Search   
MSDS 
:
 Cyclododecylmethyl ether, 98+%
CAS 
:
 2986-54-1
SYNONYMS 
:
 
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 2986-54-1 |Cyclododecylmethyl ether | 98.0+ | 221-053-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to skin.The toxicological properties of this material
have not been fully investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
Causes skin irritation. May cause dermatitis.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated. May cause burning
sensation in the chest.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse. Remove contaminated clothing and shoes.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use agent most appropriate to extinguish
fire.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate general or
local explosion-proof ventilation to keep airborne levels to
acceptable levels.
Exposure Limits
CAS# 2986-54-1:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear colorless
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: 6.91 mPas 20.0 deg
Boiling Point: 270.7 deg C
Freezing/Melting Point: 8 deg C
Autoignition Temperature: 220 deg C ( 428.00 deg F)
Flash Point: 115 deg C ( 239.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: .9110g/cm3
Molecular Formula: C13H26O
Molecular Weight: 198.33

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 2986-54-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Cyclododecylmethyl ether -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 38 Irritating to skin.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 28 After contact with skin, wash immediately
with...
S 28A After contact with skin, wash immediately with
plenty of water.
S 33 Take precautionary measures against static
discharges.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 2986-54-1: 1
Canada
CAS# 2986-54-1 is listed on Canada's DSL List.
CAS# 2986-54-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 2986-54-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 4/05/1997 Revision #6 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Tetrachlorocyclopropene, 98% (GC) 6262-42-6
Analgin DAB 68-89-3
Chelidonic Acid Monohydrate, 96% 6003-94-7
2-Chloro-4-Nitrotoluene, 99% 121-86-8
3-Methoxyphenyl isocyanate, 99% 18908-07-1
Cyclododecylmethyl ether, 98+% 2986-54-1
3-Bromofluorobenzene, 99% 1073-06-9
Gallium atomic absorption standard solution, 1mg/ml Ga in 2% HNO3 7440-55-3
Triacetylmethane, 97% 815-68-9
(4-Pyridylthio)Acetic Acid , 98% 10351-19-6
2-Methyl-1-Nitronaphthalene, 99% 881-03-8
Adogen 464 63393-96-4
Trichloroacetonitrile, 95% (gc) 545-06-2
Methyl orotate, 99% 6153-44-2
5-Amino-6-nitroquinoline, 98% 35975-00-9
Ammonium Sulfobetaine - 4, 1 % Solution in Water
3-Fluoro-p-anisaldehyde, 99% 351-54-2
3,5-Dibenzyloxyacetophenone, 98% 28924-21-2
Triisopropylsilane 6485-79-6
Ethyl Cis-2-Hydroxy-1-Cyclopentanecarboxylate, 98% 2315-21-1
Acetol, tech., ca 90-95% (gc) 116-09-6
Bathocuproinedisulfonic acid,disodium salt hydrate, 97% (hplc) 52698-84-7
Glycerol-1-Allylether, 98% 123-34-2
Dimethylamine Hydrochloride, 99% (Dry Substance) 506-59-2
Sodium tetrathionate, 90% (titr.) 10101-86-7
1,4-Diiodobenzene, 98% 624-38-4
Dibromomaleic Acid 608-37-7
1(and 2)-Octene, 99% (GC) 62758-15-0
3-Isobutoxy-2-cyclohexen-1-one, 99% 23074-59-1
2,4,5-Tribromoimidazole, 97% 2034-22-2
6-Nitrobenzimidazole, 98% 94-52-0
Acid blue 120 3529-01-9
2,6-Dimethylquinoline, 98% 877-43-0
3-Diethylamino-1-propanol, 94% (titr.) 622-93-5
FMOC-Beta-Alanine, 98% 35737-10-1
2-Chlorocyclopentanone, 97% (Stabilzed with 200 ppm H.Q.) 694-28-0
2-Azacyclononanone 99% 935-30-8
Diethylamine Hydrochloride, 99% 660-68-4
Tetrabutylammonium Nitrate 1941-27-1
2,4-Di-Tert-Pentylphenol, 96% (GC) 120-95-6
1-Diazo-2-naphthol-4-sulfonic acid,97%(TLC, contains ca. 25% 887-76-3
tert-Butylurea 1118-12-3
5-Acetoxymethyl-2-furaldehyde 10551-58-3
Iodoethane-d5, 99+ atom% d 6485-58-1
Dimethyldithiocarbamic Acid Sodium Salt 128-04-1
Naphthol yellow s 846-70-8
Molecular Sieves, 13X, Powder (< 0.050 mm) 0-00-1
1,2-Octanediol, 98+% 1117-86-8
Tetrahexylammonium Benzoate 16436-29-6
4-Bromophenylhydrazine Hydrochloride, 99% 622-88-8

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net