===================== Product Identification =====================
MSDS NAME:THINNER, PAINT TYPE III-ODORLESS
NIIN:00-837-7969
MSDS Number: BJZDS
=== Responsible Party ===
Company:CHEMICAL SPECIALISTS & DEVELOPMENT
Address:5 HACKBERRY LANE
City:CUT & SHOOT
State:TX
ZIP:77303
Country:US
Info Phone Num:409-756-1065
Emergency Phone Num:800-424-9300
Preparer's Name:DAVID SHIPP
CAGE:CHEMS
=== Contractor Identification ===
Company:CHEMICAL SPECIALISTS INC
Address:149 WEST TRIGG AVE
City:HARRISBURG
State:NC
ZIP:28075
Country:US
Phone:704-522-0825
CAGE:CHEMS
Company:CSD INC. (PRE 1985 NAME: MATHEWS, INC)
Address:420 SEABOARD DRIVE
Box:City:MATTHEWS
State:NC
ZIP:28105-5073
Country:US
Phone:704-821-9822
CAGE:5W216
============= Composition/Information on Ingredients =============
Name:STODDARD SOLVENT
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: 100%
Other REC Limits:*
OSHA PEL:500 PPM
ACGIH TLV:100 PPM; 9293
===================== Hazards Identification =====================
Health Hazards Acute and Chronic:EYES:CAUSE SEVERE
IRRITATION,REDNESS,TEARING,BLURRED VISION.SKIN:PROLONGED OR
REPEATED CONTACT CAN CAUSE MODERATE
IRRITATION,DEFATTING,DERMATITIS.BREATHING:EXCESSIVE INHALATION OF
VAPORS CAN CAUSE NAS AL & RESPIRATORY
IRRITATION,DIZZINESS,WEAKNESS,FATIGUE,NAUSEA,HEADACHE,POSSIBLE
UNCONSCIOUSNESS AND EVEN ASPHYXIATION*
Effects of Overexposure:*SWALLOWING:CAN CAUSE GASTROINTESTINAL
IRRITATION,NAUSEA,VOMITING AND DIARRHEA.ASPIRATION OF MATERIAL INTO
THE LUNGS CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL
======================= First Aid Measures =======================
First Aid:SKIN:WASH W/SOAP & WATER.REMOVE CONTAM CLOTHES. WASH BEFORE
RE-USE.EYES:FLUSH W/LOTS OF WATER,LIFTING UPPER/LOWER LIDS
OCCASIONALLY,GET MED ATTN.SWALLOWED:DO NOT INDUCE VOMIT.KEEP
WARM/QUIET/GET MED A TTN.ASPIRATION OF MAT'L INTO LUNGS DUE TO
VOMIT CAN CAUSE CHEM PNEUMONITIS WHICH CAN BE FATAL.BREATHED:REMOVE
TO FRESH AIR.IF BREATHING DIFFICULT,GIVE O,IF BREATHING STOPPED
GIVE CPR.KEEP WARM/QUIET.
===================== Fire Fighting Measures =====================
Flash Point Method:TCC
Flash Point:140F/60C
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:REGULAR FOAM OR CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR SELF-CONTAINED BREATHING APPARATUS WITH A
FULL FACEPIECE OPERATED IN PRESSURE-DEMAND OR OTHER POSITIVE
PRESSURE MODE WHEN FIGHTING FIRES.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR/TRAVEL ALONG
THE GROUND/MOVED BY VENT/IGNITED BY HEAT/OTHER IGNIT SOURCES AT
LOCATIONS DISTANT FROM MAT'L FROM HANDLING POINT.
================== Accidental Release Measures ==================
Spill Release Procedures:ELIM ALL IGNIT SOURCES.PERSONS NOT WEARING
PROTECT EQUIP,EXCLUDE FROM AREA.STOP SPILL AT SOURCE,DIKE AREA.PUMP
LIQUID TO SALVAGE TANK.TAKE UP REMAINING ON SAND,CLAY/OTHER ABSORB
MAT'L/SHOVEL INTO CONT AINERS.PREVENT RUNOFFS TO SEWERS,BODIESOF
H2O.
====================== Handling and Storage ======================
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTIED.SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUES,ALL HAZARD
PRECAUTIONS MUST BE OBSERVED.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:IF TLV IS EXCEED,A NIOSH/MSHA APPROVED AIR
SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE OF PROPER ENVIRONMENTAL
CONTROL.OSHA REGS ALSO PERMIT OTHER RESPIRATORS UNDER SPECIFIED
CONDITIONS.ENGINEERING/ADMI N CONTROLS SHOULD BE USED TO REDUCE
EXPO
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV'S.
Protective Gloves:NITRILE RUBBER GLOVES
Eye Protection:CHEM SPLASH GOGGLES/SAFETY GLASSES.
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Supplemental Safety and Health
================== Physical/Chemical Properties ==================
HCC:F4
Boiling Pt:B.P. Text:360F/182C
Melt/Freeze Pt:M.P/F.P Text:-20F,-29C
Vapor Pres:.05
Vapor Density:5.17
Spec Gravity:0.740
Evaporation Rate & Reference:.03 (ETHYL ETHER=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR, LITTLE IF ANY COLOR, SLIGHT OIL ODOR
Percent Volatiles by Volume:100
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS:CARBON
DIOXIDE AND CARBON MONOXIDE,VARIOUS HYDROCARBONS, ETC.
==================== Disposal Considerations ====================
Waste Disposal Methods:SMALL:ALLOW VOLATILE PORTION TO EVAPORATE IN
HOOD.ALLOW SUFFICIENT TIME FOR VAPORS TO COMPLETELY CLEAR HOOD DUCT
WORK.LARGE:DESTROY BY LIQUID INCINERATION.CONTAMINATED ABSORB MAY
BE DEPOSITED IN A LAN DFILL IN ACCORD WITH LOCAL,STATE AND FEDERAL
REGS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|