Material Safety Data Sheet The Soap Plant SECTION: 6 PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be taken if material is released or spilled: Clean up spills promptly. Surfaces can be slippery.
SECTION: 1 SUPPLIERINFORMATION
Treat as an oil spill. for small spills, absorb on inter material (clay, sand, dirt, ect.). For large spill,
contain with absorbent material and contact a disposal company. In all cases, package in a Transport
Common Name: STAINLESS POLISH
PA approved container. Observe recommended control measures.
Product Use: Polish for stainless steel
Waste disposal: Dispose of waste according to federal, state, and local regulations.
Manufacturer: The Soap Plant
Special handling procedures and equipment: Not required.
Address: P.O. Box 8512
Specific storage reqyirements: Keep container closed when not in use. Store in a cool and dry location
New Castle, PA 16107
away from oxidizing and reducing agents. Keep away from heat, sparks and sources of ignition.
Emergency Phone: 800-255-3924
Shipping information: N/A
Date Prepared: 05-01-07
SECTION: 7 CONTROL MEASURES
Respiratory Protection: N\A
SECTION: 2 HAZARDOUS INGREDIENTS Ventilation: Adequate ventilation to reduce mist below permissible
exposure limits recommended. Handilng area may require
CHEMICAL IDENTITY OSHA/PEL ACGIH/TLV CAS. NO.
mechanical ventilation.
Mineral Oil 5 mg/m3 5 mg/m3 8012-95-1
Protective Gloves: Neoprene type
Goggles: Yes
Other protective clothing or equipment: N\A
Note: N/E = Not established
SECTION: 8 PHYSICAL ANDCHEMICAL PROPERTIES
SECTION: 3 HAZARDS IDENTIFICATION
Appearance - Odor: Yellow color \ fruity odor.
Physical State: Liquid
Routes of entry: Eyes, Skin, Ingestion, Inhalation
pH: N/A
Health Hazards: N.A.
Vapor Density (air=1): N/A
Boiling Point: 510*F
Chemical listed as carcinogen: NO
Freezing/Melting Point: N/A
Or potential carcinogen: NO
Specific Gravity (Water =1): 0.850
National Toxicology Program: NO
Solubility in water: Negligible
I.A.R.C. MONOGRAPHS: NO
OSHA: NO
SECTION: 9 STABILITYAND REACTIVITY
Signs and symptoms of exposure: Eye irritation and may defat and dry the skin. Stability: Stable under nomal conditions.
Medical conditions generally aggravated by exposure: Dermatitis, irritation to eyes, throat and nose. Incompatability substances: Avoid strong oxidizing.
Hazardous decomposition: None known.
Hazardous polymerization: Will not occur.
SECTION: 4 EMERGENCYAND FIRSTAID PROCEDURES
Conditions of reactivity: Avoid contamination with reactive substances.
EYES: Flood with water for 15 minutes. If irritation persists, call
physician.
SECTION: 10 HAZARD RATING
SKIN: Wash off with soap and water. If irritation persists, call
HEALTH 1 4 = EXTREME
physician.
FIRE 2 3 = HIGH
INGESTION: Call physician immediately.(Vomiting may cause asperation
REACTIVITY 0 2 = MODERATE
into lungs resaulting in chemical pneumonia.
PERSONAL PROTECTION B* 1 = SLIGHT
INHALATION: Remove to fresh air.
0 = INSIGNIFICANT
B* = Gloves and goggles.
SECTION: 5 FIREFIGHTINGMEASURES
Flash Point and Method: >275* F (COC)
NOTICE: This product has been classified in accordance with the hazard criteria of the CFR and the
Hazardous combustion products: Carbon monoxide & Carbon dioxide from burning.
MSDS contains all the information required by the CFR.
Conditions of Flammability: Requires source of ignition, presence of air, and temperature
greater than the flash point
DISCLAIMER: The information herein is given in good faith, but no warranty , either expressed or
Means of extinction: Use foam, carbon dioxide, "dry chemical"(NaHCO 3). Water
implied is made. Final determination of the suitability of any material is the sole responsibility of the
may actually spread the fire by floating burning material.
user. All materials may present unknown hazards and should be used with caution. Although certain
Unusual fire and explosion hazards: None
hazards are described herein we cannot be sure or gurantee these are the only hazards which exist.
Flammable limits (% in air ): LOWER: N\A UPPER: N\A
|