=====================  Product Identification  =====================

MSDS NAME:AUTOMATIC TRANSMISSION FLUID TYPE FA
NIIN:00N011780
MSDS Number: BJHXK
=== Responsible Party ===
Company:VALVOLINE OIL CO (ASHLAND)
Box:391
City:ASHLAND
State:KY
ZIP:41114
Country:US
Info Phone Num:606-329-3333
Emergency Phone Num:606-324-1133
CAGE:72527
=== Contractor Identification ===
Company:VALVOLINE OIL CO
Address:3499 BLAZER PKY
Box:14000
City:LEXINGTON
State:KY
ZIP:40512
Country:US
Phone:606-357-7206 / 800-274-5263
CAGE:72527

=============  Composition/Information on Ingredients  =============

Name:PETROLEUM BASED-LUBRICATING OIL (LIMITS ARE FOR OIL MIST, )
OSHA PEL:5 MG/M3
ACGIH TLV:5 MG/M3

Name:FIRE FIGHT PROC:MAY CAUSE FROTHNG WHICH CAN BE VIOLENT &
    POSS ENDANGER LIFE OF FIREFIGHTER,ESP IF SPRAYED INTO (ING 3)

Name:ING 2:CONTAINERS OF HOT, BURNING LIQUID.

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO	Skin:NO  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:TOXICOLOGICAL TESTING INDICATES THAT
    SIMILAR PRODUCTS ARE NOT HAZARDOUS AS DEFINED BY OSHA. (29 CFR
    1910.1200)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:NONE SPECIFIED BY MANUFACTURER.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:SKIN:THORO WASH EXPSD AREA W/SOAP/H*20.REMOVE CONTAM
    CLTHG.LAUNDER BEFORE RE-USE.EYES:FLUSH W/LGE AMTS OF H*20 LIFTING
    UPPER/LOWER LIDS OCCASNLY,GET MD.INGEST:IMMED DRINK 2 GLASSES OF
    WATER,INDUCE VOM IT BY IPECAC SYRUP OR PLACING FINGER ATBACK OF
    THROAT.NEVER GIVE ANYTHING BY MOUTH TO UNCON PERSON,GET
    MD.INHAL:REMOVE TO FRESH AIR.IF BRTHG DFCLT GIVE O*2.IF BRTHG
    STOPPED GIVE CPR.KEEP WARM.GET MD.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:390F,199C
Lower Limits:1.1%
Extinguishing Media:REGULAR FOAM, CARBON DIOXIDE OR DRY CHEMICAL
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA WITH A FULL
    FACEPIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE PRESSURE
    MODE WHEN FIGHTING FIRES.WATER OR FOAM (SEE INGRED 2)
Unusual Fire/Explosion Hazard:NEVER USE WELDING OR CUTTING TORCH ON OR
    NEAR DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN RESIDUE) CAN IGNITE
    EXPLOSIVELY.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SMALL:ABSORB LIQ ON PAPER,VERMICULITE,FLOOR
    ABSORBENT,OR OTHER ABSORBENT MATERIAL & TRANSFER TO HOOD.LGE:PVNT
    RUN-OFF TO SEWERS,STREAMS,OTHER BODIES OF WATER.IF RUN-OFF
    OCCURS,NOTIFY PROPER AUTH.PERSO NS NOT WEARING PROT EQUIP (SEE SUPP
    DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:CONTAINERS OF THIS MATL MAY BE
    HAZARDOUS WHEN EMPTIED.SINCE EMPTIED CNTRS RETAIN PROD RESIDUES,ALL
    HAZ PRECAUTIONS MUST BE OBSERVED.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF EXPOSURE LIMIT IS EXCEEDED, USE NIOSH/MSHA
    APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
    EXHAUST)VENTILATION TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:USE NEOPRENE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES. 
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
    CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC:SHOULD BE EXCLUDED/AREA OF SPILL UNTIL CLEAN-UP
    COMPLETED.STOP SPILL AT SOURCE,DIKE AREA OF SPILL TO PVNT
    SPREADING,PUMP LIQ TO SALVAGE TANK.REMAINING LIQ MAY BE TAKEN UP ON
    SAND,CLAY,EARTH ,FLOOR ABSORB,OTHER ABSORB MATL & SHOVELED INTO
    CNTRS.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>425F,218C
Vapor Pres:<5 @ 20C
Vapor Density:>1
Spec Gravity:0.880
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON DIOXIDE, CARBON MONOXIDE,
    VARIOUS HYDROCARBONS; MAY FORM TOXIC MATERIALS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:SMALL:ALLOW VOLATILE PORTION TO EVAP IN
    HOOD.ALLOW SUFFICIENT TIME FOR VAPS TO COMPLETELY CLEAR HOOD DUCT
    WORK.DISPOSE REMAINING MATL I/A/W REGS.LGE:DESTROY BY LIQ
    INCIN.CONTAM ABSORB MAY BE DEPOSITED  IN LANDFILL I/A/W
    FEDERAL,STATE AND LOCAL REGS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***