CPD® CHEMICAL FORM RELEASE AGENT

DESCRIPTION                                                     STORAGE

CPD® Chemical Form Release Agent is an economical               May be stored outside but not below -20°C (- 4°F). Store on

petroleum based, chemically reactive concrete form release      side outside so that water cannot get into the drum. Cold

                                                                weather storage will require warming to 20°C and mixing prior

agent that is V.O.C. compliant.

                                                                to use.

WHERE TO USE

Suitable for application to plywood, timber, steel, plastic     SHELF LIFE

                                                                Two years from date of manufacture in original container

faced form work and molds and rough sawn timber form

                                                                providing product has not been contaminated with water.

work where grained effect is required.



                                                                SAFETY PRECAUTION

BENEFITS

                                                                Combustible Liquid. Consult Material Safety Data Sheet

� can be applied at temperatures down to 0° C (32°F)

                                                                (M.S.D.S.) for specific instructions. MSDS # 14.

� ready-to-use (do not dilute)

� will not discolor or stain concrete

                                                                WARRANTY

� very low viscosity to facilitate application by sprayer

                                                                The recommendations made and the information herein is based

� very low odor

                                                                on our own and independent laboratory experience, and is

                                                                believed to be accurate under controlled conditions. However,

APPLICATION

                                                                no warranty or guarantee of accuracy is made because we

Forms must be clean, dry and free from cement residue

                                                                cannot cover every possible application of product nor

from previous use. Initially apply before the first casting

                                                                anticipate every variation encountered in weather conditions,

and thereafter re-apply between castings, preferably after

                                                                job-conditions, methods used and types of surfaces on which the

stripping and cleaning the form. Brush or spray on a thin

                                                                product is applied. The users shall make their own tests to

coat removing any excess. Avoid excessive build-up, runs

                                                                determine the suitability of such products for any particular

or puddles as an excess of coating may surface retard the

                                                                purpose.

concrete.



                                                                CPD® makes no warranties with respect to this product,

Note: New plywood or timber may completely absorb the

                                                                expressed or implied, without limitation, the implied warranties

first coat requiring a second application.

                                                                of merchantability or fitness for a particular purpose.

LIMITATIONS

                                                                CPD®� liability shall be limited in all events to supplying

                                                                        s

� not recommended for use in autoclaves

                                                                sufficient product to re-treat and/or repair the specific area to

� not for lift or tilt-up construction

                                                                which CPD® product has been applied. CPD® reserves the right

                                                                to have the true cause of any difficulty determined by accepted

COVERAGES

                                                                test methods. CPD® shall have no other liability, including

Wood, plywood forms...................17-24 m²/L

                                                                liability for incidental, consequential or resultant damages,

                                        700-1000 ft²/U.S. gal

                                                                however caused, whether due to breach of warranty, negligence,

Metal and plastic forms.................24-29 m²/L

                                                                or strict liability.

                                       1000-1200 ft²/U.S. gal



                                                                THIS WARRANTY MAY NOT BE MODIFIED OR

PACKAGING

                                                                EXTENDED BY REPRESENTATIVES OF CPD®, ITS

208L drums (55 U.S. gal) - 194 kg/drum (428 lbs.)

                                                                DISTRIBUTORS OR DEALERS.

18.9L pails (5 U.S. gal) - 18 kg/pail (40 lbs.)



CLEAN UP

Clean spray equipment, brushes, etc. with mineral spirits.



                                                                                                                 0310-01-1105