polydimethylsiloxane; (dimethyl siloxane, hydroxy-terminated) fiberglass (fibrous glass); (glass fiber or microballoons) silica gel; (silica, amorphous fumed; #1655) voc: 2 g/l (maximum voc inclusive of water & exempt compounds; ing 4: 5 g/l (maximum voc exclusive of water and exempt compounds after
DOW CORNING CORP -- 3-6410 ABLATIVE/INSULATION COATING BASE PART
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: CBKNL
MSDS NAME: 3-6410 ABLATIVE/INSULATION COATING BASE PART A
Kit Part: Y
Responsible Party
Name: DOW CORNING CORP
Address: SOUTH SAGINAW ROAD
City: MIDLAND MI 48686
Info Phone: 517-496-6000
Emergency Phone Number: 517-496-5900;800-424-9300(CHEMTREC)
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: DOW CORNING CORP
Address: 3901 S SAGINAW RD
Box: 997
City: MIDLAND MI 48686-0997
Phone: 517-496-6000/517-496-6315
Name: DOW CORNING CORP
Address: 2200 W SALZBURG RD
City: AUBURN MI 48611
Phone: 517-496-4388
=======================================================
Ingredients
=======================================================
Cas: 70131-67-8
Name: POLYDIMETHYLSILOXANE; (DIMETHYL SILOXANE, HYDROXY-TERMINATED)
% Wt: 61
OSHA PEL: N/K (FP N)
ACGIH TLV: N/K (FP N)
------------------------------
Cas: 65997-17-3
Name: FIBERGLASS (FIBROUS GLASS); (GLASS FIBER OR MICROBALLOONS)
% Wt: 21
OSHA PEL: 5 MG/M3 RESP DUST
ACGIH TLV: 10 MG/M3 (<7MICRONS)
------------------------------
Cas: 112945-52-5
RTECS #: VV7310000
Name: SILICA GEL; (SILICA, AMORPHOUS FUMED; #1655)
% Wt: 17
OSHA PEL: 6 MG/M3
ACGIH TLV: 10 MG/M3
------------------------------
RTECS #: 9999999VO
Name: VOC: 2 G/L (MAXIMUM VOC INCLUSIVE OF WATER & EXEMPT COMPOUNDS;
MAXIMUM VOC EXCLUSIVE OF WATER & EXEMPT CMPDS);
OSHA PEL: N/K (FP N)
ACGIH TLV: N/K (FP N)
-----------------------------
Name: ING 4: 5 G/L (MAXIMUM VOC EXCLUSIVE OF WATER AND EXEMPT COMPOUNDS AFTER
MIXING)
=======================================================
Health Hazards Data
=======================================================
LD50 LC50 Mixture: NONE SPECIFIED BY MANUFACTURER.
Route Of Entry Inds - Inhalation: YES
Skin: YES
Ingestion: YES
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
Effects of Exposure: ACUTE: EYE: DIRECT CONT MAY CAUSE TEMPORARY DISCOMFORT
W/MILD REDNESS & DRYNESS SIMILAR TO WINDBURN. INHAL: NO INJURY IS LIKELY
FROM RELATIVELY SHORT EXPOS OF LESS THAN 8 HRS. INGEST: SML AMTS TRANSFE RRED
TO MOUTH BY FINGERS DURING USE, ETC, SHOULD NOT INJURE. SWALLOWING LGE AMTS
MAY CAUSE DIGESTIVE (EFTS OF OVEREXP)
Explanation Of Carcinogenicity: NOT RELEVANT.
Signs And Symptions Of Overexposure: HLTH HAZ: DISCOMFORT. CHRONIC: WHEN HEATED
TO TEMPS > 180C IN PRESENCE OF AIR, PROD CAN FORM FORMALDEHYDE VAPS.
FORMALDEHYDE IS A POTENTIAL CANCER HAZ, A KNOWN SKIN & RESP SENSIT &
AN IRRIT TO EYES, N OSE, THROAT, SKIN & DIGESTIVE SYS. SAFEHNDLG CNDTNS
MAY BE MAINT BY KEEPING VAP CONCS W/IN OSHA PEL FOR FORMALDEHYDE.
Medical Cond Aggravated By Exposure: NONE SPECIFIED BY MANUFACTURER.
First Aid: EYES: IMMEDIATELY FLUSH WITH WATER FOR AT LEAST 15 MINUTES. SKIN:
FLUSH WITH COPIOUS AMOUNTS OF WATER. SEE MD (FP N). INGESTION: CALL MD
IMMEDIATELY (FP N). INHALATION: REMOVE TO FRESH AIR. SUPPORT BR EATHING (GIVE
OXYGEN OR ARTIFICIAL RESPIRATION) (FP N). TREAT SYMPTOMATICALLY.
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: SCRAPE UP & CONTAIN FOR SALVAGE/DISP. OBSERVE ALL
PERS PROT EQUIP RECOMMENDATIONS. LOCAL, STATE, & FED REPORTING
REQUIREMENTS MAY APPLY TO SPILLS/RELEASES OF THIS MATL INTO ENVIRONMENT.
Neutralizing Agent: NONE SPECIFIED BY MANUFACTURER.
Waste Disposal Methods: DISPOSAL OF COLLECTED PRODUCT, RESIDUES, AND CLEANUP
MATERIALS MAY BE GOVERNMENTALLY REGULATED. OBSERBE ALL APPLICABLE LOCAL,
STATE, AND FEDERAL WASTE MANAGEMENT REGULATIONS.
Handling And Storage Precautions: THESE PRECAUTIONS ARE FOR ROOM TEMPERATURE
HANDLING. USE AT ELEVATED TEMPERATURE, OR AEROSOL/SPRAY APPLICATIONS, MAY
REQUIRE ADDED PRECAUTIONS.
Other Precautions: NO SPECIAL PRECAUTIONS. AVOID EYE CONTACT. USE REASONABLE
CARE.
=======================================================
Fire and Explosion Hazard Information
=======================================================
Extinguishing Media: USE CARBON DIOXIDE (CO*2), WATER, WATER FOG (OR SPRAY),
DRY CHEMICAL, FOAM.
Fire Fighting Procedures: WEAR NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT (FP N). IF LARGE AMOUNT IS INVOLVED, EVACUATE AREA.
Unusual Fire/Explosion Hazard: NONE.
=======================================================
Control Measures
=======================================================
Respiratory Protection: NO RESPIRATORY PROTECTION SHOULD BE NEEDED. USE
NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN (FP N).
Ventilation: LOCAL EXHAUST: NONE SHOULD BE NEEDED. GENERAL VENTILATION:
RECOMMENDED.
Protective Gloves: IMPERVIOUS GLOVES (FP N).
Eye Protection: ANSI APPRVD CHEM WORKERS GOGGS (FP N).
Other Protective Equipment: EMERGENCY EYEWASH & DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA (FP N).
Work Hygienic Practices: WASHING AT MEALTIME AND END OF SHIFT IS ADEQUATE.
Supplemental Safety and Health: NONE SPECIFIED BY MANUFACTURER.
=======================================================
Physical/Chemical Properties
=======================================================
Spec Gravity: 0.51
Solubility in Water: NONE
Appearance and Odor: WHITE PASTE
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: NONE.
Materials To Avoid: OXIDIZING MATERIAL CAN CAUSE A REACTION.
Hazardous Decomposition Products: SILICON DIOXIDE. CARBON OXIDES AND TRACES OF
INCOMPLETELY BURNED CARBON COMPOUNDS. FORMALDEHYDE.
Hazardous Polymerization Indicator: NO
Conditions To Avoid Polymerization: NOT RELEVANT.
=======================================================
Toxicological Information
=======================================================
=======================================================
Ecological Information
=======================================================
=======================================================
MSDS Transport Information
=======================================================
=======================================================
Regulatory Information
=======================================================
=======================================================
Other Information
=======================================================
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: 3-6410 ABLATIVE/INSULATION COATING BASE PART A
Company: DOW CORNING CORP
Street: 3901 S SAGINAW RD
PO Box: 997
City: MIDLAND MI
Zipcode: 48686-0997
Health Emergency Phone: 517-496-5900;800-424-9300(CHEMTREC)
Label Required IND: Y
Date Of Label Review: 02/28/1996
Status Code: C
Label Date: 02/28/1996
Origination Code: G
Eye Protection IND: YES
Skin Protection IND: YES
Signal Word: CAUTION
Respiratory Protection IND: YES
Health Hazard: Slight
Contact Hazard: Slight
Fire Hazard: None
Reactivity Hazard: None
Hazard And Precautions: ACUTE: EYES: DIRECT CONTACT MAY CAUSE TEMPORARY
DISCOMFORT WITH MILD REDNESS AND DRYNESS SIMILAR TO WINDBURN. INGESTION:
SWALLOWING LARGE AMOUNTS MAY CAUSE DIGESTIVE DISCOMFORT. CHRONIC: NONE
SPECIFIE D BY MANUFACTURER.
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.