MATERIAL SAFETY DATA SHEET
SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: STARRETT TOOL & INSTRUMENT OIL
PART NUMBER: 1620
GENERAL USE: Lubricant
PRODUCT DESCRIPTION: Water white to slightly yellow liquid
DATE PREPARED: December 21, 2003
MANUFACTURER'S NAME
Page 1 of 4
The L.S. Starrett Company November 2, 2002
SUPERSEDES:
ADDRESS (NUMBER, STREET, P.O. BOX) TELEPHONE NUMBER FOR INFORMATION
121 Crescent St. (978) 249-3551
EMERGENCY TELEPHONE NUMBER
COUNTRY
(CITY, STATE AND ZIP CODE)
USA CHEM 鈥? TEL (800) 255-3924 Outside USA (813) 248-0585
Athol, MA 01331
DISTRIBUTOR'S NAME
Same
TELEPHONE NUMBER FOR INFORMATION
ADDRESS (NUMBER, STREET, P.O. BOX)
EMERGENCY TELEPHONE NUMBER
COUNTRY
(CITY, STATE AND ZIP CODE)
SECTION 2 - HAZARDOUS INGREDIENTS
Hazard RISK PHRASES
%
HAZARDOUS COMPONENTS CAS # EINECS #
Symbol Full Text Section 16
(by weight)
Aliphatic hydrocarbon (white mineral oil) (a) 8042-47-5 232-455-8 Not classified
90 - 100 NC
(a) Product is not hazardous under normal conditions but could be classified as hazardous if present as oil mist in air.
SECTION 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Liquid, will support combustion. Can cause eye and skin irritation upon contact. Hazard symbols for this product - Not classified, Risk Phrases
- None
POTENTIAL HEALTH EFFECTS
INHALATION: No significant adverse health effects are expected to occur upon short-term exposure. High concentrations of mist may be
irritating to the respiratory tract.
SKIN: No significant irritation is expected to occur upon short-term exposure.; prolonged contact may cause moderate irritation.
EYES: Minimal irritation and discomfort may result from short-term contact with liquid, mist, and/or vapor.
INGESTION: Non-toxic; may cause gastric distress, vomiting and diarrhea. DO NOT induce vomiting. Aspiration of vomitus into the lungs
must be avoided; minute amounts aspirated into the lungs can produce severe lung injury or death.
CARCINOGENICITY NTP? IARC MONOGRAPHS? OSHA REGULATED?
No No No
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: STARRETT TOOL & INSTRUMENT OIL
Page 2 of 4
December 21, 2003
SECTION 4 - FIRST AID MEASURES
INHALATION: Remove affected person to fresh air; provide oxygen if breathing is difficult; if affected person is not breathing, administer CPR
and seek emergency medical attention.
SKIN: Remove contaminated clothing; wash affected area with soap and water; launder contaminated clothing before reuse; if irritation
persists, seek medical attention.
EYES: Remove contact lenses. Flush eyes with clear running water for 15 minutes while holding eyelids open; if irritation persists, seek
medical attention.
INGESTION: DO NOT induce vomiting; if vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into lungs; seek
immediate medical attention. Small amounts entering mouth should be rinsed out until taste is gone.
SECTION 5 - FIRE FIGHTING MEASURES
GENERAL HAZARDS: Product will support combustion. Products of combustion include compounds of carbon, hydrogen and oxygen,
including carbon monoxide.
EXTINGUISHING MEDIA
Carbon dioxide, water fog, dry chemical, chemical foam
FIRE FIGHTING PROCEDURES
Firefighters must wear full facepiece self - contained breathing apparatus in positive pressure mode. Do not use solid stream of water since
stream will scatter and spread fire. Fine water spray can be used to keep fire - exposed containers cool.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers can explode due to buildup of pressure when exposed to extreme heat.
HAZARDOUS COMBUSTION PRODUCTS
Smoke, fumes, oxides of carbon
SECTION 6 - ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: WILL SUPPORT COMBUSTION. Do not wash to sanitary sewer.
All spills - confine spill, soak up with approved absorbent, shovel product into approved container for disposal. Flush area with water, recover
flush for proper disposal.
SECTION 7 - HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep container closed when not in use; protect containers from abuse;
protect from extreme temperatures, open flames. This material will support combustion. Keep this and other chemicals out of reach of
children.
SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
NIOSH ACGIH
HAZARDOUS COMPONENTS
TWA ppm TWA mg/m3 STEL ppm STEL mg/m3 TWA ppm TWA mg/m3 STEL ppm STEL mg/m3
Aliphatic hydrocarbon (white mineral oil) (a) 10 10
PERSONAL PROTECTION:
RESPIRATORY PROTECTION (SPECIFY TYPE): None required while threshold limits are kept below maximum allowable concentrations; if
TWA exceeds limits, NIOSH approved respirator must be worn. Refer to 29 CFR 1910.134 or European Standard EN 149 for complete
regulations.
PROTECTIVE GLOVES: Neoprene gloves, butyl or nitrile rubber gloves with cuffs.
EYE PROTECTION: Protective eyeglasses or chemical safety goggles. Refer to 29 CFR 1910.133 or European Standard EN166.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Safety eyewash station nearby
WORK / HYGIENIC PRACTICES: Practice safe workplace habits. Minimize body contact with this, as well as all chemicals in general.
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: STARRETT TOOL & INSTRUMENT OIL
Page 3 of 4
December 21, 2003
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE AND ODOR VAPOR PRESSURE
Water white to light yellow liquid, slight characteristic odor < 0.1 mm Hg @ 20掳 C
pH SPECIFIC GRAVITY (WATER = 1)
Not applicable Not specified
BOILING POINT / BOILING RANGE SOLUBILITY IN WATER
Not specified Negligible
FLASH POINT VISCOSITY
400掳 F (204.4掳 C) Not specified
FLAMMABLE LIMITS VAPOR DENSITY (AIR = 1)
LEL: 0.7% UEL: 6.0% >1
AUTOIGNITION TEMPERATURE EVAPORATION RATE (WATER = 1)
Not determined <1
SECTION 10 - STABILITY AND REACTIVITY
STABILITY UNSTABLE: CONDITIONS TO AVOID: Extreme temperatures, open flames
STABLE: XXX
INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizers, strong acids
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: Decomposition will not occur if handled and stored properly. In case of a fire, oxides of
carbon, hydrocarbons, fumes, and smoke may be produced.
CONDITIONS TO AVOID: None
HAZARDOUS POLYMERIZATION MAY OCCUR:
WILL NOT OCCUR: XXX
SECTION 11 - TOXICOLOGICAL INFORMATION
CAS # LD50 of Ingredient LC50 of Ingredient
Hazardous Components
EINECS # (Specify Species and Route) (Specify Species)
8042-47-5 Not established Not established
Aliphatic hydrocarbon (white mineral oil) (a)
232-455-8
SECTION 12 - ECOLOGICAL INFORMATION
No data are available on the adverse effects of this material on the environment. Neither COD nor BOD data are available. Based on the
chemical composition of this product it is assumed that the mixture can be treated in an acclimatized biological waste treatment plant system in
limited quantities. However, such treatment should be evaluated and approved for each specific biological system. None of the ingredients in
this mixture are classified as a Marine Pollutant.
SECTION 13 - DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD: According to the European Waste Catalogue, waste codes are application specific and should be assigned by
the user based on the application for which the product is used.Dispose of in accordance with Local, State, and Federal Regulations. This
product may produce hazardous vapors or fumes in a closed disposal container creating a dangerous environment. Refer to "40 CFR
Protection of Environment Parts 260 - 299" for complete waste disposal regulations. Consult your local, state, or Federal Environmental
Protection Agency before disposing of any chemicals. Do not flush to sanitary sewer or waterway.
SECTION 14 - TRANSPORT INFORMATION
PROPER SHIPPING NAME: Not Regulated
DOT HAZARD CLASS / Pack Group: Not regulated IATA HAZARD CLASS / Pack Group: Not regulated
REFERENCE: Not Applicable IMDG HAZARD CLASS: Not regulated
UN / NA IDENTIFICATION NUMBER: None RID/ADR Dangerous Goods Code: Not regulated
LABEL: None Required UN TDG Class / Pack Group: Not regulated
HAZARD SYMBOLS: None
Note: Transportation information provided is for reference only. Client is urged to consult CFR 49 parts 100 - 177, IMDG, IATA, EU, United
Nations TDG, and WHMIS (Canada) TDG information manuals for detailed regulations and exceptions covering specific container sizes,
packaging materials and methods of shipping.
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: STARRETT TOOL & INSTRUMENT OIL
Page 4 of 4
December 21, 2003
SECTION 15 - REGULATORY INFORMATION
TSCA (USA - Toxic Substance Control Act)
All components of this product are listed on the U.S. Toxic Substances Control Act Chemical Inventory (TSCA Inventory) or are exempted
from listing because a Low Volume Exemption has been granted in accordance with 40 CFR 723.50.
SARA TITLE III (USA - Superfund Amendments and Reauthorization Act)
311/312 Hazard Categories
None
313 Reportable Ingredients:
None
CERCLA (USA - Comprehensive Response Compensation and Liability Act)
None
CPR (Canadian Controlled Products Regulations)
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all the
information required by the Controlled Products Regulations.
IDL (Canadian Ingredient Disclosure List)
Components of this product identified by CAS number and listed on the Canadian Ingredient Disclosure List are shown in Section 2.
DSL / NDSL (Canadian Domestic Substances List / Non-Domestic Substances List)
Components of this product identified by CAS number are listed on the DSL or NDSL and may or may not be listed in Section 2 of this
document. Only ingredients classified as "hazardous" are listed in Section 2 unless otherwise indicated.
EINECS (European Inventory of Existing Commercial Chemical Substances)
Components of this product identified by CAS numbers are on the European Inventory of Existing Commercial Chemical Substances.
WGK Water Quality Index: nwg VbK Index: Not applicable
SAFETY PHRASES:
SYMBOL(S) REQUIRED FOR
RISK PHRASES:
LABEL
None S2 Keep out of the reach of children.
S25 Avoid contact with eyes
None
SECTION 16 - OTHER INFORMATION
None
Notes & full R-Phrase text
HMIS HAZARD RATINGS HEALTH 0 = INSIGNIFICANT 3 = HIGH
0
FLAMMABILITY 1 = SLIGHT 4 = EXTREME
1
REACTIVITY 2 = MODERATE
0
PERSONAL PROTECTIVE EQUIPMENT Safety Glasses, Gloves
B
REVISION SUMMARY:
This MSDS has been revised in the following Format revision
sections:
MSDS Prepared by: Chem-Tel, Inc.
1305 N. Florida Ave.
Tampa, Florida USA 33602 (800) 255-3924 Outside USA (813) 248-0573
The information contained herein is believed to be accurate but is not warranted to be so. Data and calculations are based on information furnished by the
manufacturer of the product and manufacturers of the components of the product. Users are advised to confirm in advance of need that information is current,
applicable and suited to the circumstances of use. Vendor assumes no responsibility for injury to vendee or third persons proximately caused by the material if
reasonable safety procedures are not adhered to as stipulated in the data sheet. Furthermore, vendor assumes no responsibility for injury caused by abnormal use of
this material even if reasonable safety procedures are followed. Any questions regarding this product should be directed to the manufacturer of the product as
described in Section 1.
|