===================== Product Identification =====================
MSDS NAME:LOCK BOND R-35, PART A
NIIN:01-043-3196
MSDS Number: BBKJM
=== Responsible Party ===
Company:INDUSTRIAL RUBBER CEMENT COMPANY
Address:15257 EAST PROCTOR AVENUE
City:INDUSTRY
State:CA
ZIP:91745
Info Phone Num:(213) 919-8270
Emergency Phone Num:(213) 333-4578
CAGE:55913
=== Contractor Identification ===
Company:INDUSTRIAL RUBBER CEMENT CO
Address:15257 E PROCTOR AVE
Box:City:CITY OF INDUSTRY
State:CA
ZIP:91745-1019
Country:US
CAGE:55913
============= Composition/Information on Ingredients =============
Name:EXPOXY RESIN
Other REC Limits:10 MG/CUM (DUST)
===================== Hazards Identification =====================
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN: IRRITATION & SENSITIVITY.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:SKIN: IRRITATION & SENSITIVITY.
======================= First Aid Measures =======================
Eyes: FLUSH W/PLENTY OF WATER FOR AT LEAST 15 MINS. SKIN:
WASH THOROUGHLY W/SOAP & WATER. INHALATION: REMOVE TO FRESH AIR.
GIVE CPR OR OXYGEN IF NEEDED. OBTAIN MEDICAL ATTENTION IF REQUIRED.
===================== Fire Fighting Measures =====================
Flash Point Method:TOC
Flash Point:295F
Extinguishing Media:CO2, DRY CHEMICAL
====================== Handling and Storage ======================
Handling and Storage Precautions:SOME EPOXY SYSTEMS CAN IRRITATE &
SENSITIZE THE SKIN. AVOID PROLONGED OR REPEATED CONTACT WITH
W/SKIN. USE W/ADEQUATE VENTILATION.
Other Precautions:AVOID BREATHING OF VAPORS DURING CURE.
============= Exposure Controls/Personal Protection =============
Ventilation:LOCAL EXHAUST: ADEQUATE. VENT CURING OVEN TO OUTSIDE.
Supplemental Safety and Health
================== Physical/Chemical Properties ==================
Spec Gravity:9.92
Appearance and Odor:OPAQUE (WHITE) LIQUID
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:UNTIL PART A AND B ARE MIXED.
Conditions to Avoid Polymerization:WHEN PART A & B ARE MIXED TOGETHER
AN EXOTHERM IS GENERATED.
==================== Disposal Considerations ====================
Waste Disposal Methods:N/K
_
_
_
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD ***