=====================  Product Identification  =====================

MSDS NAME:473308
NIIN:01-149-4198
MSDS Number: BGNYP
=== Responsible Party ===
Company:MSA
Emergency Phone Num:412-273-5000
CAGE:NO058
=== Contractor Identification ===
Company:MINE SAFETY APPLIANCE  (REPLACED BY CAGE 55799)
Address:201 N BRADDOCK AVENUE
Box:426
City:PITTSBURGH
State:PA
ZIP:15230
Country:US
Phone:412-967-3000
CAGE:40912
Company:MSA
CAGE:NO058

=============  Composition/Information on Ingredients  =============

Name:ACRYLIC POLYMER
CAS:9003-01-4
RTECS #:AT4680000
Fraction by Wt: 19%

Name:RESIDUAL MONOMER (ACRYLIC)
Fraction by Wt: 0.15%
ACGIH TLV:10 PPM

Name:WATER
CAS:7732-18-5
RTECS #:ZC0110000
Fraction by Wt: 81%

=====================  Hazards Identification  =====================

Effects of Overexposure:EYE & RESP TRACT IRRIT,HEAD,NAU. SKIN IRRIT

=======================  First Aid Measures  =======================

First Aid:INHAL:RMV TO FRESH AIR. IF NOT BRTHNG GIVE CPR; IF BRTHNG
    DIFF GIVE OXYGEN. EYE:IMMED FLUSH W/PLENTY OF WATER. SKIN:WASH
    W/SOAP&WATER. RMV CONTAM CLTHG&SHOES. INGEST:INDUCE VOMIT. RPT
    UNTIL VOMIT IS C LEAR. NOTHG BY MOUTH IF UNCONSC. GET MEDICAL ATTN.

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Lower Limits:NONE
Upper Limits:NONE
Fire Fighting Procedures:WEAR MESA/NIOSH APPROVED SELF-CONTAINED BRTHG
    APPARATUS
Unusual Fire/Explosion Hazard:ACRYLIC EMULSIONS WILL NOT BURN. MAY
    SPATTER >212F. DRIED POLYMER FILMS WILL BURN.

==================  Accidental Release Measures  ==================

Spill Release Procedures:EVAC AREA, DIKE & CONTAIN SPILL W/INERT
    MATERIAL (DRY SAND,ETC.) & TRANS THE LIQUID TO DISPOSAL CONTAINERS.
    KEEP SPILL OUT OF SEWERS & OPEN BODIES OF WATER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN WELL VENT AREA BETWEEN 35F &
    100F. KEEP FROM FREEZING. KEEP CONTAINERS TIGHTLY CLOSED. PROTECT
    FM DAMAGE. DO NOT INHAL MIST,VAPORS OR DUST.
Other Precautions:USE ONLY W/GOOD VENTILATION. HAZ VAPORS CAN PRESENT
    PROBLEMS IN WORK AREA WERE PROD IS HEAT CURED OR DRIED IF NOT
    EXHAUSTED PROPERLY. DUSTS OR MISTS SHOULD BE <10 MG/CUM FOR 8HR
    TWA.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NONE REQUIRED W/GOOD VENTILATION. WEAR
    NIOSH/MESA APPR IF REQD.
Ventilation:LOCAL EXHAUST RECOMMENDED AT POINT OF VAPOR/MIST/DUST.
Protective Gloves:IMPERVIOUS
Eye Protection:CHEM SPLASH GOGGLES
Other Protective Equipment:EYE WASH STATION. EMER SHOWER.
Supplemental Safety and Health
MSDS DATED 7/79

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:212F,100C
Vapor Pres:17
Vapor Density:0.62
Spec Gravity:1.1
Evaporation Rate & Reference:0.36(BU-AC=1)
Solubility in Water:COMPLETE
Appearance and Odor:MILKY-WHITE LIQUID; MILD ACRYLIC ODOR
Percent Volatiles by Volume:81

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
Hazardous Decomposition Products:CO, CO*2 & TOXIC MONOMER FUMES

====================  Disposal Considerations  ====================

Waste Disposal Methods:EMULSION CAN BE COAGULATED BY STEPWISE ADD OF
    LIME & FERRIC CHLORIDE/SULFATE. INCINERATE IN APPROVED EQUIP.
    COAGULUM & CONTAM DIKE MATL SHOULD BE LANDFILLED I/A/W LOCAL,STATE
    & FEDERAL REGULATIONS.CLE AR WATER MAY BE SEWERED FOR BIOLOGICAL
    TREATMENT.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***