Page 1/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
* 1 Identification of substance
Trade name: MG-132 Inhibitor
Article number: G932
Application of the substance / the preparation Laboratory chemicals
Manufacturer/Supplier:
Promega Corporation
2800 Woods Hollow Road
Madison, WI 53711
U.S.A.
1-800-356-9526 or (608)-274-4330
MSDS author: Regulatory.Affairs@promega.com
Emergency information:
CHEMTREC 1-800-424-9300
for call originating outside the United States dial 001-703-527-3887
2 Composition/Data on components
Chemical characterization
Description: Mixture of the substances listed below with nonhazardous additions.
Dangerous components:
67-68-5 dimethyl sulfoxide 75-100%
Additional information: For the wording of the listed risk phrases refer to section 15.
* 3 Hazards identification
Hazard description:
Xn Harmful
Information pertaining to particular dangers for man and environment:
Harmful if swallowed.
Irritating to eyes and skin.
Warning - contains substance not yet fully tested
Classification system:
The classification was made according to the latest editions of international substances lists, and is expanded
upon by company and technical literature data.
NFPA ratings (scale 0 - 4)
Health = 2
Fire = 1
Reactivity = 0
(Contd. on page 2)
USA
DR
Page 2/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
Trade name: MG-132 Inhibitor
(Contd. of page 1)
HMIS-ratings (scale 0 - 4)
Health = 2
Fire =1
Reactivity = 0
OSHA Hazard Overview (Criteria according to 29CFR1910.1200):
Toxic
Irritant
Primary route(s) of entry:
Dermal
Oral
Target Organ(s):
Dermal hazard (Cutaneous hazard)
Risk of damage to eyes
4 First aid measures
General information:
Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours
after the accident.
After inhalation: In case of unconsciousness place patient stably in side position for transportation.
After skin contact: Immediately wash with water and soap and rinse thoroughly.
After eye contact:
Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
After swallowing: Immediately call a doctor.
5 Fire fighting measures
Suitable extinguishing agents:
CO2, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
6 Accidental release measures
Person-related safety precautions: Not required.
Measures for environmental protection: Do not allow to enter sewers/ surface or ground water.
Measures for cleaning/collecting:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
7 Handling and storage
Handling:
Information for safe handling:
Keep receptacles tightly sealed.
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
No special precautions are necessary if used correctly.
Information about protection against explosions and fires: No special measures required.
Storage:
Requirements to be met by storerooms and receptacles: No special requirements.
(Contd. on page 3)
USA
DR
Page 3/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
Trade name: MG-132 Inhibitor
(Contd. of page 2)
Information about storage in one common storage facility: Not required.
Further information about storage conditions: Keep receptacle tightly sealed.
8 Exposure controls and personal protection
Components with limit values that require monitoring at the workplace:
67-68-5 dimethyl sulfoxide
WEEL 250 ppm
Additional information: The lists that were valid during the creation were used as basis.
Personal protective equipment:
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Breathing equipment:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use
respiratory protective device that is independent of circulating air.
Protection of hands:
Protective gloves
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance
of the glove material can not be calculated in advance and has therefore to be checked prior to the application.
Eye protection: Tightly sealed goggles
* 9 Physical and chemical properties
General Information
Fluid
Form:
Colorless
Color:
Characteristic
Odor:
Change in condition
Melting point/Melting range: Undetermined.
Boiling point/Boiling range: 189掳C (372掳F)
> 55掳C (> 131掳F)
Flash point:
270掳C (518掳F)
Ignition temperature:
Product is not selfigniting.
Auto igniting:
Product does not present an explosion hazard.
Danger of explosion:
Explosion limits:
1.8 Vol %
Lower:
Vapor pressure at 20掳C (68掳F): 2.5 hPa (2 mm Hg)
1.122 g/cm鲁
Density at 20掳C (68掳F):
(Contd. on page 4)
USA
DR
Page 4/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
Trade name: MG-132 Inhibitor
(Contd. of page 3)
Solubility in / Miscibility with
Not miscible or difficult to mix.
Water:
Solvent content:
90.5 %
Organic solvents:
90.5 %
VOC content:
9.5 %
Solids content:
10 Stability and reactivity
Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
Dangerous reactions No dangerous reactions known.
Dangerous products of decomposition: No dangerous decomposition products known.
11 Toxicological information
Acute toxicity:
LD/LC50 values that are relevant for classification:
67-68-5 dimethyl sulfoxide
Oral LD50 14500 mg/kg (Rat)
Irritation of eyes acute 500 mg (Rabbit)
mild irritation
Primary irritant effect:
on the skin: Irritant to skin and mucous membranes.
on the eye: Irritating effect.
Sensitization: No sensitizing effects known.
Additional toxicological information:
The product shows the following dangers according to internally approved calculation methods for preparations:
Harmful
Irritant
12 Ecological information
General notes:
Water hazard class 1 (Self-assessment): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
13 Disposal considerations
Product:
Recommendation:
Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
(Contd. on page 5)
USA
DR
Page 5/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
Trade name: MG-132 Inhibitor
(Contd. of page 4)
Uncleaned packagings:
Recommendation: Disposal must be made according to official regulations.
* 14 Transport information
Contact Promega Safety Department for additional transportation information
DOT regulations:
Not regulated
-
Hazard class:
Land transport ADR/RID (cross-border):
ADR/RID class: -
Maritime transport IMDG:
-
IMDG Class:
Marine pollutant: No
Air transport ICAO-TI and IATA-DGR:
ICAO/IATA Class: -
* 15 Regulations
Sara
Section 355 (extremely hazardous substances):
None of the ingredients are listed.
Section 313 (Specific toxic chemical listings):
None of the ingredients are listed.
TSCA (Toxic Substances Control Act):
67-68-5 dimethyl sulfoxide
Proposition 65
Chemicals known to cause cancer:
None of the ingredients are listed.
Chemicals known to cause reproductive toxicity for females:
None of the ingredients are listed.
Chemicals known to cause reproductive toxicity for males:
None of the ingredients are listed.
Chemicals known to cause developmental toxicity:
None of the ingredients are listed.
Cancerogenity categories
EPA (Environmental Protection Agency)
None of the ingredients are listed.
IARC (International Agency for Research on Cancer)
None of the ingredients are listed.
NTP (National Toxicology Program)
None of the ingredients are listed.
(Contd. on page 6)
USA
DR
Page 6/6
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 06/20/2008 Reviewed on 06/20/2008
Trade name: MG-132 Inhibitor
(Contd. of page 5)
TLV (Threshold Limit Value established by ACGIH)
None of the ingredients are listed.
MAK (German Maximum Workplace Concentration)
None of the ingredients are listed.
NIOSH-Ca (National Institute for Occupational Safety and Health)
None of the ingredients are listed.
OSHA-Ca (Occupational Safety & Health Administration)
None of the ingredients are listed.
Product related hazard informations:
The product has been classified and marked in accordance with directives on hazardous materials.
Hazard symbols:
Xn Harmful
Hazard-determining components of labelling:
dimethyl sulfoxide
Risk phrases:
Harmful if swallowed.
Irritating to eyes and skin.
Safety phrases:
Do not breathe gas/fumes/vapour/spray (appropriate wording to be specified by the manufacturer).
Avoid contact with eyes.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Wear suitable protective clothing and gloves.
This material and its container must be disposed of as hazardous waste.
Special labeling of certain preparations:
Warning - contains substance not yet fully tested
National regulations:
Water hazard class: Water hazard class 1 (Self-assessment): slightly hazardous for water.
* 16 Other information
This information is based on our present knowledge. However, this shall not constitute a guarantee for any
specific product features and shall not establish a legally valid contractual relationship.
Department issuing MSDS:
Promega Corporation
Environmental Health and Safety Department
2800 Woods Hollow Road
Madison, WI
Ph:(608)274-4330
* Data compared to the previous version altered.
USA
DR
|