STONER INCORPORATED -- XTRA HEAVY DUTY SILICONE MOLD RELEASE, E218
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: CJMRD
MSDS NAME: XTRA HEAVY DUTY SILICONE MOLD RELEASE, E218
Responsible Party
Name: STONER INCORPORATED
Address: 1070 ROBERT FULTON HWY
City: QUARRYVILLE PA 15766
Info Phone: 800-227-5538
Emergency Phone Number: 800-424-9300 (CHEMTREC)
Chemtrec IND/Phone: (800)424-9300
Proprietary Ind: Y
Review Ind: Y
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: STONER INCORPORATED
Address: 1070 ROBERT FULTON HWY
City: QUARRYVILLE PA 15766
Phone: 800-227-5538
=======================================================
Item Description Information
=======================================================
=======================================================
Ingredients
=======================================================
Name: *** PROPRIETARY ***
-----------------------------
=======================================================
Health Hazards Data
=======================================================
Route Of Entry Inds - Inhalation: YES
Skin: YES
Ingestion: NO
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
Effects of Exposure: ACUTE: EYES: EYE CONTACT WITH THE LIQUID OR VAPOR MAY
CAUSE IRRITATION. SKIN: SKIN CONTACT WITH THE LIQUID MAY CAUSE FREEZING OF
THE SKIN OR IRRITATION. INGESTION: NOT CONSIDERED A POTENTIAL ROUTE OF
EXPOSURE. INHALATION: OVEREXPOSURE BY INHALATION OF VAPORS MAY CAUSE
RESPIRATORY IRRITATION OR NON-SPECIFIC DISCOMFORT SUCH AS NAUSEA, HEADACHE OR
WEAKNESS. INHALATION OF CONCENTRATIONS ABOVE THE RECO MMENDED LIMITS MAY
CAUSE TEMPORARY CENTRAL NERVOUS SYSTEM DEPRESSION WITH ANESTHETIC EFFECTS
SUCH AS DIZZINESS, HEADACHE, INCOORDINATION, AND LOSS OF CONSCIOUSNESS;
(EFFECTS OF OVEREXPOSURE)
Explanation Of Carcinogenicity: THIS PRODUCT CONTAINS NO COMPONENTS LISTED AS
CARCINOGENIC BY IARC, NTP, OR OSHA 1910(Z).
Signs And Symptions Of Overexposure: HEALTH HAZARDS: OR TEMPORARY ALTERATION OF
THE HEART'S ELECTRICAL ACTIVITY (CARDIAC ARRHYTHMIA). GROSS OVEREXPOSURE MAY
BE FATAL. CHRONIC: NO CHRONIC HEALTH EFFECTS KNOWN. CHLOROFLUOROCARBON
MATERIALS HAVE PRODUCED SENSITIZATION OF THE MYOCARDIUM TO EPINEPHRINE IN
LABORATORY ANIMALS AND COULD HAVE A SIMILAR EFFECT IN HUMANS. ADRENOMIMETICS
(E.G., EPINEPHRINE) MAY BE CONTRAINDICATED EXCEPT FOR LIFE -SUSTAINING USES
IN HUMANS ACUTELY OR CHRONICALLY EXPOSED TO CHLOROFLUOROCARBONS (FP N).
Medical Cond Aggravated By Exposure: INDIVIDUALS WITH PREEXISTING DISEASES OF
THE CENTRAL NERVOUS OR CARDIOVASCULAR SYSTEM MAY HAVE INCREASED
SUSCEPTIBILITY TO THE TOXICITY OF EXCESSIVE EXPOSURES.
First Aid: EYES: FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES. IF
SYMPTOMS PERSIST, SEEK MEDICAL ATTENTION. SKIN: WASH THOROUGHLY WITH SOAP AND
WATER. INGESTION: UNLIKELY ROUTE OF EXPOSURE. DO NOT INDUCE V OMITING UNLESS
INSTRUCTED BY A PHYSICIAN. INHALATION: REMOVE SOURCE(S) OF CONTAMINATION AND
MOVE VICTIM TO FRESH AIR. IF BREATHING HAS STOPPED, GIVE ARTIFICIAL
RESPIRATION, THEN OXYGEN IF NEEDED. CONT ACT PHYSICIAN IMMEDIATELY. NOTES TO
PHYSICIAN: BECAUSE OF POSSIBLE DISTURBANCES OF CARDIAC RHYTHM, CATECHOLAMINE
DRUGS, SUCH AS EPINEPHRINE, SHOULD BE USED ONLY IN SITUATIONS OF EMERGENCY
LIFE SUPPORT .
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: AVOID BREATHING VAPORS. EVACUATE AREA UNTIL VAPOR HAS
DISPERSED. REMOVE ALL SOURCES OF IGNITION. STOP OR REDUCE DISCHARGE IF IT CAN
BE DONE SAFELY.
Waste Disposal Methods: DISPOSE ACCORDING TO FEDERAL, STATE AND LOCAL
REGULATIONS. "EMPTY" CONTAINERS MAY CONTAIN RESIDUAL PRODUCT.
Handling And Storage Precautions: MIN BRTHG VAPS & AVOID PRLNG/RPTD SKIN
CONT. WEAR PROPER PROT EQUIP. IF VENT IS NOT SUFFICIENT, WEAR PROPER NIOSH
APPRVD RESP EQUIP. DO NOT USE NEAR IGNIT SOURCES. CONTENTS UNDER PRESS. DO
NOT PUNCTUR E/INCIN. DO NOT REMOVE/DEFACE LABEL. STORE IN COOL, DRY,
WELL-VENTD AREA AWAY FROM IGNIT SOURCES.
Other Precautions: EMPTY CONTAINER MAY CONTAIN RESIDUES WHICH ARE HAZARDOUS. DO
NOT STORE AT TEMPERATURES ABOVE 120F. NO SMOKING IN AREA OF USE. DO NOT USE
IN THE GENERAL VICINITY OF ARC WELDING, OPEN FLAMES OR HOT SURF ACES. HEAT
AND/OR UV RADIATION MAY CAUSE THE FORMATION OF HCL AND/OR PHOSGENE (FP N).
=======================================================
Fire and Explosion Hazard Information
=======================================================
Extinguishing Media: USE DRY CHEMICAL, FOAM, OR CARBON DIOXIDE; WATER MAY BE
INEFFECTIVE BUT SHOULD BE USED TO KEEP EXPOSED CONTAINERS COOL.
Fire Fighting Procedures: WEAR NIOSH APPROVED PRESSURE DEMAND SCBA AND FULL
PROTECTIVE EQUIPMENT (FP N).
Unusual Fire/Explosion Hazard: VAPS CONFINED IN POORLY VENTD AREA MAY BE
IGNITED BY SPK/FLAME. VAPS MAY TRAVEL CONSIDERABLE DISTS TO SOURCE OF IGNIT.
VAPS ARE HVR/AIR & MAY ACCUM IN LOW AREAS. CONTRS MAY RUPTURE/EXPLODE
UNDER FIRE CNDTNS. HAZ DECOMP PRODS MAY BE FORMED. MATL CAN ACCUM STATIC
CHARGES WHICH CAN CAUSE INCENDIARY ELEC (SUP DAT)
=======================================================
Control Measures
=======================================================
Respiratory Protection: NONE REQUIRED FOR WELL-VENTILATED SITUATIONS. FOR
HIGHER VAP LEVELS, A NIOSH APPRVD ORGANIC VAP MASK IS RECOMMENDED. A NIOSH
APPRVD SUPPLIED AIR RESPIRATOR SHOULD BE USED IF VENTILATION IS NOT SUFFICI
ENT TO MAINTAIN EXPOS LIMITS. IF RESPIRATORY IRRITATION DEVELOPS BELOW THE
RECOMMENDED EXPOS LIMITS, USE A NIOSH APPRVD NUISANCE DUST/MIST ORGANIC VAPOR
RESP.
Ventilation: VENT SHOULD BE ADEQ TO PVNT EXPOS ABOVE LIMS. USE LOC EXHST IN
AREAS WHERE EXPOS LIMS MAY BE EXCEEDED. USE MECH VENT IN CONFINED SPACES
& LOW AREAS.
Protective Gloves: CHEMICALLY RESISTANT GLOVES RECOMMENDED FOR PROLONGED OR
REPEATED SKIN CONTACT.
Eye Protection: ANSI APPROVED CHEMICAL WORKERS GOGGLES (FP N).
Other Protective Equipment: ANSI APPROVED EMERGENCY EYEWASH AND DELUGE SHOWER
(FP N).
Supplemental Safety and Health: EXPLO HAZ: DISCHARGE. "EMPTY" CONTRS RETAIN
PROD RESIDUE & CAN BE DANGEROUS. AEROSOL FLAME PROJECTION TEST: NON-FLAM
AEROSOL, AS DETERMINED BY ASTM D3065-77 & FSHA SEC 1500.45. HOWEVER, THIS
PROD CONT AINS COMPONENTS WHICH MAY BE IGNITED UNDER CERTAIN CIRCUMSTANCES.
DO NOT USE NEAR IGNIT SOURCES SUCH AS (OTHER INFO)
=======================================================
Physical/Chemical Properties
=======================================================
Vapor Pres: 50 PSIG @ 70F
Vapor Density: >1 (AIR=1)
Spec Gravity: 0.86 @ 70F
Evaporation Rate & Reference: >1 (BUTYL ACETATE=1)
Solubility in Water: INSOLUBLE
Appearance and Odor: CLEAR, COLORLESS AEROSOL CAN, WITH SLIGHT ETHEREAL ODOR.
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: IGNITION SOURCES SUCH AS OPEN FLAMES, SPARKS,
STATIC DISCHARGES OR GLOWING METAL SURFACES. FRESHLY ABRADED ALUMINUM
SURFACES.
Materials To Avoid: CHEMICALLY ACTIVE METALS: CALCIUM, POWDERED ALUMINUM, ZINC,
SODIUM, POTASSIUM, MAGNESIUM, ETC. OXIDIZERS, CARBON MONOXIDE, ACETIC ACIDS,
ORGANIC ACID ANHYDRIDES.
Hazardous Decomposition Products: BURNING CAN PRODUCE THE FOLLOWING COMBUSTION
PRODS: CARBON DIOXIDE AND CARBON MONOXIDE. OXIDES OF SILICONE. HALOGENS,
HALOGEN ACIDS, & POSSIBLE CARBONYL HALIDES, SUCH AS PHOSGENE. HCL, PHOSGENE
(FP N).
Hazardous Polymerization Indicator: NO
=======================================================
Regulatory Information
=======================================================
Sara Title III Information: SARA SECTION 313: THIS PRODUCT CONTAINS THE
FOLLOWING CHEMICALS THAT ARE SUBJECT TO THE REPORTING REQUIREMENTS UNDER
SECTION 313 OF SARA TITLE III: DICHLOROFLUOROETHANE, CAS # 1717-00-6, 40-50%
BY WEI GHT.
Federal Regulatory Information: TSCA STATUS: ALL COMPONENTS OF THIS PRODUCT ARE
LISTED ON TSCA INVENTORY.
State Regulatory Information: CALIFORNIA PROPOSITION 65: THIS PRODUCT CONTAINS
NO CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS,
OR OTHER REPRODUCTIVE HARM.
=======================================================
Other Information
=======================================================
Other Information: SUP DAT: SPARKS OR OPEN FLAMES. THERMAL DECOMPOSITION
PRODUCTS MAY INCLUDE HCL AND PHOSGENE (FP N).
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: XTRA HEAVY DUTY SILICONE MOLD RELEASE, E218
Company: STONER INCORPORATED
Street: 1070 ROBERT FULTON HWY
City: QUARRYVILLE PA
Zipcode: 15766
Health Emergency Phone: 800-424-9300 (CHEMTREC)
Label Required IND: Y
Date Of Label Review: 08/27/1999
Status Code: A
Origination Code: F
Eye Protection IND: YES
Skin Protection IND: YES
Signal Word: WARNING
Respiratory Protection IND: YES
Health Hazard: Moderate
Contact Hazard: Moderate
Fire Hazard: None
Reactivity Hazard: None
Hazard And Precautions: ACUTE: INHAL OF VAPS MAY CONTRIBUTE TO THE OCCURRENCE
OF IRREGULAR HEARTBEAT (FP N). EYES:CONT W/LIQ OR VAP MAY CAUSE IRRIT. SKIN:
CONT W/LIQ MAY CAUSE FREEZING OF THE SKIN/ IRRIT. INHAL: OVEREXP BY INHAL
OF VAPORS MAY CAUSE RESP IRRIT OR NON-SPECIFIC DISCOMFORT SUCH AS NAUSEA,
HEADACHE OR WEAKNESS. INHAL OF CONCS ABOVE THE RECOMMENDED LIMITS MAY CAUSE
TEMP CNS DEPRESS WITH ANESTHETIC EFFECTS SUC H AS DIZZINESS, HEADACHE,
INCOORDINATION, AND LOSS OF CONSCIOUSNESS; OR TEMPORARY ALTERATION OF THE
HEART'S ELECTRICAL ACTIVITY (CARDIAC ARRHYTHMIA). GROSS OVEREXP MAY BE
FATAL. CHRONIC: NO CHRONIC HLTH EFTS KNOWN.
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.
*** END OF RECORD *** |
|
|