=====================  Product Identification  =====================

MSDS NAME:IONOGRAPHIC TONER, RP1345
NIIN:00N089494
Status Code:A
MSDS Number: CHVGC
=== Responsible Party ===
Company:COATES REPROGRAPHICS INC
Address:COUNTY CLUB RD
Box:160
City:DALLAS
State:PA
ZIP:18612
Country:PA
Info Phone Num:717-675-1131
Emergency Phone Num:717-675-1131
CAGE:3S299
=== Contractor Identification ===
Company:COATES REPROGRAPHICS INC
Address:COUNTRY CLUB RD
Box:City:DALLAS
State:PA
ZIP:18612-9171
Country:US
Phone:717-675-1131
CAGE:3S299

=============  Composition/Information on Ingredients  =============

Name:IRON OXIDE
CAS:1317-61-9
Fraction by Wt: 55-75%
OSHA PEL:10 MG/M3
ACGIH TLV:5 MG/M3

Name:CARBON BLACK
CAS:1333-86-4
RTECS #:FF5800000
Fraction by Wt: <10%
OSHA PEL:3.5 MG/M3
ACGIH TLV:3.5 MG/M3

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:NO
Reports of Carcinogenicity:NTP:YES    IARC:YES	  OSHA:NO
Health Hazards Acute and Chronic:ACUTE: SKIN: NONE KNOWN. INHALED:
    MINIMAL LUNG IRRIT MAY OCCUR AS W/EXPOSURE TO LARGE AMOUNTS OF ANY
    DUST. CHRONIC: NONE KNOWN. NOTE: ACGIH TLV 10MG/M3 (EXPS LIMIT) FOR
    "PARTICULATES NOT OTHERWISE CLA SSIFIED" (NUISANCE PARTICULATES).
    IN CHRONIC INHAL STUDY IN RATS USING SPEC TEST TONER, THERE WERE NO
    (EFTS OF OVEREXP)
Explanation of Carcinogenicity:CARBON BLACK: IARC MONO, VOL 65, PG 149,
    GROUP 2B. 1996: GROUP 2B.
Effects of Overexposure:HLTH HAZ: LUNG CHANGES @ ALL IN LOWEST EXPOS
    LEVEL (1MG/M3), MOST RELEVANT LEVEL TO POTNTL HUMAN EXPOS. VERY
    SLIGHT DEGREE OF FIBROSIS WASTE NOTED IN 25% OF ANIMALS @ MIDDLE
    EXPOS LEVEL (4MG/M3) WHILE	SLIGHT DEGREE OF FIBROSIS WAS OBSERVED@
    HIGHEST EXPOS LEVEL (16MG/M3) IN ALL ANIMALS. THESE FINDINGS ARE
    (SUPDAT)
Medical Cond Aggravated by Exposure:NONE WHEN USED AS INTENDED IN THE
    PRINTING EQUIPMENT FOR WHICH IT IS DESIGNED.

=======================  First Aid Measures  =======================

First Aid:INGEST: DILUTE STOM CONTENTS WITH SEVERAL GLASSES OF WATER.
    SEEK MEDICAL ATTENTION IF NECESSARY. EYES: FLUSH WITH WATER FOR AT
    LEAST 15 MINUTES. SEEK MEDICAL ATTENTION IF IRRITATION DEVELOPS.
    SKIN: WA SH WITH SOAP AND WATER. INHAL: REMOVE FROM EXPOSURE.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT .
Unusual Fire/Explosion Hazard:MATERIAL IS COMBUSTIBLE. WHEN DISPERSED
    IN AIR, AS A DUST, IT CAN FORM EXPLOSIVE MIXTURES.

==================  Accidental Release Measures  ==================

Spill Release Procedures:LOOSE INK CAN BE REMOVED USING A VACUUM
    CLEANER AND MAY BE SWEPT UP (AVOID DUST INHALATION - USE
    APPROPRIATE DUST MASK IF NECESSARY).
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN A COOL DRY, WELL VENTILATED
    AREA.
Other Precautions:AVOID PROLONGED INHALATION OF EXCESSIVE DUST.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NIOSH APPROVED RESPIRATOR APPROPRIATE FOR
    EXPOSURE OF CONCERN .
Ventilation:NORMAL CARE IN HANDLING A PARTICULATE MATERIAL.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EFTS OF OVEREXP: ATTRIBUTED TO "LUNG OVERLOADING", GENERIC RESPONSE TO
    EXCESS AMTS OF ANY DUST RETAINED IN LUNGS FOR PRLNGD INTERVAL. SPEC
    TEST TONER WAS 10 TIMES MORE RESPIRABLE THAN COMMERCIALLY AVA IL
    TONER TO COMPLY W/EPA TESTING PROTOCOL. ON BASIS OF THIS INFO,
    EXPOS LIMIT OF 2.5MG/M3(TOTAL DUST) IS RECOMMENDED.

==================  Physical/Chemical Properties  ==================

Melt/Freeze Pt:M.P/F.P Text:>212F,>100C
Spec Gravity:1.5-1.7(H*2O=1)
Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:NEGLIGIBLE
Appearance and Odor:FINE BLACK POWDER. MILD RESINOUS ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

====================  Disposal Considerations  ====================

Waste Disposal Methods:LANDFILL OR INCINERATE. ENSURE CONFORMITY WITH
    FEDERAL, STATE, AND LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***