**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 1193-79-9 |2-Acetyl-5-methylfuran | 98% | 214-779-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN
Risk Phrases: 22
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Harmful if swallowed.The toxicological properties of this material
have not been fully investigated.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation. May be harmful if absorbed through the
skin.
Ingestion:
Harmful if swallowed. May cause irritation of the digestive tract.
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated. May be harmful if
inhaled.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
In case of contact, immediately flush eyes with plenty of water for
at least 15 minutes. Get medical aid.
Skin:
In case of contact, flush skin with plenty of water. Remove
contaminated clothing and shoes. Get medical aid if irritation
develops and persists. Wash clothing before reuse.
Ingestion:
If swallowed, do not induce vomiting unless directed to do so by
medical personnel. Never give anything by mouth to an unconscious
person. Get medical aid.
Inhalation:
If inhaled, remove to fresh air. If not breathing, give artificial
respiration. If breathing is difficult, give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Combustible liquid.
Vapors may be heavier than air. They can spread along the ground and
collect in low or confined areas. Runoff from fire control or
dilution water may cause pollution. Combustible liquid and vapor.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Use water spray,
dry chemical, carbon dioxide, or chemical foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
breathing dust, vapor, mist, or gas. Avoid contact with eyes, skin,
and clothing. Empty containers retain product residue, (liquid and/or
vapor), and can be dangerous. Keep container tightly closed. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames. Keep away from heat and flame.
Storage:
Keep away from sources of ignition. Store in a cool, dry place.
Store in a tightly closed container.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 1193-79-9:
Personal Protective Equipment
Eyes:
Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 100 - 101 deg C @ 25 mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 80 deg C ( 176.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.066
Molecular Formula: C7H8O2
Molecular Weight: 124.0548
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Not currently available.
Conditions to Avoid:
Ignition sources, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 1193-79-9: LT8528000
LD50/LC50:
CAS# 1193-79-9: Oral, mouse: LD50 = 438 mg/kg.
Carcinogenicity:
2-Acetyl-5-methylfuran -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN
Risk Phrases:
R 22 Harmful if swallowed.
Safety Phrases:
WGK (Water Danger/Protection)
CAS# 1193-79-9: No information available.
Canada
CAS# 1193-79-9 is listed on Canada's DSL List.
CAS# 1193-79-9 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1193-79-9 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 1/16/2002 Revision #2 Date: 2/24/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
2,4-Decadien-1-ol, Tech., 90%
| 14507-02-9 |
|
4,4'-Dimethoxy-2,2'-bipyridine, 97%
| 17217-57-1 |
|
Benzyl 4-Hydroxybenzoate, 98%
| 94-18-8 |
|
m-Tolyl isocyanate, 99%
| 621-29-4 |
|
Histamine dihydrochloride, 98.5 - 101.0% ( on the dried substance)
| 56-92-8 |
|
Xanthosine dihydrate, 99%
| 5968-90-1 |
|
1-Butyl-3-Methylimidazolium Tetrafluoroborate
| 174501-65-6 |
|
1-Hexyl-3-methylimidazolium tetrafluoroborate
| 244193-50-8 |
|
1-Butylpyridinium tetrafluoroborate
| 203389-28-0 |
|
1-Hexylpyridinium tetrafluoroborate
| 474368-70-2 |
|
Methyl isovalerate, 98%
| 556-24-1 |
|
1-Bromo-2-fluoro-4-iodobenzene, 98+% (gc)
| 136434-77-0 |
|
2-Butoxyethanol or ethylene glycol monobutyl ether
| 111-76-2 |
|
Diacetone acrylamide, 99%
| 2873-97-4 |
|
N-(n-Butyl)phthalimide
| 1515-72-6 |
|
Poly(isobutylene), approximate MW 2800
| 9003-27-4 |
|
Poly(isobutylene), approximate MW 85000
| 9003-27-4 |
|
Poly(isobutylene), approximate MW 1,700,000
| 9003-27-4 |
|
Brucine sulfate hydrate, p.a.
| 38741-38-7 |
|
2,3,5,6-Tetrafluoro-p-toluic acid, 98%
| 652-32-4 |
|
2,3,5,6-Tetrafluoro-4-methylbenzyl alcohol
| 79538-03-7 |
|
Methyl nitroacetate, 98%
| 2483-57-0 |
|
Grubb's second generation catalyst, 97%
| 246047-72-3 |
|
1,3-Bis(2,4,6-Trimethylphenyl)-4,5-Dihydroimidazolium Chloride, 95%
| 141556-45-8 |
|
1,3-Bis(2,4,6-Trimethylphenyl)-4,5-Dihydroimidazolium
| 245679-18-9 |
|
2-(Di-tert-butylphosphino)biphenyl, 99%
| 224311-51-7 |
|
2-(Dicyclohexylphosphino)biphenyl, 98%
| 247940-06-3 |
|
2-Dicyclohexylphosphino-2'-(N,N-dimethylamino)biphenyl, 97%
| 213697-53-1 |
|
3,4-Dimethoxytoluene, 98%
| 494-99-5 |
|
Dimethylol urea
| 140-95-4 |
|
1,2,4,5-Tetrabromobenzene, 97%
| 636-28-2 |
|
2-Acetyl-5-methylfuran, 98%
| 1193-79-9 |
|
4-n-Hexyloxybenzoic acid, 99%
| 1142-39-8 |
|
2-Methyl-2-Pentenoic Acid, 99%
| 3142-72-1 |
|
cis-4-Hepten-1-ol, 97%
| 6191-71-5 |
|
3,5-Dibromobenzoic Acid
| 618-58-6 |
|
8-Ethoxyquinoline-5-sulfonic acid
| 15301-40-3 |
|
6-Fluoro-2-methylquinoline
| 1128-61-6 |
|
2-(Cyanomethyl)benzimidazole, 99%
| 4414-88-4 |
|
(S)-(-)-2,2'-Diamino-1,1-Binaphthalene
| 18531-95-8 |
|
(R)-(+)-2,2'-Diamino-1,1-binaphthalene, 99%
| 18741-85-0 |
|
Tris(4-bromophenyl)aminium hexachloroantimonate, 95%
| 24964-91-8 |
|
4-Chloro-1-butanol, 85%, balance THF and HCl
| 928-51-8 |
|
2-Phenylimidazole, 95%
| 670-96-2 |
|
Calcium silicide, 99+%
| 12013-56-8 |
|
2-(4-Chloro-2-Nitrophenyl)malondialdehyde, 95+% (NMR)
| 0-00-1 |
|
Fast Blue B fluoroborate
| 3410-35-3 |
|
4-Chlorobutyronitrile, 90% Chloro-deriv., bal. bromo-deriv. +
| 628-20-6 |
|
1-Acetyl-5-Nitroindoline
| 33632-27-8 |
|
Xanthine, 98%
| 69-89-6 |
|
|