Search   
MSDS  : TT-V-71H, FLOOR AND TRIM VARNISH
CAS  : 64742-88-7
NAME  : mineral spirits, exempt
===================== Product Identification =====================

MSDS NAME:TT-V-71H, FLOOR AND TRIM VARNISH
NIIN:00-165-4420
MSDS Number: BJXHC
=== Responsible Party ===
Company:BAKER SEALANTS & COATINGS COMPANY
Address:234 SUYDAM AVENUE
Box:B
City:JERSEY CITY
State:NJ
ZIP:07304
Country:US
Info Phone Num:201-333-6986
Emergency Phone Num:201-333-6986
CAGE:FO833
=== Contractor Identification ===
Company:BAKER SEALANTS & COATINGS CO., INC.
Address:234 SUYDAM AVENUE
Box:B
City:JERSEY CITY
State:NJ
ZIP:07304-3306
Phone:(201) 333-6986
CAGE:FO833
Company:BAKER SEALANTS AND COATINGS CO
Address:234 SUYDAM AVE
Box:City:JERSEY CITY
State:NJ
ZIP:07304-3306
Country:US
Phone:201-333-6986
CAGE:34094
Company:STEVEN INDUSTRIES
Address:39 AVENUE C
Box:8
City:BAYONNE
State:NJ
ZIP:07002-3417
Country:US
Phone:201-437-6501
CAGE:33150

============= Composition/Information on Ingredients =============

Name:MINERAL SPIRITS, EXEMPT
CAS:64742-88-7
Fraction by Wt: 54%
Other REC Limits:NONE SPECIFIED
OSHA PEL:500 PPM
ACGIH TLV:125 PPM

===================== Hazards Identification =====================

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:INHALATION:IN EXTREME
CASES,UNCONSCIOUSNESS AND DEATH MAY OCCUR.INGESTION:INGESTION OF
PRODUCT MAY RESULT IN VOMITING.ASPIRATION OF VOMITUS INTO THE LUNGS
MUST BE AVOIDED AS EVEN SMALL QUANTITIES MAY RESULT IN ASPIRATION
PNEUMONITIS WHICH MAY BE EVIDENCED BY COUGHING,LABORED BREATHING
AND CYANOSIS.IN SEVERE CASES:DEATH
Effects of Overexposure:EYES:HIGH CONCENTRATIONS MAY BE
IRRITATING.SKIN:SLIGHTLY IRRITATING.PROLONGED EXPO MAY CAUSE
DEFATTING/DRYING OF SKIN,LEADING TO
IRRITATION/DERMATITIS.INHALE:HIGH CONCENTRATIONS MAY BE IRRIT TO
NOSE,R ESPIRATORY TRACT AND MAY CAUSE CENTRAL NERVOUS SYSTEM
DEPRESSION,EVIDENCED BY GIDDINESS HEADACHE,DIZZINESS AND NAUSEA.
Medical Cond Aggravated by Exposure:PREXISTING EYE, SKIN AND
RESPIRATORY DISORDERS MAY BE AGGRAVATED BY EXPOSURE TO THIS
PRODUCT.

======================= First Aid Measures =======================

First Aid:EYE:FLUSH W/WATER FOR 15 MIN WHILE HOLD EYELIDS OPEN.GEN MED
ATTN.SKIN:FLUSH W/WATER.REMOVE CONTAMINATED CLOTHES/SHOES.WASH
W/SOAP/WATER.DO NOT REUSE CLOTHES/SHOES UNTIL CLEANED.IF IRRIT
PERSISTS,GET MED ATTN.INHALE:REMOVE TO FRESH AIR/PROVIDE OXYGEN IF
BREATHING DIFFICULT.GIVE CPR IF NOT BREATHING.GET MED
AID.INGESTION:DO NOT INDUCE VOMIT.IF VOMIT OCCURS
SPONTANEOUSLY,KEEP HEAD BELOW HIPS.*

===================== Fire Fighting Measures =====================

Flash Point Method:TCC
Flash Point:105F/41C
Lower Limits:1
Upper Limits:6
Extinguishing Media:WATER FOG, FOAM, DRY CHEMICAL OR CARBON DIOXIDE.
Fire Fighting Procedures:DO NOT ENTER SPACE W/OUT FULL BUNKER
GEAR,INCLUDE POSITIVE PRESS NIOSH APPROVE SCBA.COOL FIRE EXPOSE
CONTAINER W/H2O.DO NOT USE DIRECT STRM OF H2O ON POOL FIRES
Unusual Fire/Explosion Hazard:CONTAINER EXPOSED TO HIGH HEAT FROM FIRE
SHOULD BE COOLED W/WATER TO PREVENT VAPOR PRESS BUILD-UP.COOL
CONTAINER AREAS EXPOSED TO DIR FLAME W/LARGE QUANT WATER.

================== Accidental Release Measures ==================

Spill Release Procedures:REMOVE SOURCES OF IGNIT.WEAR APPROPRIATE
RESPIRATOR/PROTECT CLOTH.SHUT OFF SOURCE IF
SAFE.DIKE/CONTAIN.REMOVE W/VACUUM TRUCKS/PUMP TO STORAGE/SALVAGE
VESSEL.SOAK UP W/ABSORBENT.PLACE IN NON-LEAK CONTA INER/SEALED
TIGHTLY FOR DISPOSE.FLUSH AREA W/WATER

====================== Handling and Storage ======================

Handling and Storage Precautions:THIS PRODUCT IS CLASSIFIED AS AN
OIL.SPILLS INTO SURFACE WATERS,AIR OR LAND MUST BE REPORTED TO THE
NATIONAL RESPONSE CENTER 1-800-424-8802.
Other Precautions:VAPORS MAY ACCUMULATE/TRAVEL TO IGNIT SOURCES DISTANT
FROM THE HANDLING SITE.KEEP CONTAINERS CLOSED WHEN NOT IN USE.DO
NOT CUT,DRILL,GRIND,WELD,ETC.ON/NEAR CONTAINERS.SURFACES THAT ARE
SUFFICIENTLY HO T MAY IGNIT PRODUCT IN ABSENCE OF SPARK.

============= Exposure Controls/Personal Protection =============

Respiratory Protection:IF EXPOSURE DOES EXCEED OCCUPATIONAL EXPOSURE
LIMITS,USE A NIOSH APPROVED RESPIRATOR AS REQUIRED TO PREVENT
OVEREXPOSURE.USE EITHER AN ATMOSPHERE SUPPLYING RESPIRATOR OR AN
AIR PURIFYING RESPIRATOR FO R ORGANIC VAPORS.
Ventilation:USE EXPLOSION-PROOF VENTILATION AS REQUIRED TO CONTROL
VAPOR CONCENTRATIONS WITHIN SUGGESTED PEL/TLV LIMITATIONS.
Protective Gloves:WEAR CHEMICAL RESISTANT GLOVES
Eye Protection:WEAR SAFETY GLASSES OR GOGGLES
Other Protective Equipment:SAFETY SHOWER, EYE BATH AND WASHING
FACILITIES SHOULD BE AVAILABLE.
Work Hygienic Practices:WASH WITH SOAP/WATER BEFORE
EATING,DRINKING,SMOKING OR USING TOILET FACILITIES.NO SMOKING WHERE
MATERIAL IS USED/STORED.
Supplemental Safety and Health
*NOTE TO DOCTOR:MORE THAN 2.0 ML PER KG IS INGESTED AND VOMITING HAS
NOT OCCURED,EMESIS SHOULD BE INDUCED W/SUPERVISION.KEEP VICTIM HEAD
BELOW HIP TO PREVENT ASPIRATION.IF SYMPTOMS AS LOSS OF GAG REFL
EX,CONVULSIONS/UNCONSCIOUSNESS OCCUR BEFORE EMESIS,GASTRIC LAVAGE
USING A CUFFED ENDOTRACHEAL TUBE SHOULD BE CONSIDERED.

================== Physical/Chemical Properties ==================

HCC:F4
Boiling Pt:B.P. Text:323 TO 390F
Vapor Pres:0.1 PSI
Vapor Density:HEAVIER
Spec Gravity:.874
Evaporation Rate & Reference:SLOWER THAN ETHER

================= Stability and Reactivity Data =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS SUCH AS LIQUID CHLORINE, CONCENTRATED OXYGEN,
SODIUM OR CALCIUM HYPOCHLORITE.
Stability Condition to Avoid:AVOID HEAT, FLAME
Hazardous Decomposition Products:CARBON MONOXIDE AND UNIDENTIFIED
ORGANIC COMPOUNDS DURING COMBUSTION.

==================== Disposal Considerations ====================

Waste Disposal Methods:SEAL CONTAINERS,LABEL PROPERLY AND DISPATCH TO
APPROVED WASTE DISPOSAL FACILITY.ASSURE COMPLIANCE WITH ALL
LOCAL,STATE AND FEDERAL REGULATIONS.IF THIS PRODUCT BECOMES A WASTE
MATERIAL,IT WOULD BE IGNI TABLE HAZARDOUS WASTE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

*** END OF RECORD ***
Search More   
ALL PAGES On Chemical Property IN THIS GROUP
NAMECAS
DOW CORNING (R) S-2260 PRIME COAT 8030-30-6
2768-02-7
682-01-9
5593-70-4
2157-45-1
PRO-SEAL 870, CLASS A, BASE 108-88-3
9003-35-4
PROSEAL 870 ALL CLASS & TYPES, ACCELERATOR 13423-61-5
102-06-7
1313-13-9
EASY FLO 3;AWS SPEC.AS 8,3AG-3 7440-22-4
7440-50-8
7440-66-6
7440-43-9
7440-02-0
ACTIVATOR BA-5 68187-11-1
112945-52-5
REMOVER FLOOR POLISH 6834-92-0
ETHYL ACETATE 141-78-6
MOLYLUBE 1200
L-TEC TUNGSTEN ELECTRODES 7440-33-7
1314-20-1
7440-67-7
AMMONIA INHALANT SOLUTION,NDC 00839-0076-99,U 1-24 7664-41-7
64-17-5
AK-024 CARPET CLEANER
SCOTCHGARD(TM) BRAND PROTECTOR FOR FABRICS 71-55-6
124-38-9
109-87-5
75-65-0
78-92-2
DOW CORNING(R)3145RTV ADHES SEALANT-CLEAR 68909-20-6
1185-55-3
13463-67-7
PETROLEUM BASED RUST PREVENTATIVE 124-38-9
8052-41-3
64742-53-6
OXALIC ACID 144-62-7
GSA TYPE I SWEEPING COMPOUND 8002-05-9
9004-34-6
112945-52-5
AA1550 WAX, LIQUID 8052-41-3
S-8 SOLVENT 108-88-3
108-65-6
SCOTCH-WELD(R)EPOXY ADHESIVE 2214 REGULAR 7429-90-5
63231-67-4
150-68-5
598-94-7
GLYPTAL AIR DRY ENAMEL 1201 1330-20-7
8030-30-6
64741-41-9
WAX, FLOOR, WATER-EMULSION TYPE 7732-18-5
68441-17-8
8002-26-4
90-43-7
128-37-0
100-37-8
78-51-3
1336-21-6
PRIMER COATING 724222 EPOXY POLYAMIDE 108-88-3
78-83-1
107-98-2
7789-06-2
13463-67-7
14807-96-6
14808-60-7
63231-67-4
SODIUM SULFITE, CRYSTAL 3888, 3922 7757-83-7
SCOTCH-WELD2216B/A PT A GRAY EPOXY ADHESIVE 1332-58-7
1333-86-4
SCOTCH-WELD(TM)2216 B/A PT B GRAY EPOXY ADH 25068-38-6
1318-74-7
PLASTIC PLASTISOL
ADHESIVE-SCOTCH-WELD (R) 2216 A GRAY 1302-76-7
1333-86-4
ADHESIVE-SCOTCH-WELD (R) 2216 B GRAY 80-05-7
1302-76-7
RTV159, SILICONE SEALANT 4253-34-3
ECCOBOND 45 CLEAR
CATALYST 15 CLEAR 112-24-3
PR-1431-G AND GT, PART A 13423-61-5
14307-33-6
PR-1431-G, TYPE I, PART B 9003-35-4
25068-38-6
108-88-3
13423-61-5
RTVS 51 WHITE, RS-0051-610000-A
CAT 2, RC-0002-660000-B
2-TON CLEAR EPOXY HARDENER 140-31-8
25154-52-3
2-TON CLEAR EPOXY RESIN 25068-38-6
12 7439-89-6
7439-96-5
13463-67-7
1312-76-1
1344-09-8
TT-V-71H, FLOOR AND TRIM VARNISH 64742-88-7
THERMOMETER,MERCURY 7439-97-6
AMYL ACETATE PRIMARY 628-63-7
CLEANING COMPOUND, SOLVENT DETERGENT 111-76-2
106-89-8
CLEANING COMPOUND SOLVENT DETERGENT 1310-58-3
111-76-2
6834-92-0
68412-54-4
CLEANER-DEGREASER DG1 67-56-1
9016-45-9
1303-96-4
533-96-0
25155-30-0
7732-18-5
SCOTCH-WELD(TM)1838-A EPOXY ADHESIVE(GREEN) 68410-23-1
1318-74-7
112-24-3
112945-52-5
SCOTCH-WELD 1838-B EPOXY ADHESIVE (GREEN) 25068-38-6
1332-58-7
68953-58-2
1317-65-3
13463-67-7
SCOTCH-WELD (R) EPOXY ADHESIVE 2214 REGULAR 7429-90-5
63231-67-4
150-68-5
598-94-7
GLYPTAL-G7526F 8030-30-6
110-80-5
1330-20-7
64741-41-9
138-86-3
THERMOFIT S-1009 ADHESIVE 25068-38-6
112945-52-5
68410-23-1
140-31-8
TT-E-529F, BROWN 20117,X9358 108-88-3
67-64-1
1330-20-7
74-98-6
75-28-5
106-97-8

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net