===================== Product Identification =====================
MSDS NAME:R-501 REMOVER
NIIN:00-142-8840
MSDS Number: BDBRM
=== Responsible Party ===
Company:MET-L-CHEK COMPANY
Address:1639 EUCLID ST
City:SANTA MONICA
State:CA
ZIP:90404
Country:US
Info Phone Num:310-450-1111
Emergency Phone Num:310-450-1111/800-424-9300(CHEMTREC)
CAGE:98733
=== Contractor Identification ===
Company:MET-L-CHEK COMPANY
Address:1639 EUCLID ST
Box:00000
City:SANTA MONICA
State:CA
ZIP:90404
Country:US
Phone:310-450-1111/FAX 310452-4046
CAGE:98733
============= Composition/Information on Ingredients =============
Name:METHYL CHLOROFORM (1,1,1-TRICHLOROEHANE) (SARA III)
CAS:71-55-6
RTECS #:KJ2975000
OSHA PEL:350 PPM/450 STEL
ACGIH TLV:350 PPM/450STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ozone Depleting Chemical:1
Name:ISOBUTANE PROPANE MIXTURE
ACGIH TLV:ASPHYXIANTS
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE MILD IRRITATION TO SKIN &
RESP TRACT SYSTEM
Effects of Overexposure:INHALATION:MAY CAUSE IRRITATION TO NOSE AND
RESPIRATORY SYSTEM.EARLY TO MODERATE CNS DEPRESSION MAY BE
EVIDENCED BY DIZZ,GIDDINESS,HEADACHE,NAUSEA,EYES:VAPOR MAY CAUSE
IRRITATION;SKIN:LIQUID CONTACT M AY IRRITATE MILDLY;INGESTION:NOT
LISTED.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN,EYE,AND
RESPIRATORY DISORDERS MAY BE AGGRAVATED.
======================= First Aid Measures =======================
First Aid:INHALATION:REMOVE TO FRESH AIR.GIVE CPR IF
NEEDED;EYES/SKIN:FLUSH WITH RUNNING WATER FOR ATLEAST 15
MINUTES.GET MEDICAL HELP IF IRRITATION OCCURS OR PERSISTS;
INGESTION:IF VICTIM IS CONSCIOUS,DO NOT I NDUCE VOMITING.NOTHING BY
MOUTH IF UNCONSCIOUS GET MEDICAL ATTENTION.
===================== Fire Fighting Measures =====================
Flash Point:N/R (AEROSOLS)
Lower Limits:7.0 (LIQ)
Upper Limits:15.0 (LIQ)
Extinguishing Media:CO*2WATER,DRY CHEMICALS.
Fire Fighting Procedures:CONTAINERS EXPOSED TO INTENSE HEAT FROM FIRES
SHOULD BE COOLED WITH WATER SPRAY TO PREVENT VAPOR PRESSURE
BUILD-UP.USE NIOSH APPRVD SCBA IN CONFINED AREA.
Unusual Fire/Explosion Hazard:AEROSOL CANS MAY RUPTURE/EXPLODE DUE TO
VAPOR PRESSURE BUILDUP IF EXPOSED TO INTENSE HEAT.
================== Accidental Release Measures ==================
Spill Release Procedures:ELIMINATE IGNITION SORCES.WEAR PROTECTED
CLOTHING & APPROPRIATE RESPIRATOR.SOAKUP RESIDUE WITH ABSORBENT
CLAY,SAND,EARTH, OR OTHER MATERIAL.PLACE GAGS & ABSORBED WASTE AND
DAMAGED BUT EMPTY CANS IN DO T COVERED NON-LEAKING CONTAINERS.
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE AWAY FROM HOT PLACES & IGNITION
SOURCES.DO NOT STORE OR HANDLING IN ALUMINUM EQUIPMENT AT TEMP
ABOVE 120F.
Other Precautions:DURING TRANSFER OF LIQUID IN BULK,GROUND THE HANDLING
EQUIPMENT.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF EXPOSURE EXCEEDS TLV,USE NIOSH APPRVD
RESPIRATOR OR AN ORGANIC VAPOR CHEMICAL CARTRIDGE OR CANISTER TO
PREVENT OVEREXPOSURE.
Ventilation:PER MANUFACTURER,PROVIDE LOCAL EXHAUST, OR
MECHANICAL(GENERAL) VENTILATION TO MAINTAIN TLV.
Protective Gloves:VITON
Eye Protection:GOGGLES SPLASHPROOF WHEN HANDLING LIQ
Other Protective Equipment:EYEWASH FOUNTAINS AND SAFETY SHOWERS.
Work Hygienic Practices:WASH WITH SOAP AND WATER BEFORE EATING,
DRINKING,SMOKING OR USING TIOLET FACILITIES.
Supplemental Safety and Health
ITEM IS SINGLE UNIT FOR MIL-I-25135,REV D,QPL-25135-15;UNDER OLDER
VERSIONS OF APL & SPEC,THE NSN WAS OF GROUP I & VIT. UNDER
AOL-25135,THIS REMOVER ISZ CLASS.
================== Physical/Chemical Properties ==================
HCC:V2
NRC/State Lic Num:NOT RELEVANT
Vapor Density:4.55
Spec Gravity:0.8 (BULK)
Evaporation Rate & Reference:0.35 OF LIQ(ETHER=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:LIQUID BEFOR FILLING IN AEROSOL CANS IS CLEAR
COLORLESS LIQ WITH ETHER-LIKE ODO
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
LS.
Stability Condition to Avoid:HEAT,SPARKS,IGNITION SOURCES
Hazardous Decomposition Products:THERMAL DECOMP PRODUCES PHOSGENE, HCL
GASES
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE OF IN A PERMITTED HAZARDOUS WASTE
FACILITY.EMPTY AEROSOL CAN BEFORE DISPOSING OF THEM.PRESSURIZED
AEROSOL CANS ARE NOT ACCEPTABLE WASTE.COMPLY ALL FEDERAL,STATE &
LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|
| ALL PAGES On Chemical Property IN THIS GROUP
| | NAME | CAS |
|
IB NO 2654
| 108-88-3
75-09-2 |
|
1701, BRIGHT GOLD, SPRAY PAINT
| 108-88-3
75-09-2 |
|
KRYLON INT/EXT ENAMEL, 1901 REGAL BLUE
| 71-36-3
78-93-3
1330-20-7
108-88-3
67-64-1
74-98-6
108-10-1
108-65-6 |
|
KRYLON INTERIOR/EXTER ENAMEL AEROSOL 1901
| 67-64-1
74-98-6
108-10-1
108-88-3
111-15-9 |
|
LACQUER, AEROSOL 16099 GRAY
| 108-88-3
1330-20-7
75-09-2 |
|
DRO48-CONCENTRATE
| 108-88-3
1330-20-7
78-93-3
111-76-2 |
|
MOLYLUBE 503 GREASE
| 8012-95-1
1317-33-5 |
|
PLASTILUBE MOLY 3
| 12656-85-8
8012-95-1 |
|
PLASTILUBE MOLY 3
| 8012-95-1
1317-33-5 |
|
SAT-T-POL II
| |
|
8131 FORMULA
| 8002-74-2
7732-18-5 |
|
TRISODIUM PHOSPHATE ANHYDROUS
| 7601-54-9 |
|
TRISODIUM PHOSPHATE ANHYDROUS
| 7601-54-9 |
|
SODIUM PHOSPHATE,TRIBASIC
| 10101-89-0 |
|
TRISODIUM PHOSPHATE ANHYDROUS
| 7601-54-9 |
|
TPO-403, MED CHROME YELLOW, 7B
| 8001-26-1
8030-30-6 |
|
METOL
| 55-55-1 |
|
GLACIAL ACETIC ACID
| 64-19-7 |
|
ACETIC ACID,ETHANOIC ACID,METHANE CARBOXYLI
| 64-19-7 |
|
ACETIC ACID
| 64-19-7 |
|
VINEGAR ACID
| 64-19-7 |
|
AQUA AMMONIA,AMMONIA LIQUOR
| |
|
ROYCO 13D
| |
|
SUPERMIL ASU GREASE NO 31052
| |
|
ROYCO 13D
| 63148-52-7
116-14-3
25619-56-1
71011-25-1
7775-11-3 |
|
SUPERMIL GREASE NO. 1371
| |
|
LR-7132C OLIVE DRAB WW TYPE II 34087
| 8030-30-6
123-86-4
108-88-3
8030-30-6
110-69-0 |
|
LR-7605D LIGHT GRAY W W TYPE I #38440
| 64475-85-0
8030-30-6
123-86-4
110-69-0 |
|
GS-7128-G.LT GULL GREY,36440,WALKWAY TYPE 2
| 8030-30-6
96-29-7 |
|
WALKWAY COMPOUND, GRAY 36440
| 13463-67-7
14808-60-7
1480-96-6
64742-89-8 |
|
U-20 PART A
| |
|
U-20 PART B
| |
|
U-20 AGGREGATES
| 14808-60-7 |
|
SOLDERING FLUX
| 64-17-5 |
|
STA-SILV 15
| 7440-22-4
7440-50-8
7723-14-0 |
|
YELLOW 23531, 787-305, LACQUER CAMOFLAGE
| 7758-97-6
110-19-0
78-83-1
1330-20-7
108-88-3 |
|
GS-7126B BLACK,37038 WALKWAY COMPOUND,TY2
| 8030-30-6
1332-21-4
111-76-2
123-86-4
8030-30-6 |
|
GS-7126-G,BLK 37038 WLKWAY,TYPE 2(ROUGH)
| 8032-32-4
96-29-7 |
|
WALKWAY COMPOUND TYPE II BLACK 37038
| 61790-53-2
1333-86-4
8030-30-6
14807-96-6 |
|
BRACO MICRONIC 759
| 115-86-6 |
|
WITCH HAZEL
| |
|
FLUORO-FINDER FC-44 CLEANER
| 71-55-6
124-38-9 |
|
9 PR 551/K 410 C AEROSOL
| 71-55-6
74-98-6
75-28-5
106-97-8
75-65-0 |
|
CHLOROTHENE
| 71-55-6
124-38-9 |
|
SKC-NF/ZC-7 CLEANER/REMOVER(PER 6/88)
| 71-55-6
124-38-9 |
|
SKC-NF/ZC-7B CLEANER/REMOVR(SEE SUPPL DATA)
| 71-55-6
124-38-9
123-91-1 |
|
TURCO DY-CHEK REMOVER #3 PSV
| 76-13-1
124-38-9 |
|
PETROLEUM DISTILLATES
| 8002-05-9 |
|
R-501 REMOVER
| 71-55-6 |
|
#1033
| 108-88-3 |
|
|