=====================  Product Identification  =====================

MSDS NAME:RHODORSIL 90 CLEAR
NIIN:00N089484
Status Code:A
MSDS Number: CHVFR
=== Responsible Party ===
Company:RHODIA INC
Address:PROSPECT PLAINS RD, CN 7500
City:CRANBURY
State:NJ
ZIP:08512-7500
Country:US
Info Phone Num:609-860-3435
Emergency Phone Num:800-334-7577;800-424-9300(CHEMTREC)
CAGE:RHXDX
=== Contractor Identification ===
Company:RHODIA INC
Address:PROSPECT PLAINS RD, CN 7500
Box:City:CRANBURY
State:NJ
ZIP:08512-7500
Country:US
Phone:609-860-3435/800-243-5052
CAGE:RHXDX

=============  Composition/Information on Ingredients  =============

Name:POLYDIMETHYLSILOXANE FLUIDS
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:ACETOXYSILANE CURING AGENTS
Fraction by Wt: <5%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:FILLERS
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:ACETIC ACID (EMITTED DURING CURING)  (CERCLA)
CAS:64-19-7
RTECS #:AF1225000
Fraction by Wt: 2.5%
OSHA PEL:10 PPM
ACGIH TLV:10 PPM;15 STEL
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Name:EFTS OF OVEREXP:BEGINNING AT APPROX 150C(300F). EXPOS TO
    FORMALDEHYDE CAN CAUSE ADVERSE EFTS SUCH AS SKIN & RESP (ING 6)
RTECS #:9999999ZZ

Name:ING 5:SENSIT & EYE & THROAT IRRIT. FORMALDEHYDE IS A POTNTL
    CANCER HAZ. TOX INFO:ACUTE:SKIN:IRRIT (RABBIT). (ING 7)
RTECS #:9999999ZZ

Name:ING 8:ING 4:SEVERELY IRRITATING, EMITTED DURING CURING.
RTECS #:9999999ZZ

Name:FIRST AID PROC:INGEST:IF VICTIM IS CONSCIOUS & ALERT, GIVE
    1-2 GLASSES OF WATER TO DRINK. DO NOT GIVE ANYTHING BY(ING 9)
RTECS #:9999999ZZ

Name:ING 8:MOUTH TO UNCON PERS. SEEK MD. DO NOT LEAVE VICTIM
    UNATTENDED. NOTES TO MD:ALL TREATMENTS SHOULD BE BASED (ING 10)
RTECS #:9999999ZZ

Name:ING 9:ON OBSERVED SIGNS & SYMPS OF DISTRESS IN PATIENT.
    CONSIDERATION SHOULD BE GIVEN TO POSS THAT OVEREXP TO (ING 11)
RTECS #:9999999ZZ

Name:ING 10:MATLS OTHER THAN THIS PROD MAY HAVE OCCURRED. TREAT
    SYMPTOMATICALLY. NO SPECIFIC ANTIDOTE AVAILABLE.
RTECS #:9999999ZZ

Name:SPILL PROC:CNTNR. CLEAN UP RESIDUAL MATL W/APPROP SOLV LIKE
    PAINT THINNER/MINERAL SPIRITS, PROVIDED THAT THERE (ING 13)
RTECS #:9999999ZZ

Name:ING 12:IS GOOD VENTILATION & NO SOURCES OF IGNITION. DO NOT
    FLUSH TO DRAIN.
RTECS #:9999999ZZ

Name:WASTE DISP METH:MORE RESTRICTIVE/OTHERWISE DIFF FROM FED
    LAWS & REGS. CONSULT STATE & LOC REGS REGARDING PROPER (ING 15)
RTECS #:9999999ZZ

Name:ING 14:DISPOSAL OF THIS MATERIAL. ANY CONTAINERS OR
    EQUIPMENT USED SHOULD BE DECONTAMINATED IMMEDIATELY AFTER USE.
RTECS #:9999999ZZ

Name:OTHER PREC:POLYETHYLENE-LINED, METAL. MIN/MAX STOR
    TEMP:5-25C (41-77F). CLEAN EQUIP & PIPING SYS FOR MAINT & (ING 17)
RTECS #:9999999ZZ

Name:ING 16:REPAIRS. USE GOOD INDUS HYGIENE PRACTICES TO EVAL &
    CONTROL EXPOS TO FORMALDEHYDE WHEN WARRANTED BY (ING 18)
RTECS #:9999999ZZ

Name:ING 17:CNDTNS OF USE. DO NOT STORE, USE &/OR CONSUME FOODS,
    BEVERAGES, TOBACCO PRODS/COSMETICS IN AREAS WHERE (ING 20)
RTECS #:9999999ZZ

Name:ING 19:THIS MATERIAL IS STORED.
RTECS #:9999999ZZ

Name:HYGIENE PRACT:SKIN PROMPTLY TO REMOVE ACCIDENTAL SPLASHES
    OF CONTACT W/THIS MATERIAL.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:LD50:(ORAL,RAT) 3310 MG/KG.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE:ING 4:EMITTED DURING CURING,
    MAY CAUSE REDNESS, TISS DESTRUCT, IRRIT. SKIN:HARMFUL IF ABSORBED.
    ING 4:EMITTED DURING CURING, MAY BE ABSORBED. MAY CAUSE REDNESS,
    INFLAMM, IRRIT. INHAL:HARMFUL  IF INHALED. ING 4:EMITTED DURING
    CURING, MAY CAUSE RESP TRACT IRRIT. INGEST:LOW ORAL TOX. CHRONIC:
    (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:LONG-TERM EXPOS TO LOW CONCS OF ING 4
    MAY CAUSE BLACKENING & THICKENING OF SKIN OF HANDS, EYE/LUNG IRRIT,
    EROSION OF TOOTH ENAMEL. FORMS ING 4 DURING CURING WHICH MAY BE
    HARMFUL IF SWALLOWED,  IS SEVERELY IRRIT TO EYES. ING 1:CAN
    GENERATE SM AMTS OF FORMALDEHYDE AS BYPROD OF OXIDATIVE THERMAL
    DECOMP (ING 5)
Medical Cond Aggravated by Exposure:NO SPECIFIC INFORMATION FOUND.

=======================  First Aid Measures  =======================

Eyes:IMMED ABSORB EXCESS W/CLEAN ABSORB CLOTH/COTTON. THEN,
    HOLD LIDS OPEN & FLUSH W/STEADY, GENTLE STREAM OF WATER FOR AT LST
    15 MINS. SEEK MD IF IRRIT DEVELS/PERSISTS OR IF VISUAL CHANGES
    OCCUR. SKI N:IMMED WIPE EXCESS MATL OFF W/DRY CLOTH; THEN WASH
    W/PLENTY OF SOAP & WATER. SEEK MD IF IRRIT DEVELS/PERSISTS.
    INHAL:REMOVE VICTIM TO FRESH AIR. SEEK MED ATTN IF RESP
    IRRIT/DISTRESS CONTINUES.(ING 8)

=====================  Fire Fighting Measures  =====================

Flash Point Method:CC
Flash Point:>302F,>150C
Lower Limits:5.4%
Upper Limits:16%
Extinguishing Media:DRY CHEMICAL, FOAM, CARBON DIOXIDE.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . COOL CONTAINERS EXPOSED TO FIRE W/WATER.
Unusual Fire/Explosion Hazard:PRODUCT WILL BURN UNDER FIRE CONDITIONS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:WEAR APPROP PROT GEAR FOR SITUATION. SEE
    SECTION 8. CAUT:SPILLED MATL MAY MAKE FLOOR SLIPPERY. DO NOT LEAVE
    TRACES OF PROD ON FLOORS, LADDERS, ETC, AS THIS MAY PRESENT
    SLIPPING HAZ. ABSORB W/INERT ABS ORB. SCRAPE UP & PLACE IN APPROP
    CLSD (ING 12)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:AVOID BRTHG VAPS & MISTS. AVOID
    DIRECT/PRLNG CONT W/SKIN & EYES. USE NON-SPARKING TOOLS &
    GROUNDED/BONDED EQUIP & CNTNRS WHEN TRANSFERRING.
Other Precautions:KEEP CNTNRS CLSD WHEN STORED & WHEN NOT BEING USED TO
    AVOID PREMATURE CURING. ROTATE STOCKS. STORE IN AREA THAT IS DRY,
    WELL-VENTED, AWAY FROM INCOMPAT MATLS. STORE IN ORIGINAL CNRTNR.
    REC CNTNR MATL: POLYETHYLENE, ALUMINUM, (ING 16)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WHEN RESPS ARE REQD, SELECT NIOSH APPRVD EQUIP
    BASED ON ACTUAL/POTNTL AIRBORNE CONCS & I/A/W APPROP REGULATORY
    STDS &/OR INDUS RECS. FOR REAS FORESEEABLE INDUS & USES OF THIS
    MATL, RESP PROT SHOULD NO T BE NEC.
Ventilation:WHERE ENGINEERING CONTROLS ARE INDICATED BY USE
    CNDTNS/POTNTL FOR EXCESSIVE EXPOS EXISTS, FOLLOWING TRADITIONAL
    (SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:ANSI APPRVD EYE WASH FOUNTAIN & DELUGE
    SHOWER . SUITABLE LONG-SLEEVED CLTHG (I.E., SHIRTS & PANTS). (SUPP
    DATA)
Work Hygienic Practices:WASH HANDS & FACE CAREFULLY BEFORE EATING,
    DRINKING, USING TOBACCO, APPLYING COSMETICS/USING TOILET. WASH
    EXPOS (ING 21)
Supplemental Safety and Health
HAZ DECOMP PROD:DIMETHYLCYCLOSILOXANES, METHYLPHENYLCYCLOSILOXANES;
    (OXIDATIVE/THERMAL):FORMALDEHYDE. VENT:EXPOS CONTROL TECHNIQUES MAY
    BE USED TO EFTIVELY MIN EMPLOYEE EXPOS:GEN AREA DILUTION/EXHST V
    ENT. OTHER PROT EQUIP:CONSIDERATION MUST BE GIVEN BOTH TO
    DURABILITY AS WELL AS PERMEATION RESISTANCE.

==================  Physical/Chemical Properties  ==================

Decomp Temp:Decomp Text:>392F,>200C
Vapor Pres:<0.1 @ 20C
Vapor Density:2.07
Spec Gravity:1.04
Solubility in Water:SLOWLY HYDROLYSES
Appearance and Odor:TRANSLUCENT, PASTE-LIKE SOLID; ACETIC ACID ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
MOISTURE, WATER, STRONG BASES, STRONG ACIDS, STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:COMBUSTIBLE MATERIALS, HEAT, OPEN FLAME,
    SPARK, WATER, EXTREME HUMIDITY.
Hazardous Decomposition Products:(UNDER FIRE CNDTNS):FORMALDEHYDE,
    OXIDES OF CARBON, SILICA (CRYSTALLINE); (HYDROLYSIS):ACETIC ACID;
    (THERMAL): (SUPDAT)

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISP MUST BE I/A/W FED, STATE & LOC REGS . CHEM
    ADDNS, PROCESSING/OTHERWISE ALTERING MATL MAY MAKE WASTE MANAGEMENT
    INFO INCOMPLETE, INACCURATE/OTHERWISE INAPPROP. PLEASE BE ADVISED
    THAT STATE &  LOC REQUIREMENTS FOR WASTE DISP MAY BE(ING 14)

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***