===================== Product Identification =====================
MSDS NAME:PETROTECT IX,MIL-C-16173,GRADE 1
NIIN:00-062-6950
MSDS Number: BCWTR
=== Responsible Party ===
Company:PENRECO
Address:700 MILIAM ST PENNZOIL PL
Box:2967
City:HOUSTON
State:TX
ZIP:77252
Country:US
CAGE:PENRE
=== Contractor Identification ===
Company:PENRECO
Address:4401 PARK AVENUE
City:DICKINSON
State:TX
ZIP:77539
Country:US
Phone:713-236-6070
CAGE:PENRE
Company:PENRECO, DIV OF PENNZOIL CO
Address:700 MILIAM ST
Box:2967
City:HOUSTON
State:TX
ZIP:77252
Country:US
Phone:800-245-3952
CAGE:86459
============= Composition/Information on Ingredients =============
Name:NAPHTA (PETROLEUM SPIRITS OR BENZIN)
CAS:8030-30-6
RTECS #:DE3030000
Fraction by Wt: 37%
OSHA PEL:100 PPM
===================== Hazards Identification =====================
Effects of Overexposure:EYE: BURN/IRRIT. SKIN: IRRIT. VAPORS:
IRRIT,DROWSINESS,PNEUMONIA,COMA. INGESTION: IRRIT GI TRACT
======================= First Aid Measures =======================
First Aid:EYE: FLUSH WITH WATER 14 MIN,CALL PHYSICIAN. SKIN: WASH WITH
SOAP & WATER,REMOVE CONTAMINATED CLOTHING. INHALATION: REMOVE TO
FRESH AIR,GIVE ARTIF RESP IF NEEDED,CALL MD. INGESTION: DO NOT
INDUCE VOMI TING,CALL A PHYSICIAN.
===================== Fire Fighting Measures =====================
Flash Point:100F/37C (PMCC)
Extinguishing Media:FOAM,DRY CHEMICAL,CARBON DIOXIDE
Fire Fighting Procedures:TREAT AS AN OIL FIRE,WATER ONLY TO COOL
EXPOSED CONTAINERS
Unusual Fire/Explosion Hazard:DENSE SMOKE MAY BE GENERATED WHEN
BURNING,SOLVENT CAN CREATE MODERATE FIRE OR EXPLOSION HAZARD
================== Accidental Release Measures ==================
Spill Release Procedures:REMOVE FROM IGNITION SOURCES,SCRAPE MATERIAL
INTO WASTE CONTAINERS,OR ABSORB WITH DRY SAND OR OIL ABSORBENTS.
CLEAN SPILL AREA WITH DETERGENT SOLUTIONS OR SAFETY,SOLVENTS,
PROVIDE ADEQUATE VENTILATION DURING CLEAN UP.
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN SEALED CONTAINERS AWAY FROM
HEAT,OPEN FLAME,AND OXIDIZING MATERIALS.
Other Precautions:FIRE EXTINGUISHERS MUST BE KEPT READLY AVAILABLE &
PERSONNEL TRAINED IN PROPER USE.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:NIOSH/MSHA APPROVED RESP DEVICE IN ACCORD WITH
EXPOSURE OF CONCERN
Ventilation:LOCAL/GENERAL
Protective Gloves:RUBBER,SYNTHETI
Eye Protection:SPLASH PROCF GOGGLES
Other Protective Equipment:RUBBER PROTECTIVE CLOTHING,BOOTS,APRONS
Supplemental Safety and Health
50% DISTILLATION TEMPERATURE IS BETWEEN 300-360F. PKG: 1 QT CAN.
SOLVENTCONTAINS NO DETECTABLE BENZENE (IE: <3 PPM)
================== Physical/Chemical Properties ==================
Boiling Pt:B.P. Text:300F/148C
Vapor Density:4.3
Spec Gravity:0.912
Evaporation Rate & Reference:<1 (EE)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK LIQUID ASPHALT,HYDROCARBON SOLVENT ODOR
Percent Volatiles by Volume:37
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Hazardous Decomposition Products:CO,CO*2,SMOKE,SO*X
==================== Disposal Considerations ====================
Waste Disposal Methods:WASTE MATERIALS SHOULD BE DUMPED OR BURIED IN AN
APPROVED INDUSTRIAL WASTE LAND FILL. LARGE QUANTITIES MAY BE
DISPOSED OF BY INCINERATION IN A SUITABLE COMBUSTION CHAMBER.
DISPOSAL MUST COMPLY WITH AL L FEDERAL,STATE & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|
|