=====================  Product Identification  =====================

MSDS NAME:1500 SINCO CREEPY
NIIN:00F056945
Status Code:A
MSDS Number: CHZYH
=== Responsible Party ===
Company:SNYDER MANUFACTURING CORP
Address:1541 W COWLES STREET
City:LONG BEACH
State:CA
ZIP:90813-1224
Country:US
Info Phone Num:213-432-2038
Emergency Phone Num:213-432-2038
CAGE:GO221
=== Contractor Identification ===
Company:SNYDER MANUFACTURING CORP
Address:1541 W COWLES STREET
City:LONG BEACH
State:CA
ZIP:90813-1224
Country:US
Phone:213-432-2038
CAGE:GO221
Company:SNYDER MFG CO
Address:1541 W COWLES ST
Box:City:LONG BEACH
State:CA
ZIP:90813-1224
Country:US
Phone:213-432-2038 800-424-9300(CHEMTREC)
CAGE:9N258

=============  Composition/Information on Ingredients  =============

Name:STODDARD SOLVENT (PETROLEUM DISTILLATE), MINERAL SPIRITS   
      *98-3*
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: >80%
Other REC Limits:525 MG/CUM
OSHA PEL:500 PPM
ACGIH TLV:100 PPM

Name:PETROLEUM OIL, HYDROTREATED HEAVY NAPHTHENIC DISTILLATE
    (PETROLEUM), PETROLEUM DISTILLATES, MINERAL OIL (SEVERE)
CAS:64742-52-5
RTECS #:PY8035001
Fraction by Wt: >10%

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE IRRITANT, BLURRED VISION.
    SKIN: PROLONGED/REPEATED CONTACT CAN CAUSE IRRITATION, DERMATITIS.
    INGESTION: GASTROINTESTINAL IRRITATION. ASPIRATION INTO THE LUNGS
    CAN CAUSE CHEMICAL PNEUMONIT IS WHICH CAN BE FATAL. INHALATION:
    NASAL/RESPIRATORY IRRITANT. CNS EFFECTS. MAY CAUSE DEATH.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
    DEFATTING OF SKIN, NAUSEA, VOMITING, DIARRHEA, DIZZINESS, WEAKNESS,
    FATIGUE, HEADACHE, UNCONSCIOUSNESS

=======================  First Aid Measures  =======================

First Aid:SKIN: THOROUGHLY WASH W/SOAP & WATER. EYES: FLUSH W/LARGE
    AMOUNTS OF WATER. INGESTION: DON'T INDUCE VOMITING. KEEP
    WARM/QUIET. INHALATION: REMOVE TO FRESH AIR. IF BREATHING IS
    DIFFICULT, ADMINISTER OX YGEN. IF BREATHING HAS STOPPED, GIVE CPR.
    OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:165F
Upper Limits:>1
Extinguishing Media:FOAM, CO, DRY CHEMICAL
Unusual Fire/Explosion Hazard:VAPORS ARE >AIR, MAY TRAVEL ALONG THE
    GROUND/BE MOVED BY VENTILATION & IGNITE BY IGNITION SOURCES AT
    LOCATIONS DISTANT FROM MATERIAL HANDLING POINT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ELIMINATE IGNITION SOURCES. EVACUATE
    UNPROTECTED PERSONNEL FROM AREA. STOP LEAK AT SOURCE, DIKE AREA.
    PUMP LIQUID TO SALVAGE TANK. REMAINING LIQUID CAN BE TAKEN UP
    W/SAND/EARTH/FLOOR ABSORBENT/OTHER A BSORBENT. SHOVEL INTO
    CONTAINERS. (SEE SUPP)

======================	Handling and Storage  ======================

Handling and Storage Precautions:AVOID STORING NEAR OPEN FLAME.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF WORKPLACE EXPOSURE LIMITS OCCUR, A NIOSH/MSHA
    APPROVED RESPIRATOR SHOULD BE PROVIDED IN ABSENCE OF PROPER
    ENVIRONMENTAL CONTROL.
Ventilation:SUFFICIENT MECHANICAL VENTILATION TO MAINTAIN TLV BELOW
    EXPOSURE LEVEL.
Protective Gloves:NITRILE RUBBER
Eye Protection:CHEMICAL SPLASH GOGGLES
Other Protective Equipment:PROTECTIVE IMPERVIOUS CLOTHING & BOOTS
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
    REUSE.
Supplemental Safety and Health
SPILL PROC CONT'D: PREVENT RUN-OFF TO SEWERS, STREAMS/OTHER BODIES OF
    WATER.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>334F
Vapor Pres:>2
Vapor Density:4.9
Spec Gravity:0.806
Evaporation Rate & Reference:(ETHER=1): >70
Solubility in Water:NONE
Appearance and Odor:THIN STRAW COLORED LIQUID
Percent Volatiles by Volume:100

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS
Stability Condition to Avoid:HEAT, PILOT LIGHTS, FLAMES & OTHER
    IGNITION SOURCES
Hazardous Decomposition Products:CO2, CO, VARIOUS HYDROCARBONS

====================  Disposal Considerations  ====================

Waste Disposal Methods:CONTAMINATED ABSORBENT MAY BE DEPOSITIED IN A
    LANDFILL/DISPOSED OF IAW/LOCAL, STATE & FEDERAL REGULATIONS.
    DESTROY BY LIQUID INCINERATION. COMBUSTIBLE LIQUID UN1255.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***