Updated June 15, 2007
ULTRAMARI NE PI NK
Material Safety Data Sheet ( MSDS)
Eye Contact : Dust may cause mechanical irritation.
1. PRODUCT I DENTI FI CATI ON
Skin Contact: Not a primary skin irritant, but repeated or
Product Name: ultramarine pink prolonged exposure may cause skin irritation.
I NCI Name: ultramarines I ngestion: May cause irritations to the gastrointestinal tract.
CAS Number: 1345-00-2
EI NECS Number: 215-711-3 8. FI RST AI D MEASURES
Origin: natural, modified
Eyes: Irrigate eyes with a heavy stream of water for at least 15 to
20 minutes. If irritation persists get medical attention.
Skin: Wash exposed areas of the body with soap and water.
I nhalation: Remove from area of exposure. If breathing is
2. PHYSI CAL & CHEMI CAL PROPERTI ES
difficult, give oxygen. Seek medical attention if symptoms persist.
> 500oC
Melting Point: I ngestion: If large quantities are ingested, get medical advice.
Boiling Point: not applicable Give water to drink to dilute ingested materials.
Freezing Point: not applicable
9. FI RE FI GHTI NG MEASURES
Bulk Density: 3.6-4.6
Vapor Pressure: not applicable
Flash Point: not applicable, material not flammable
Solubility in w ater: insoluble
Explosion Hazard: none
Volatile by Vol.: 0%
Extinguishing Media: None does not burn. Use extinguishing
Evaporation Rate: 0 (Buac= 1)
media appropriate for surrounding.
pH Value: not determined
Fire Fighting Procedures: Firefighters should wear full fire-
Appearance & Odor: pink powder, no odor
fighting turn-out gear (full Bunker gear) including NIOSH-approved
3. STABI LI TY & REACTI VI TY self-contained breathing apparatus with full facepiece operated in
the pressure demand or other positive pressure mode.
Chemical Stability: stable under normal conditions
I ncompatibility: strong acids and oxidizying agents 10. TOXI COLOGI CAL I NFORMATI ON
Hazardous Decomposition Products: none known
Acute Toxicity: LD50 > 15 g/ kg (oral, rats)
Hazardous Polymerisation: will not occur
Sensitization: not a sensitizing agent
Carcinogenicity: no data available
4. HANDLI NG & STORAGE
Avoid breathing dust. Wash thoroughly after handling. Avoid 11. DI SPOSAL CONSI DERATI ONS
contact with eyes. As with all chemicals, good industrial hygiene
Storage and disposal must be in accordance with applicable local,
practices should be followed when handling this material. Avoid
state & federal disposal regulations. Characterization and com-
freezing or excessive heat. Do not handle or store near an open
pliance with applicable laws are the responsibility solely of the
flame, heat or other sources of ignition. Keep the container tightly
generator.
closed and in a cool, well-ventilated place.
12. TRANSPORT I NFORMATI ON
5. ACCI DENTAL RELEASE MEASURES
General: not regarded as hazardous material
Isolate spill area immediately. Keep unauthorized personnel away.
DOT Shipping Name: Refer to corresponding hazard class
Ventilate closed spaces before entering. Do not touch or walk
ADR/ RI C Code: Refer to corresponding hazard class
through spilled material. Prevent entry into waterways, sewers,
Sea Transport I MDG Code: Refer to corresponding hazard class
basements or confined areas. Surface may become slippery after
Air Transport I ATA: Refer to corresponding hazard class
spillage. Use vacuum or broom sweeping and remove to disposal
container.
13. DI SCLAI MER
6. EXPOSURE CONTROLS & PERSONAL PROTECTI ON This information relates only to the specific material designated and
may not be valid for such material used in combination with any
Respiratory Protection: Where exposure likely exceeds accep-
other materials or in any other process. Such information is to be
table criteria, use NIOSH/ OSHA-approved respiratory equipment.
the best of the company s knowledge and believed accurate and
Protective Clothing: Gloves, safety glasses, or face shield
reliable as of the date indicated. However, no representation,
recommended. Local exhaust ventilation recommended.
warranty or guarantee of any kind, express or implied, is made as
Exposure Cont rols of Respirable Dust: OSHA: 15 mg/ m3 PEL;
to its accuracy, reliability or completeness and we assume no
ACGIH TLV: 10 mg/ m3 TLV
responsibility for any loss, damage or expense, direct or
7. HAZARDS I DENTI FI CATI ON consequential, arising out of use. It is the user s responsibility to
satisfy himself as to the suitableness & completeness of such
I nhalation: Acute inhalation of dust may cause mechanical
information for his own particular use.
irritation to the respiratory tract.
ALL DATA HEREIN ARE ALL AS PER OUR SUPPLIER.
|