STAR                                        EX

   MATERIALS SAFETY                                     DATA              SHEET

SECTION 1 - Product Description

Manufacturer's Name : Cheil Industries Inc.

Emergency Telephone No. : 82-662-689-1531

Address : Yeosu Plant, Chemical Division, Cheil Industries Inc.

          62, Pyeongnyeo-dong, Yeosu-si, Jeollanam-do, 555-210, Korea

Grade Name : starex Flame Retardant ABS VT-0826

Chemical Name and Synonyms : Acrylonitrile-Butadiene-Styrene(CAS No. 9003-56-9)



SECTION II - Ingredients

 ABS(Acrylonitrile-Butadiene-Styrene) : 85 � 95%

 Flame Retardant Agent : 5 ~ 15%





 Substances lised in the ingredients section are chemicals of which concentration is more

than 1 % or 0.1% if the substance is on the list of potential carcinogens cited in OSHA

Hazard Communication Standard.





SECTION III - Physical Characteristics

  Boiling Point(â„?) : Not Applicable

   Vapor Pressure(mmHg) : Not Applicable

   Vapor Density(air = 1) : Not Applicable

   Evaporation Rate(Butyl Acetate = 1) : Not Applicable

   Solubility in Water : Insoluble

   Appearance : Solid Pellet

   Specific Gravity(H2O = 1) : 1.05 � 1.15





SECTION IV - Fire And Explosion Hazard Data

  Flash Point(â„?) : Not Applicable

   Flammable Limits in Air(vol%) : Lower - Not Applicable

                                     Upper - Not Applicable

   Extinguishing Media : Water, Water Spray, CO2, Foam, Dry Chemical Powder

   Special Fire Fighting Procedure : Firefighters should be equipped with goggles and

                                 self-contained breathing apparatus to avoid smoke or gases

   Unusual Fire and Explosion Hazards : Dense smoke and Irritating Gas









                                                                                        -1-

MATERIALS SAFETY DATA SHEET (VT-0826) - CHEIL INDUSTRIES INC. -

SECTION V - Reactivity Data

  Stability : Stable under Normal Condition

   Conditions to Avoid : Spark, Open Flame

                             At temperature over 300 â„?, combustible gas may be liberated.

   Incompatibility(Materials to Avoid) : None

   Hazardous Decomposition Product : None

   Hazardous Polymerization : Will not Occur.





SECTION VI - Health Hazard Data

  Routes of Entry :

   Inhalation, Ingestion, Skin and Eye Contact of Solid or Dusts.

    - May cause irritation due to mecanical contact.

   Inhalation of Fumes or Gases Liberated from Heated Material

    - May cause irritation to respiration.

   Permissible Exposere Level : Not Assigned(Nonvolatile)

   Effects of Overexposure : Unknown

   First Aid

    Inhalation of Fumes or Gases : Remove person immediately to fresh air.

                                       Get medical attention.

    Ingestion : Rinse mouth with water. Promptly induce vomiting, and get medical attention.

    Eye Contact : Flush with water for 15 minutes.

                    Get medical attention as soon as possible.

    Skin Contact: Mechanical Injury Only





SECTION VII - Environmental And Disposal Information

  Steps to be Taken in Case Material is Released or Spilled :

    Eliminate source of ignition.

    Sweep up, and remove or reuse, if possible.

   Waste Disposal Method :

    Bury in landfill or burn in an adequate incinerator in accordance with all applicable

    federal, state and local regulations.





SECTION VIII - Certifications Of Hazardous Materials

   In this section, we certify that the grades mentioned here do not contain the following

listed materials.





     Primary Important Material List

     - Ammonium nitrate(CAS no. 6484-52-2)

     - Arsenic and its Compounds

     - Asbestos(all types)

     - Benzene(CAS no. 7440-43-9)



                                                                                            -2-

MATERIALS SAFETY DATA SHEET (VT-0826) - CHEIL INDUSTRIES INC. -

    - Beryllium and its Compounds

    - Cadmium(CAS no. 7440-43-9) and its Compounds

    - Chromium and its Compounds

    - Dioxines

    - Difuranes

    - Ethylene Glycol Ethers and their Acetates

    - Epichlorohydrine

    - Mercury and its Compounds

    - ODE : Ozone Depletion Chemical

            including CFC-11(CAS No. 75-69-7), CFC-12(CAS No. 75-71-8),

            CFC-13(CAS No. 75-72-9), CFC-114(CAS No. 1320-37-2),

            CFC-115(CAS No. 76-15-3), HALON-1211, HALON-1301, HALON-2402

    - PCBs : Polychlorinated Bisphenyls

    - PBBEs : Polybrominated Biphenyl Ethers

    - PBDEs : Polybrominated Diphenyl Ethers

    - PCTs : Polychlorinated Triphenyls

    - TBBA : Tetarbromobisphenol A (CAS No. 79-94-7)

    - Toluene

    - Vinylchloride

    - Xylene





   Secondary Important Material List

    - Cyanides

    - Formaldehyde Monomer

    - Hydrazine

    - Lead and its Compounds

    - Metal Carbonyls

    - Nitrosamine

    - Nitrosamide

    - Pentachlorophenol

    - Polyhalodibenzofuranes

    - Polycyclic Aromatic Hydrocarbons

    - Selenium and its Compounds

    - Tellurium and its Compounds

    - Thallium and its Compounds





    We hereby certify that the above statements are true and correct

  in every respect. If the statements are not true, all responsibility

  will belong to CHEIL.

                          Issued Date : Jun. 25. 1998





                                                                           -3-

MATERIALS SAFETY DATA SHEET (VT-0826) - CHEIL INDUSTRIES INC. -