=====================  Product Identification  =====================

MSDS NAME:03-GY-56,BASE,GRAY 16440,POLYURETHANE,GLOSS
NIIN:01-068-3115
Kit Part:Y
MSDS Number: BGKFZ
=== Responsible Party ===
Company:DEFT CHEMICAL COATINGS
Address:17451 VON KARMAN AVE
City:IRVINE
State:CA
ZIP:92714-6205
Country:US
Emergency Phone Num:714-549-8911
CAGE:EO418
=== Contractor Identification ===
Company:DEFT CHEMICAL COATINGS
CAGE:EO418
Company:DEFT,  INC.
Address:17451 VON KARMAN AVE
City:IRVINE
State:CA
ZIP:92614
Country:US
Phone:949-474-0400
CAGE:33461

=============  Composition/Information on Ingredients  =============

Name:METHYL ETHYL KETONE (2-BUTANONE) (MEK)  (SARA III)
CAS:78-93-3
RTECS #:EL6475000
Fraction by Wt: 2.0%
OSHA PEL:200 PPM/300 STEL
ACGIH TLV:200 PPM/300STEL 9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Name:2-ETHOXYETHYL ACETATE (CELLOSOLVE ACETATE) (EGEEA)
CAS:111-15-9
RTECS #:KK8225000
Fraction by Wt: 20.0%
OSHA PEL:S,100 PPM
ACGIH TLV:S, 5 PPM; 9192

Name:N-BUTYL ACETATE  (SARA III)
CAS:123-86-4
RTECS #:AF7350000
Fraction by Wt: 5.0%
OSHA PEL:150 PPM/200 STEL
ACGIH TLV:150 PPM/200STEL;9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Name:XYLENES (O-,M-,P- ISOMERS)	(SARA III)
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 1.0%
OSHA PEL:100 PPM/150 STEL
ACGIH TLV:100 PPM/150STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Name:TOLUENE  (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 5.0%
OSHA PEL:200 PPM/150 STEL
ACGIH TLV:50 PPM; 9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

=====================  Hazards Identification  =====================

Effects of Overexposure:EYES:MOSERATE IRRIT;SKIN:POSSIBLE IRRIT BY
    SOLVENTS;INH:SOLVENT VAPORS CAN CAUSE IRRIT OR NARCOSIS.

=======================  First Aid Measures  =======================

First Aid:SKIN:WIPE OFF WITH A RAG THEN THOROUGH RINSING W/H*2O &
    WASHING W/MILD SOAP AND WATER;EYES:FLUSH W/WATER FOR AT LEAST 10
    MIN & CONSULT AN EYE PHYSICIAN;INH:REMOVE TO FRESH AIR.GIVE
    CPR/OXYGEN IF NEEDE D.

=====================  Fire Fighting Measures  =====================

Flash Point:28F(-2.2C)-OC
Lower Limits:UNK
Extinguishing Media:CO*2,DRY CHEM,FOAM
Fire Fighting Procedures:DO NOT USE H*2O STREAM ON FIRE.H*2O SPRAY/FOG
    IS MORE EFFCTV
Unusual Fire/Explosion Hazard:CAUTION AGAINST APPLICATION TO HOT
    SURFACES & USE IN AREAS WHERE SOURCES OF IGNITION MAY BE PRESENT

==================  Accidental Release Measures  ==================

Spill Release Procedures:EVACUATE UNPROTECTED PERSONS.ELIM IGN
    SOURCES.USE SAFETY EQUIP.VENTLATE AREA.STOP LEAK W/O RISK.ABSORB SM
    SPILL W/OIL ABSORBNG COMPD/RAGS;DIKE LG SPILL.PUMP LIQ TO SALVAGE
    TANK.SHOVEL UP RESIDUE INTO  COVRD DRUMS;PER MFR,FLUSH AREA W/LG
    AMOH*2O.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN COOL,DRY WELL VENTILATED,LOW
    FIRE RISK AREA.KEEP CONTNRS TIGHTLY CLOSED.KEEP AWAY FM HEAT,SPARK
    OR OPEN FLAME.
Other Precautions:AVOID PROLONGED INHALATION OF VAP .PER MFR,WATER
    SPRAY OR FOG CAN BE USED EFFECTIVELY ON FIRE AND TO COOL HEAT/FIRE
    EXPOSED CONTNRS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:GOOD VENTILATION IS NEEDED. HOWEVER USE NIOSH
    APPRVD SCBA FOR PAINTS
Ventilation:USE ADEQUATE VENTILATION USING EXHAUST FAN.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY/CHEM GOGGLES.
Other Protective Equipment:AS REQD TO PREVENT PROLONGED OR REPEATED
    CONTACT.
Supplemental Safety and Health
PART A OF 2 PART KIT;SEE P/N IND "B" FOR CATALYST;THIS ALSO CONTAINS:2%
    SC-150 SOLVNT(HI-BOILING AROMIC HYDROCARBON & 65%
    NON-AQUEOUSSOLUTION,HAZARD UNKNOWN,UNIDENTIFIED;MSDS
    DATED:01/15/76.KEY1:F3

==================  Physical/Chemical Properties  ==================

HCC:F2
Boiling Pt:B.P. Text:175-398F
Vapor Density:>1.0
Spec Gravity:1.3444
Evaporation Rate & Reference:<1(SLWR THAN ETHR)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:GRAY PAINT ODOR OR ORGANIC SOLVENTS.
Percent Volatiles by Volume:50%

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
OXIDIZING & CORROSIVE MATERIALS.
Stability Condition to Avoid:SOURCE OF IGN,SPARK,HEAT & OPEN FLAME

====================  Disposal Considerations  ====================

Waste Disposal Methods:KEEP IN CLOSED CONTNRS PENDING DISPOSAL.MFR
    SUGGESTED,DISPOSE IN TIGHTLY CLOSED CONTAINERS & FINALLY DISPOSE BY
    SANITARY LANDFILL IAW APPLICABLE REGS;HANDLE & DISPOSE IN FULL
    COMPLIANCE W/ALL FED,STAT E,& LOCAL REGULATIONS CONCERNING WASTE
    DISPOSAL.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***