Search   
MSDS 
:
 Succinic Anhydride
CAS 
:
 108-30-5
SYNONYMS 
:
 SAA
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 108-30-5 |Succinic Anhydride | 100.0 | 203-570-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes and respiratory system.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause irritation of the digestive tract. May be harmful if
swallowed.
Inhalation:
Causes respiratory tract irritation. May cause allergic respiratory
reaction.
Chronic:
May cause cancer according to animal studies.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid if irritation develops or persists. Wash clothing
before reuse. Flush skin with plenty of soap and water.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Minimize dust generation and accumulation. Avoid
contact with eyes, skin, and clothing. Avoid ingestion and
inhalation.
Storage:
Store in a cool, dry place. Keep container closed when not in use.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use process enclosure,
local exhaust ventilation, or other engineering controls to control
airborne levels.
Exposure Limits
CAS# 108-30-5:


Personal Protective Equipment

Eyes:
Wear safety glasses and chemical goggles if splashing
is possible.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: white
Odor: None reported.
pH: Not available.
Vapor Pressure: 1 mmHg @ 92 C
Viscosity: 3 cP 125 C
Boiling Point: 261 deg C
Freezing/Melting Point: 119.6 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: 20 g/l (20 C) (decomposes)
Specific Gravity/Density:
Molecular Formula: C4H4O3
Molecular Weight: 100.0262

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, acids, bases, alcohols, amines, moist air or
water.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 108-30-5: WN0875000
LD50/LC50:
CAS# 108-30-5: Draize test, rabbit, eye: 750 ug Severe; Oral, rat:
LD50 = 1510 mg/kg.
Carcinogenicity:
Succinic Anhydride -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37 Irritating to eyes and respiratory system.
Safety Phrases:
S 25 Avoid contact with eyes.
WGK (Water Danger/Protection)
CAS# 108-30-5: 0
Canada
CAS# 108-30-5 is listed on Canada's DSL List.
CAS# 108-30-5 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 108-30-5 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #3 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Ethyl trans-2-hydroxy-1-cyclopentanecarboxylate (>95%)
Sulfur 7704-34-9
Sulfolane 126-33-0
Succinic Anhydride 108-30-5
Styrene, stabilized with 10-15 ppm tert-butylcatechol 98-29-3
(+)-2,3-O-Isopropylidene-L-threitol, 98+% 50622-09-8
Sulfuric acid 20-55% w/v 7664-93-9
Steel Wool
Strontium Carbonate 1633-05-2
Sorbic Acid 110-44-1
Sodium thioglycollate 367-51-1
Sodium Tauroglycocholate 0-00-0
Sodium Starch Glycolate
Sodium Metasilicate 6834-92-0
Sodium Sesquicarbonate Dihydrate 6106-20-3
Tetra-Sodium Pyrophosphate Anhydrous 7722-88-5
Sodium Propionate 137-40-6
Sodium persulfate 7775-27-1
Sodium perborate tetrahydrate 10486-00-7
Sodium selenite 10102-18-8
Sodium Selenate Decahydrate 10102-23-5
Sodium Metavanadate 131718-26-8
Sodium Metaborate Tetrahydrate 15293-77-3
Sodium metasilicate pentahydrate 6834-92-0
Sodium Malonate 141-95-7
Sodium Hypophosphite 7681-53-0
Sodium Hypochlorite Solution 1310-73-2
Sodium Hydrogen Tartrate Monohydrate 526-94-3
Sodium bisulfate 7681-38-1
Sodium Hydrogen Selenite 7782-82-3
Di-Sodium Hydrogen Citrate, Sesquihydrate 6132-05-4
Sodium Sulfite Hydrated 10102-15-5
2-Chloro-4-ethylamino-6-isopropylamino-s-triazine, 98% 1912-24-9
1,5-Diphenyl-1,5-pentanedione, 99% (uv-vis) 6263-83-8
Disodium hydrogen orthophosphate dihydrate 7558-79-4
Sodium b-Glycerophosphate Hydrate 1300-25-0
Sodium Gluconate 527-07-1
N,n,n',n'-Tetramethyldiaminomethane, 99% 51-80-9
Sodium Formaldehyde Sulfoxylate 149-44-0
Sodium Fluorosilicate 16893-85-9
Sodium Fluoroborate 13755-29-8
Sodium Hexacyanoferrate (II) Decahydrate 59299-99-9
Sodium Dithionite 7775-14-6
Sodium Cacodylate 124-65-2
Sodium Bismuthate 12232-99-4
Sodium Arsenate,Hydrated 10048-95-0
Sodium Aluminate 1302-47-7
Sodium Alginate 9005-38-3
Sodamide 0-00-0
Soda lime granules 2390-59-2

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net