n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
1 PRODUCT AND COMPANY IDENTIFICATION
EMERGENCY PHONE NUMBERS:
Thio and Fine Chemicals
Chemtrec: (800) 424-9300 (24hrs) or (703) 527-3887
Arkema Inc.
Medical: Rocky Mountain Poison Control Center
2000 Market Street
(866) 767-5089 (24Hrs)
Philadelphia, PA 19103
Information Telephone Numbers Phone Number Available Hrs
Customer Service 1-800-628-4453 8:30 to 5:30 EST
Product Name n-PROPYL MERCAPTAN
Product Synonym(s)
Chemical Family Alkyl Mercaptan
Chemical Formula C3H8S
Chemical Name 1-Propanethiol
EPA Reg Num
Product Use Chemical intermediate
2 COMPOSITION / INFORMATION ON INGREDIENTS
Ingredient Name CAS RegistryNumber Typical Wt. % OSHA
n-Propylmercaptan 107-03-9 100% Y
The substance(s) marked with a "Y" in the OSHA column, are identified as hazardous chemicals according to the
criteria of the OSHA Hazard Communication Standard (29 CFR 1910.1200)
This material is classified as hazardous under Federal OSHA regulation.
The components of this product are all on the TSCA Inventory list.
3 HAZARDS IDENTIFICATION
Emergency Overview
Water white liquid, with gassy odor
DANGER!
EXTREMELY FLAMMABLE LIQUID AND VAPOR. VAPOR MAY CAUSE FLASH FIRE.
CAUSES EYE AND SKIN IRRITATION.
MAY BE HARMFUL IF SWALLOWED.
MAY CAUSE RESPIRATORY TRACT IRRITATION.
MAY CAUSE NAUSEA, HEADACHE OR DIZZINESS.
Potential Health Effects
Inhalation and skin contact are expected to be the primary routes of occupational exposure to this material. Based on
single exposure animal tests, it is considered to be slightly toxic if swallowed, no more than slightly toxic if absorbed
through skin, practically non-toxic if inhaled and severely irritating to eyes. Direct contact with liquid or vapor can cause
skin irritation. This material has a strong objectionable odor that may cause nausea, headache or dizziness. Inhalation
of vapor is irritating to the respiratory tract and, with extreme overexposure, may cause a sense of coldness at the
extremities, rapid heartbeat, cyanosis and respiratory paralysis.
Product Code: 001478 Page 1
Revision: 7 Issued: 11 OCT 2004 of 6
n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
4 FIRST AID MEASURES
IF IN EYES, immediately flush with plenty of water for at least 15 minutes. Get medical attention.
IF ON SKIN, immediately flush with plenty of water. Remove contaminated clothing and shoes. Get medical
attention. Wash clothing before reuse. Thoroughly clean shoes before reuse.
IF SWALLOWED, do NOT induce vomiting. Give water to drink. Get medical attention immediately. NEVER
GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.
IF INHALED, remove to fresh air. If breathing is difficult, get medical attention.
5 FIRE FIGHTING MEASURES
Fire and Explosive Properties
Auto-Ignition Temperature NE
Flash Point <0F Flash Point Method TCC
Flammable Limits- Upper NE
NE
Lower
Extinguishing Media
Use water spray, carbon dioxide, foam or dry chemical.
Fire Fighting Instructions
Water may be ineffective. Use water spray or water fog to cool surrounding surfaces and prevent fire damage
or rupture of containers. Fire fighters and others who may be exposed to products of combustion should wear
full fire fighting gear (full Bunker Gear) and self-contained breathing apparatus (pressure demand NIOSH
approved or equivalent). Fire fighting equipment should be thoroughly decontaminated after use.
Fire and Explosion Hazards
When burned, the following hazardous products of combustion can occur:
Oxides of carbon
Hydrogen sulfide
Sulfur oxides
Vapors can travel to a source of ignition and flash back.
6 ACCIDENTAL RELEASE MEASURES
In Case of Spill or Leak
Extinguish or turn off ignition or combustion sources. Contain spill. Stop leak at source if this can be done
safely. Ventilate area only if odor control is not an issue. Nonessential personnel should leave the area until
cleanup is completed. Cover spill area with closed-cell foam to reduce odors (use of Aqueous Film Forming
Foam (AFFF) with polymeric layer is acceptable). If foam is unavailable, absorb spill with liquid-binding
material (e.g. diatomaceous earth, saw dust universal binder) and deodorize residue on ground with 3-10%
hydrogen peroxide. If spill is contained within a large containment area, add 5% bleach solution (sodium
hypochlorite) in a 50 parts bleach solution to one part product dilution ratio. Swimming pool chemicals
(hypochlorite compounds) work effectively in deodorizing product. If these are applied to product, the crystals
must be accompanied by sufficient water of dilution so that the considerable heat of reaction will be
absorbed. Enzyme or bacteria based deodorizers are also acceptable for use. Place waste materials into
Department of Transportation (DOT)-approved drums for disposal. Where practicable wash area down with
water. Keep concentrate and wash water from entering sewers or waterways. Consult a regulatory specialist
Product Code: 001478 Page 2
Revision: 7 Issued: 11 OCT 2004 of 6
n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
6 ACCIDENTAL RELEASE MEASURES
to determine appropriate state or local reporting requirements, for assistance in waste characterization and/or
hazardous waste disposal and other requirements listed in pertinent environmental permits.
7 HANDLING AND STORAGE
Handling
Keep away from heat, sparks and flame.
Keep container closed.
Use only with adequate ventilation.
Avoid contact with eyes, skin and clothing.
Do not taste or swallow.
Wash thoroughly after handling.
CONTAINER HAZARDOUS WHEN EMPTY. Emptied container retains vapor and product residue. Follow
labeled warnings even after container is emptied. RESIDUAL VAPORS MAY EXPLODE ON IGNITION. DO
NOT CUT, DRILL GRIND OR WELD ON OR NEAR THIS CONTAINER. Improper disposal or reuse of this
container may be dangerous and/or illegal.
Storage
Store in well ventilated area away from heat and sources of ignition such as flame, sparks and static
electricity. Ensure that all storage and handling equipment is properly rated, grounded and installed to satisfy
electrical classification requirements. Static electricity may accumulate and create a fire hazard. All storage
containers, including containers such as drums, cylinders and IBC鈥檚, must be bonded and grounded during
filling and emptying operations. Store away from oxidizers and reactive materials. Keep container tightly
closed. Observe all federal, state and local regulations and National Fire Protection Association (NFPA)
Codes which pertain to the specific local conditions of storage and use, including OSHA 29 CFR 1910.106
and NFPA 30, 70, 77, and 497.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls
Investigate engineering techniques to reduce exposures. Provide ventilation if necessary to minimize
exposure. Dilution ventilation is acceptable, but local mechanical exhaust ventilation preferred, if practical, at
sources of air contamination such as open process equipment. Consult ACGIH ventilation manual or NFPA
Standard 91 for design of exhaust systems.
Eye / Face Protection
Where there is potential for eye contact, wear chemical goggles and have eye flushing equipment
immediately available.
Skin Protection
Wear appropriate chemical resistant protective clothing and chemical resistant gloves to prevent skin
contact. Consult glove manufacturer to determine appropriate type glove material for given application.
Wear chemical goggles, a face shield, and chemical resistant clothing such as a rubber apron when
splashing may occur. Rinse immediately if skin is contaminated. Remove contaminated clothing promptly
and wash before reuse. Clean protective equipment before reuse. Provide a safety shower at any location
where skin contact can occur. Wash skin thoroughly after handling.
Product Code: 001478 Page 3
Revision: 7 Issued: 11 OCT 2004 of 6
n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Respiratory Protection
Avoid breathing vapor or mist. Where airborne exposure is likely, use NIOSH approved respiratory
protection equipment appropriate to the material and/or its components. Full facepiece equipment is
recommended and, if used, replaces need for face shield and/or chemical goggles. If exposures cannot be
kept at a minimum with engineering controls, consult respirator manufacturer to determine appropriate type
equipment for given application. Observe respirator use limitations specified by NIOSH or the manufacturer.
For emergency and other conditions where there may be a potential for significant exposure, use an
approved full face positive-pressure, self-contained breathing apparatus or positive-pressure airline with
auxiliary self-contained air supply. Respiratory protection programs must comply with 29 CFR 搂 1910.134.
Airborne Exposure Guidelines for Ingredients
The components of this product have no established Airborne Exposure Guidelines
-Only those components with exposure limits are printed in this section.
-Skin contact limits designated with a "Y" above have skin contact effect. Air sampling alone is insufficient to accurately quantitate
exposure. Measures to prevent significant cutaneous absorption may be required.
-ACGIH Sensitizer designator with a value of "Y" above means that exposure to this material may cause allergic reactions.
-WEEL-AIHA Sensitizer designator with a value of "Y" above means that exposure to this material may cause allergic skin reactions.
9 PHYSICAL AND CHEMICAL PROPERTIES
Water white liquid, with gassy odor
Appearance/Odor
pH NE
Specific Gravity 0.847 @ 15.5 C
Vapor Pressure 122 mmHg
Vapor Density 2.54
Melting Point NA
Freezing Point -113 C
Boiling Point 66.2 - 69.4 C (151-157 F)
Solubility In Water Slightly soluble @ 20 C
Solubility in Other Materials Alcohols, ethyl ether
Evaporation Rate NE
Percent Volatile 100
Molecular Weight 76.15
n-Octanol/Water Partition Coefficient log Pow = 1.7
Other Physical Data Olfactory threshold: 1.6 ppb
Refractive index: 1.438 @ 20 C
Henry鈥檚 contant: 0.00461 atm m3/mole
10 STABILITY AND REACTIVITY
Stability
This material is chemically stable under normal and anticipated storage and handling conditions.
Incompatibility
Avoid contact with strong oxidizers, acids, bases, reducing agents.
Hazardous Decomposition Products
None known.
Product Code: 001478 Page 4
Revision: 7 Issued: 11 OCT 2004 of 6
n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
11 TOXICOLOGICAL INFORMATION
Toxicological Information
Data on this material and/or its components are summarized below.
Single exposure (acute) studies indicate:
Oral - Slightly Toxic to Rats (LD50 1,790 mg/kg)
Dermal - No More Than Slightly Toxic to Rabbits (LD50 >2,000 mg/kg)
Inhalation - Practically Non-toxic to Rats (4-hr LC50 22.7-25.4 mg/l)
Eye Irritation - Severely Irritating to Rabbits
Skin Irritation - Non-Irritating to Rabbits (4-hr exposure)
Acute poisoning produced a pattern of central nervous system depression and respiratory paralysis in rodents
with death resulting from respiratory failure.
12 ECOLOGICAL INFORMATION
Ecotoxicological Information
This material is highly toxic to Daphnia magna (48-hr EC50 <0.22 mg/l).
Chemical Fate Information
Degradation of 94% required 14 days.
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Incineration is the recommended method for disposal observing all local, state and federal regulations. Note:
Chemical additions to, processing of, or otherwise altering this material may make this waste management
information incomplete, inaccurate, or otherwise inappropriate. Furthermore, state and local waste disposal
requirements may be more restrictive or otherwise different from federal laws and regulations.
14 TRANSPORT INFORMATION
DOT Name Propanethiols
DOT Technical Name (n-Propyl Mercaptan)
DOT Hazard Class 3
UN Number 2402
DOT Packing Group PG ll
RQ No
DOT Special Information Primary Hazard - FLAMMABLE
15 REGULATORY INFORMATION
Hazard Categories Under Criteria of SARA Title III Rules (40 CFR Part 370)
Immediate (Acute) Health Y Fire Y
Reactive N
Delayed (Chronic) Health N
Sudden Release of Pressure N
The components of this product are all on the TSCA Inventory list.
Product Code: 001478 Page 5
Revision: 7 Issued: 11 OCT 2004 of 6
n-PROPYL MERCAPTAN
Material Safety Data Sheet
Arkema Inc.
Ingredient Related Regulatory Information:
CERCLA RQ SARA TPQ
SARA Reportable Quantities
n-Propylmercaptan NE
Massachusetts Right to Know
This product does contain the following chemicals(s), as indicated below, currently on the Massachusetts Right to Know Substance
List.
n-Propylmercaptan
New Jersey Right to Know
This product does contain the following chemical(s), as indicated below, currently on the New Jersey Right-to-Know Substances List.
n-Propylmercaptan
16 OTHER INFORMATION
Revision Information
Revision Number 7
11 OCT 2004
Revision Date
Supercedes Revision Dated 19-AUG-2004
Revision Summary
ATOFINA Chemicals, Inc. has changed its name to Arkema Inc.
Key
NE= Not Established NA= Not Applicable (R) = Registered Trademark
Arkema Inc. believes that the information and recommendations contained herein (including data and
statements) are accurate as of the date hereof. NO WARRANTY OF FITNESS FOR ANY PARTICULAR
PURPOSE, WARRANTY OF MERCHANTABILITY, OR ANY OTHER WARRANTY, EXPRESSED OR
IMPLIED, IS MADE CONCERNING THE INFORMATION PROVIDED HEREIN. The information provided
herein relates only to the specific product designated and may not be valid where such product is used in
combination with any other materials or in any process. Further, since the conditions and methods of use are
beyond the control of Arkema Inc., Arkema Inc. expressly disclaims any and all liability as to any results
obtained or arising from any use of the product or reliance on such information.
Product Code: 001478 Page 6
Revision: 7 Issued: 11 OCT 2004 of 6
|