Search   
MSDS 
:
 1-Butyl-3-Methylimidazolium Tetrafluoroborate
CAS 
:
 174501-65-6
SYNONYMS 
:
 None Known.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 174501-65-6 |1-Butyl-3-Methylimidazolium Tetrafluor| ca. 100 | unlisted |
| |oborate | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Hygroscopic (absorbs
moisture from the air).

Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes respiratory tract irritation. Can produce delayed pulmonary
edema.
Chronic:
Effects may be delayed.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water. Wash mouth out with water.
Inhalation:
Remove from exposure and move to fresh air immediately. If breathing
is difficult, give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation. If breathing has ceased apply artificial respiration
using oxygen and a suitable mechanical device such as a bag and a
mask.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas. Runoff from fire control or dilution water
may cause pollution.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Avoid breathing dust, vapor, mist, or gas. Avoid contact with eyes,
skin, and clothing. Keep container tightly closed. Avoid ingestion
and inhalation. Use and store under nitrogen. Wash clothing before
reuse.
Storage:
Store in a cool, dry place. Store in a tightly closed container.
Store protected from moisture. Store under nitrogen.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 174501-65-6:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: 118.3 cP (25 deg C)
Boiling Point: Not available.
Freezing/Melting Point: -71 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.2077
Molecular Formula: C8H15N2.BF4
Molecular Weight: 226.02

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Excess heat, exposure to moist air or water.
Incompatibilities with Other Materials:
Moisture, oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide, hydrogen fluoride
gas.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 174501-65-6 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1-Butyl-3-Methylimidazolium Tetrafluoroborate -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 174501-65-6: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 174501-65-6 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 174501-65-6 is not listed on the TSCA inventory.
It is for research and development use only.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 1/16/2002 Revision #2 Date: 10/07/2002

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
2,4-Decadien-1-ol, Tech., 90% 14507-02-9
4,4'-Dimethoxy-2,2'-bipyridine, 97% 17217-57-1
Benzyl 4-Hydroxybenzoate, 98% 94-18-8
m-Tolyl isocyanate, 99% 621-29-4
Histamine dihydrochloride, 98.5 - 101.0% ( on the dried substance) 56-92-8
Xanthosine dihydrate, 99% 5968-90-1
1-Butyl-3-Methylimidazolium Tetrafluoroborate 174501-65-6
1-Hexyl-3-methylimidazolium tetrafluoroborate 244193-50-8
1-Butylpyridinium tetrafluoroborate 203389-28-0
1-Hexylpyridinium tetrafluoroborate 474368-70-2
Methyl isovalerate, 98% 556-24-1
1-Bromo-2-fluoro-4-iodobenzene, 98+% (gc) 136434-77-0
2-Butoxyethanol or ethylene glycol monobutyl ether 111-76-2
Diacetone acrylamide, 99% 2873-97-4
N-(n-Butyl)phthalimide 1515-72-6
Poly(isobutylene), approximate MW 2800 9003-27-4
Poly(isobutylene), approximate MW 85000 9003-27-4
Poly(isobutylene), approximate MW 1,700,000 9003-27-4
Brucine sulfate hydrate, p.a. 38741-38-7
2,3,5,6-Tetrafluoro-p-toluic acid, 98% 652-32-4
2,3,5,6-Tetrafluoro-4-methylbenzyl alcohol 79538-03-7
Methyl nitroacetate, 98% 2483-57-0
Grubb's second generation catalyst, 97% 246047-72-3
1,3-Bis(2,4,6-Trimethylphenyl)-4,5-Dihydroimidazolium Chloride, 95% 141556-45-8
1,3-Bis(2,4,6-Trimethylphenyl)-4,5-Dihydroimidazolium 245679-18-9
2-(Di-tert-butylphosphino)biphenyl, 99% 224311-51-7
2-(Dicyclohexylphosphino)biphenyl, 98% 247940-06-3
2-Dicyclohexylphosphino-2'-(N,N-dimethylamino)biphenyl, 97% 213697-53-1
3,4-Dimethoxytoluene, 98% 494-99-5
Dimethylol urea 140-95-4
1,2,4,5-Tetrabromobenzene, 97% 636-28-2
2-Acetyl-5-methylfuran, 98% 1193-79-9
4-n-Hexyloxybenzoic acid, 99% 1142-39-8
2-Methyl-2-Pentenoic Acid, 99% 3142-72-1
cis-4-Hepten-1-ol, 97% 6191-71-5
3,5-Dibromobenzoic Acid 618-58-6
8-Ethoxyquinoline-5-sulfonic acid 15301-40-3
6-Fluoro-2-methylquinoline 1128-61-6
2-(Cyanomethyl)benzimidazole, 99% 4414-88-4
(S)-(-)-2,2'-Diamino-1,1-Binaphthalene 18531-95-8
(R)-(+)-2,2'-Diamino-1,1-binaphthalene, 99% 18741-85-0
Tris(4-bromophenyl)aminium hexachloroantimonate, 95% 24964-91-8
4-Chloro-1-butanol, 85%, balance THF and HCl 928-51-8
2-Phenylimidazole, 95% 670-96-2
Calcium silicide, 99+% 12013-56-8
2-(4-Chloro-2-Nitrophenyl)malondialdehyde, 95+% (NMR) 0-00-1
Fast Blue B fluoroborate 3410-35-3
4-Chlorobutyronitrile, 90% Chloro-deriv., bal. bromo-deriv. + 628-20-6
1-Acetyl-5-Nitroindoline 33632-27-8
Xanthine, 98% 69-89-6

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net