Page 1 of 2
MATERIAL SAFETY DATA SHEET
Manufacturer's Name: Transportation Emergencies: NPCA HAZARDOUS MATERIALS IDENTIFICATION SYSTEM
RATING IDENTIFICATION
Call Chemtrec 4 = EXTREME HEALTH 3
3 = HIGH FLAMMABILITY 4
1-800-424-9300
Masterchem庐 Industries, Inc. 2 = MODERATE REACTIVITY 0
Emergency Telephone No. 1 = SLIGHT CHRONIC HEALTH See Section V
3135 Old Highway M 0 = MINIMAL
1-800-325-3552
Imperial, MO 6305
Company Code: MTER
Issue Date: April 7, 2003
SECTION I - PRODUCT IDENTIFICATION
Kilz庐 Upshot庐 Aerosol
PRODUCT NAME:
PRODUCT NUMBER: 51652-10007-5
PRODUCT CLASS: Aerosol Spray Primer
SECTION II A-HAZARDOUS INGREDIENTS
CAS REGISTRY %W CHEMICAL NAME(S) OCCUPATIONAL VAPOR PRESSURE LISTED AS A
NO. EXPOSURE LIMITS CARCINOGEN
TLV PEL
64742-89-8 VM & P Naphtha (Aliphatic 300 ppm 300 ppm No
17.60 15 mm Hg @ 37.7掳 C
Hydrocarbon)
68476-86-8 24.00 Propellant (Propane /Butane/ Isobutane 990 ppm 900 ppm 70 PSIG @ 25掳 C No
Blend)
67-64-1 15.50 Acetone 750 ppm 750 ppm 231 mm Hg @ 25掳 C No
108-03-2 2.40 1-Nitropropane 25 ppm 25 ppm No
7.5 mm Hg @ 25掳 C
SECTION II B 鈥? OTHER INGREDIENTS
- - -
71243-64-6 10-25 Alkyd Resin No
- - -
13463-67-7 10-25 Titanium Dioxide No
SECTION III - PHYSICAL DATA
APPEARANCE: Off White, Aerosol Spray ODOR: Mild, Sweet Ketone
VAPOR DENSITY: 鈱? HEAVIER
BOILING RANGE: Minus 43.7掳 F to plus 160掳 LIGHTER THAN AIR
EVAPORATION RATE: 鈱? FASTER 82.27% VOLATILE VOLUME: 7.59 POUNDS WT/GAL
SLOWER THAN BUTYL ACETATE
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLAMMABILITY CLASSIFICATION: OSHA 1A FLASH POINT: Minus 156掳 F FTCC LEL: 1.8 DOT: Consumer Commodity; ORM-D
EXTINGUISHING MEDIA:
鈱? 鈱? 鈱?
DRY CHEMICAL ALCOHOL FOAM WATER FOG FOAM CO2 OTHER
UNUSUAL FIRE AND EXPLOSION HAZARDS: Explosive air/vapor mixtures may form when exposed to heat. Vapors are heavier than air and
may travel along the ground and be ignited by open flame, sparks, static discharge or by other sources of ignition. Containers may burst when exposed to
extreme heat. Over exposure to combustion products may cause a health hazard. Obtain medical attention.
SPECIAL FIREFIGHTING PROCEDURES: Full protective equipment, including self-contained breathing apparatus, should be used to protect
firefighters from any hazardous combustion products.
SECTION V - HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE: Inhalation: Irritation of the respiratory tract or acute nervous system depression characterized by the following
progressive steps; headache, dizziness, staggering gait, confusion, unconsciousness, or coma. Skin or eye contact: Primary irritant.
MEDICAL CONDITIONS PRONE TO AGGRAVATION BY EXPOSURE: Reports have associated repeated and prolonged occupation
overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents
may be harmful or fatal.
Kilz Upshot Aerosol
Page 2 of 2
PRIMARY ROUTE(S) OF ENTRY:
DERMAL 鈱? INHALATION 鈱? INGESTION 鈱?
EMERGENCY AND FIRST AID PROCEDURES: Inhalation: Remove to fresh air. Restore breathing. Treat symptomatically. Consult a physician.
Splash (eyes): Flush immediately with large amounts of water for at least 15 minutes. Take to physician for medical treatment. Splash (skin); Wash
affected areas with soap and water. Remove contaminated clothing. Consult a physician if irritation persists. Ingestion: Drink 1 or 2 glasses of water to
dilute. Do not induce vomiting. Consult physician or poison control center immediately. Treat symptomatically.
SECTION VI - REACTIVITY DATA
STABLE 鈱?
STABILITY: UNSTABLE
WILL NOT OCCUR 鈱?
HAZARDOUS POLYMERIZATION: MAY OCCUR
HAZARDOUS DECOMPOSITION PRODUCTS: May produce fumes when heated to decomposition, as in welding or fire. Fumes may contain:
carbon monoxide, carbon dioxide, hydrocarbons and other products of combustion.
CONDITIONS TO AVOID: High temperatures or high humidities. Heat, sparks or open flame.
INCOMPATIBILITY: (MATERIALS TO AVOID) Peroxides or strong oxidizing agents.
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Limit spread of spill or leak. Remove all sources of ignition. Soak
up with inert absorbent material. Use non-sparking tools when removing wet absorbent. See Section VIII for required protective measures. Keep
material out of sewers and/or drains.
WASTE DISPOSAL METHOD: Dispose of in accordance with all local, state and federal regulations. Dry primer and empty containers may be
landfilled. Full or partially full containers should be treated as hazardous waste which requires disposal at an approved hazardous waste site or
incinerator.
SECTION VIII-SAFE HANDLING AND USE INFORMATION
RESPIRATORY PROTECTION: If you experience eye watering, headaches or dizziness, increase fresh air or wear respiratory protection
(NIOSH/MSHA TC 23C or Equivalent) or leave the area.
VENTILATION:Open doors and windows to provide ventilation of sufficient volume and pattern to keep air contaminant concentrations below
occupational exposure limits as shown in Section II A.
PROTECTIVE GLOVES: Required, rubber or neoprene to prevent skin contact.
EYE PROTECTION: Use safety eyewear including splash guards or side shields.
OTHER PROTECTIVE EQUIPMENT: Wear protective clothing. Remove and wash contaminated clothing before re-use.
HYGIENIC PRACTICES: Wash hands before eating or using the washroom. Smoke in smoking areas only.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store away from extreme heat, fire, or open flame. Store in accordance with
OSHA 1910.106. Store in well ventilated areas. Store as level 3 aerosol (NFPA 30B).
OTHER PRECAUTIONS: DO NOT TAKE INTERNALLY. Avoid breathing vapors and spray mists. Avoid contact with skin and eyes. Protect
containers from damage. Store away from any source of ignition. Do not heat, puncture or incinerate containers. Contents under pressure and may
contain explosive vapors. Do not remove or deface label. Keep out of the reach of children.
DISCLAIMER OF EXPRESSED AND IMPLIED WARRANTIES
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the
accuracy of this data or the results to be obtained from the use thereof. The product is no more hazardous than its component parts pursuant
to 29CFR 1910.1200 (D). The technical information on this MSDS sheet is based upon information submitted by manufacturers and
additional information furnished by distributor's chemical suppliers and manufacturers. Vendor assumes no responsibility for injury to
vendee or third persons proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet.
Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material
even if reasonable safety procedures are followed. Furthermore, vendee assumes the risk in his use of the material.
PREPARED BY: Mr. William R. Benton DATE PREPARED: April 7, 2003
TITLE: W.R. Benton, MSDS Coordinator SUPERSEDES: April 28, 1999 Upshot Aero
(Signature Available Upon Request)
Kilz Upshot Aerosol
|