Search   
MSDS 
:
 4-(Trifluoromethoxy)benzonitrile
CAS 
:
 332-25-2
SYNONYMS 
:
 alpha, alpha, alpha-Trifluoro-p-anisonitrile
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 332-25-2 |4-(Trifluoromethoxy)benzonitrile | 100.0 | 206-363-3 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN XI
Risk Phrases: 20/21/22 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Harmful by inhalation, in contact with skin and if swallowed.
Irritating to eyes, respiratory system and skin.The toxicological
properties of this material have not been fully
investigated.Combustible liquid.

Potential Health Effects
Eye:
No information regarding eye irritation and other potential effects
was found.
Skin:
No information regarding skin irritation and other potential effects
was found.
Ingestion:
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
The toxicological properties of this substance have not been fully
investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Use water spray to keep fire-exposed containers
cool. Combustible liquid. Containers may explode when heated.
Extinguishing Media:
Use water spray to cool fire-exposed containers. For small fires,
use dry chemical, carbon dioxide, or water spray. For large fires,
use dry chemical, carbon dioxide, alcohol-resistant foam, or water
spray. Cool containers with flooding quantities of water until well
after fire is out.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Empty containers retain
product residue, (liquid and/or vapor), and can be dangerous. Keep
container tightly closed. Keep away from heat, sparks and flame.
Avoid ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 332-25-2:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: Not available.
Odor: Spicy odor.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 192 - 193 deg C @ 760.00mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 82 deg C ( 179.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.2850g/cm3
Molecular Formula: C8H4F3NO
Molecular Weight: 187.12

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stability unknown.
Conditions to Avoid:
Incompatible materials, ignition sources.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide, hydrogen fluoride
gas.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 332-25-2 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
4-(Trifluoromethoxy)benzonitrile -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN XI
Risk Phrases:
R 20/21/22 Harmful by inhalation, in contact with
skin and if swallowed.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
WGK (Water Danger/Protection)
CAS# 332-25-2: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 332-25-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 332-25-2 is not listed on the TSCA inventory.
It is for research and development use only.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 1/20/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Acetic Acid, Sodium Salt, Anhydrous, P.A. 127-09-3
1400W.dihydrochloride 0-01-1
4,5-Imidazoledicarboxylic Acid, 99% (Titr.) 570-22-9
S-Ethyl-N-[4-(trifluoromethyl)phenyl]-isothiourea.hydrochloride 0-01-1
L(+)-2-Amino-4-Phosphonobutyric Acid 23052-81-5
(+-)-1-Aminoindane-1,5-Dicarboxylic Acid 0-01-1
D(-)-2-Amino-4-Phosphonobutyric Acid 78739-01-2
DL-2-Amino-4-Phosphonobutyric Acid 20263-07-4
L-(+)-2-Amino-3-Phosphonopropionic Acid 23052-80-4
D-(-)-2-Amino-3-Phosphonopropionic Acid 128241-72-5
Ethyl 4-aminobenzoate, 98% 94-09-7
Acetic acid, sodium salt trihydrate, p.a. 6131-90-4
Benzoic acid, sodium salt, 99+% 532-32-1
DL-2-Amino-3-Phosphonopropionic Acid 20263-06-3
cis-Azetidine-2,4-dicarboxylic acid 121050-04-2
(+-)-trans-Azetidinen-2,4-Dicarboxylic Acid 0-01-1
(2R,4R)-(+)-Azetidinen-2,4-Dicarboxylic Acid 161596-63-0
(2S,4S)-(-)-Azetidinen-2,4-Dicarboxylic Acid 0-01-1
Sodium Bicarbonate, P.A. 144-55-8
(RS)-4-Bromo-homo-ibotenic acid 71366-32-0
Sodium borohydride, pellets, 7/16'', 98% (12-13 mm) 16940-66-2
Sodium Bromate, 99+% 7789-38-0
Ammonium Thiocyanate 1762-95-4
3-Cyclohexyl-1-Propanol, 99% 1124-63-6
(2S,3S)-Trans-3-(Carboxymethyl)-Azetidine-2-Acetic Acid 185387-36-4
Sodium bromide, p.a. 7647-15-6
4-(Trifluoromethoxy)benzonitrile 332-25-2
Diltiazem.hydrochloride 33286-22-5
FGIN-1-27 142720-24-9
Dimethyl 2-acetoxyethylphosphonate 39118-50-8
6-alpha-Methylprednisolone, 99% 83-43-2
L-Cysteine hydrochloride hydrate, 98.5%- 101.5% (on the dried basis) 52-89-1
5-Norbornene-2-carboxaldehyde, 90-95% 5453-80-5
Glipizide (USP) 29094-61-9
(+-)-Ibotenic acid 2552-55-8
IDRA 21 22503-72-6
Sodium Carbonate, Anhydrous 497-19-8
1,5-Isoquinolinediol 5154-02-9
Luzindole 117946-91-5
N-Methyl-L-Aspartic Acid 4226-18-0
N-Methyl-D-aspartic acid 6384-92-5
p-Iodophenoxyacetic acid, 97% 1878-94-0
Ammonium meta-vanadate 7803-55-6
Sodium carbonate monohydrate, reagent ACS (granular) 5968-11-6
Sodium chlorate, 99+% 7775-09-9
4-n-Heptyloxybenzoic Acid, 98% 15872-42-1
(S)-(-)-N-(2-Hydroxyethyl)-Alpha-Phenylethylamine, 99% 0-01-1
4-Chlorobutyryl chloride, specialty project grade 4635-59-0
3-Hydroxy-2-methylpyridine, 99% 1121-25-1
Sodium borohydride, powder, 98+%, Morton material !!!Prepak only!!! 16940-66-2

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net