:PPG INDUSTRIES INC CHEMICAL DIVISION
Address:ONE GATEWAY CENTER
City:PITTSBURGH
State:PA
ZIP:15222-1416
Country:US
Phone:304-843-1300
CAGE:93915
============= Composition/Information on Ingredients =============
Name:STYRENE, (MONOMER), SUSPECTED ANIMAL CARCINOGEN BY IARC &
ACGIH
CAS:100-42-5
RTECS #:WL3675000
Fraction by Wt: 35%
Other REC Limits:50 PPM
ACGIH TLV:213 MG/CUM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:WEIGHT PER GALLON IN POUNDS: 9
RTECS #:9999999WG
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:SKIN/EYES: PRIMARY IRRITATION.
INHALATION: ANESTHETIC EFFECTS. IRRITATION OF RESPIRATORY TRACT OR
ACUTE NERVOUS SYSTEM DEPRESSION. VAPORS ARE HARMFUL IF INHALED OR
INGESTED.
Explanation of Carcinogenicity:SEE INGREDIENTS.
Effects of Overexposure:INHALATION: HEADACHE, DIZZINESS, STAGGERING
GAIT, CONFUSION, UNCONSCIOUSNESS, OR COMA.
======================= First Aid Measures =======================
First Aid:INHALATION: REMOVE TO FRESH AIR. RESTORE BREATHING. KEEP WARM
& QUIET. EYES: FLUSH IMMEDIATELY W/COPIOUS QUANTITIES OF WATER FOR
AT LEAST 15 MINS. SKIN: WASH AFFECTED AREAS W/WATER. REMOVE
CONTAMINATE D CLOTHING. REMOVE FROM AFFECTED AREA BY WIPING,
FOLLOWED BY WATERLESS HAND CLEANER, SOAP & WATER. DON'T WEAR
CONTAMINATED CLOTHING/SHOES/GLOVES. OBTAIN MEDICAL ATTENTION IN ALL
CASES.
===================== Fire Fighting Measures =====================
Flash Point Method:PMCC
Flash Point:85F
Lower Limits:1.1%
Extinguishing Media:USE NFPA CLASS B EXTINGUISHERS (CO2, DRY CHEMICAL,
OR FOAM). WATER SPRAY MAY BE INEFFECTIVE.
Fire Fighting Procedures:USE WATER TO COOL CLOSED CONTAINERS TO PREVENT
PRESSURE BUILD-UP/POSSIBLE AUTOIGNITION/EXPLOSION. IF WATER IS
USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE,
AUTOIGNITE, BUILD-UP PRESSURE WHEN EXPOSED TO EXTREME HEAT.
FLAMMABLE.
================== Accidental Release Measures ==================
Spill Release Procedures:REMOVE SOURCES OF IGNITION. AVOID BREATHING
VAPORS. VENTILATE AREA. REMOVE W/INERT ABSORBENT & NON-SPARKING
TOOLS.
====================== Handling and Storage ======================
Handling and Storage Precautions:DON'T STORE >100F. DON'T TAKE
INTERNALLY. CONTAINERS SHOULD BE GROUNDED WHEN POURING. USE
W/ADEQUATE VENTILATION. AVOID VAPOR/SPRAY MIST INHALATION.
Other Precautions:AVOID FREE FALL OF LIQUID IN EXCESS OF FEW INCHES.
PREVENT PROLONGED SKIN CONTACT W/CONTAMINATED CLOTHING. KEEP
CONTAINERS TIGHTLY CLOSED. AVOID CONTACT W/EYES/SKIN/CLOTHING. KEEP
FROM CHILDREN. CLOSE CONTAINER AFTER EACH USE.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:OUTDOORS: FILTER TYPE RESPIRATOR. RESTRICTED
AREA: COMBINATION ORGANIC VAPOR-FILTER TYPE. CONFINED: SUPPLIED AIR
RESPIRATOR/HOODS.
Ventilation:GENERAL DILUTION OR LOCAL EXHAUST IN VOLUME & PATTERN TO
KEEP TLV OF MOST HAZARDOUS INGREDIENTS BELOW ACCEPTABLE LIMITS
Protective Gloves:REQUIRED FOR PROLONGED/REPEATED CONTACT
Eye Protection:SAFETY GLASSES IF SPLASHING OF LIQUIDS
Supplemental Safety and Health
STORE LARGE QUANTITIES IN BUILDINGS DESIGNED & PROTECTED FOR STORAGE OF
NFPA CLASS IC FLAMMABLE LIQUIDS.
================== Physical/Chemical Properties ==================
Boiling Pt:B.P. Text:146C
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:39.7
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:NO
PEROXIDES, FREE RADICAL INITIATORS, STRONG ALKALIS
Stability Condition to Avoid:HEAT, HOT SURFACES, TEMPS >100F,
ELECTRICAL/STATIC/FRICTIONAL SPARKS, & ALL OTHER SOURCES OF
IGNITION
Hazardous Decomposition Products:CO, ALDEHYDES, ORGANIC ACIDS, HEAVY
SMOKE
Conditions to Avoid Polymerization:RUNAWAY EXOTHERM MAY RESULT FROM
ELEVATED TEMPS & CONTACT W/PEROXIDES, INITIATORS, ALKALIES
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE, &
FEDERAL REGULATIONS. DON'T INCINERATE CLOSED CONTAINERS. FLAMMABLE.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|