Search   
MSDS 
:
 2,6-Dichloroindophenol Sodium Salt Hydrate  P.A.
CAS 
:
 620-45-1
SYNONYMS 
:
 Tillman's Reagent; 2,6-Dichlorophenolindophenol Sodium Salt; Sodium     2,6-Dichloroindophenolate
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 620-45-1 |2,5-Cyclohexadien-1-One,2,6-Dichloro-4| ca. 100 | 210-640-4 |
| |-(4-Hydroxyphenyl)imin | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
May cause eye irritation. The toxicological properties of this
material have not been fully investigated.
Skin:
May cause skin irritation. The toxicological properties of this
material have not been fully investigated.
Ingestion:
May cause irritation of the digestive tract. May cause
gastrointestinal irritation with nausea, vomiting and diarrhea. The
toxicological properties of this substance have not been fully
investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
Use extinguishing media most appropriate for the surrounding fire.
Use water spray, dry chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Keep
containers tightly closed.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 620-45-1:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: dark green
Odor: odorless
pH: Not available.
Vapor Pressure: Negligible.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Soluble in water.
Specific Gravity/Density: Not available.
Molecular Formula: C12H6Cl2NO2Na.2H2O
Molecular Weight: 325.9701

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, oxidizers.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Hydrogen chloride, nitrogen oxides, carbon monoxide, irritating and
toxic fumes and gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Will not occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 620-45-1: GU5495000
LD50/LC50:
Not available.
Carcinogenicity:
2,5-Cyclohexadien-1-One,2,6-Dichloro-4-(4-Hydroxyphenyl)imin -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 620-45-1: No information available.
Canada
CAS# 620-45-1 is listed on Canada's DSL List.
CAS# 620-45-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 620-45-1 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 11/05/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Bromophenol Blue (0.1% in Water) 115-39-9
Diethylene glycol dibutyl ether, 99+% 112-73-2
Bromophenol Blue, Water Soluble Indicator 62625-28-9
Bromocresol green, indicator 76-60-8
Cresyl Violet Acetate, High Purity Biological Stain 10510-54-0
Congo Red, Indicator Grade 573-58-0
Congo Red (Cert) 573-58-0
2,6-Dichloroindophenol Sodium Salt Hydrate P.A. 620-45-1
Eosin Y High Purity Biological Stain 17372-87-1
Eosin Y (cert) 17372-87-1
Giemsa Stain, High Purity Biological Stain 51811-82-6
Hematoxylin (Cert), 90% (UV-Vis) 517-28-2
Indigo carmine, high purity biological stain 860-22-0
Methyl red, sodium salt, indicator 845-10-3
Methyl Orange, Indicator 547-58-0
Methyl Orange (Cert) 547-58-0
Methyl Orange, Reagent ACS 547-58-0
Neutral red, high purity biological stain 553-24-2
Orange G, High Purity Biological Stain 1936-15-8
Orcein, natural 1400-62-0
Basic Fuchsin, high purity biological stain 569-61-9
Pararosaniline Chloride (0.2% in .1M Hydrochloric Acid) 569-61-9
1,10-Phenanthroline monohydrate, 99+% 66-71-7
m-Toluic acid, 99% 99-04-7
Phenol Red, Water Soluble, Indicator 34487-61-1
Phloxine b, high purity biological stain 18472-87-2
Safranine O, high purity biological stain, 95% 477-73-6
Sudan iii, high purity biological stain 98% (tlc) 85-86-9
Sudan IV, High Purity Biological Stain 85-83-6
Sudan Black B, High Purity Biological Stain 4197-25-5
Palmitoyl chloride,tech. 92%(gc) 112-67-4
Pyronin Y, High Purity Biological Stain 92-32-0
Nitro Blue Tetrazolium Chloride Mono- Hydrate 298-83-9
Oil Red O, biological stain 1320-06-5
Dithioerythritol, 99+% 6892-68-8
MES hydrate 0-00-1
2,2-Bis(Hydroxymethyl)-2,2',2"- Nitrilotriethanol, 98% 6976-37-0
ACES, 99% 7365-82-4
Benzamidine hydrochloride hydrate, 98% 1670-14-0
Dimethyl 1,4-Cyclohexanedicarboxylate, 99%, Mixture of Cis and Trans 94-60-0
Iodoacetic acid 64-69-7
Calcium Pantothenate, 97.5% 137-08-6
1-BROMOPYRENE 1714-29-0
Yttrium(iii)-oxide, 99.999% 1314-36-9
2-Hydroxy-p-naphthoquinone 83-72-7
Crocein Orange G 1934-20-9
5-Nitroindazole, 98% (titr.) 5401-94-5
4-Chloro-1-Naphthol, 99% 604-44-4
Dextran (High Fraction), average m.w. 250000 9004-54-0
2,2-Dimethyl-1,3-propanediol, 97% 126-30-7

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net