=====================  Product Identification  =====================

MSDS NAME:WM. BIRD LATEX WALL PRIMER/SEALER, 5-8550
NIIN:00N083235
MSDS Number: CGPXN
=== Responsible Party ===
Company:WATTYL PAINT CORP
Address:5275 PEACHTREE INDUSTRIAL BLVD
City:ATLANTA
State:GA
ZIP:30341
Country:US
Info Phone Num:404-455-7000
Emergency Phone Num:404-455-7000
CAGE:WATTL
=== Contractor Identification ===
Company:WATTYL PAINT CORP
Address:5275 PEACHTREE INDUSTRIAL BLVD
City:ATLANTA
State:GA
ZIP:30341
Country:US
Phone:404-455-7000
CAGE:WATTL

=============  Composition/Information on Ingredients  =============

Name:ETHYLENE GLYCOL (SARA 313) (CERCLA) VP: 0,1 @ 20C
CAS:107-21-1
RTECS #:KW2975000
OSHA PEL:C 50 PPM (MFR)
ACGIH TLV:C 50 PPM, VAPOR
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION: WITH POOR
    VENTILATION, VAPOR OR SPRAY MIST MAY IRRITATE RESPIRATORY MUCOUS
    MEMBRANES, CAUSING HEADACHE AND NAUSEA. EYES: PRIMARY IRRITATION.
    CHRONIC: NONE SPECIFIED BY MANUFACTURER.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: FLUSH IMMEDIATELY WITH
    LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. TAKE TO MD FOR
    MEDICAL TREATMENT. SKIN: REMOVE WITH SOAP AND WATER. IF DRENCHED,
    REMOVE CO NTAMINATED CLOTHING. INGESTION: IF VICTIM IS CONSCIOUS,
    GIVE 2 GLASSES OF WATER TO DILUTE. DO NOT INDUCE VOMITING. CONSULT
    MD OR POISON CONTROL CENTER.

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Lower Limits:NONE
Extinguishing Media:WATER FOG (APPALICABLE ONLY FOR COOLING CLOSED
    CONTAINERS).
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA AND FULL PROTECTIVE
    EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE WHEN
    EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AS DESCRIBED IN VENTILATION SECTION.
    AVOID UNNECESSARY SKIN CONTACT. COLLECT BY ABSORPTION, SHOVEL
    AND/OR WET MOPPING.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. CLOSE
    CONTAINER AFTER EACH USE. DO NOT TAKE INTERNALLY.
Other Precautions:NOTE: PIGMENTED PAINTS & COATINGS (THOSE WHICH ARE
    OPAQUE, COLORED/WHICH HAVE REDUCED GLOSS WHEN DRY) MAY CONTAIN
    MATLS SUCH AS SILICA, TALC, CALCIUM CARBONATE, TITANIUM DIOXIDE,
    ETC, WHICH ARE HAZ TO  INHALE IN DRY POWDER FORM. (SUP DAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:DURING SPRAY APPLICATION USE NIOSH APPROVED
    MECHANICAL FILTER RESPIRATOR TO REMOVE SOLID AIRBORNE PARTICLES OF
    OVERSPRAY.
Ventilation:PROVIDE SUFFICIENT VENT, IN VOL & PATTERN, TO INSURE VAP
    CONCS WELL BELOW ANY TLV & LEL LISTED IN INGREDIENTS SECTION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:NONE REQUIRED. EMERGENCY EYEWASH AND DELUGE
    SHOWER MEETING ANSI DESIGN CRITERIA .
Work Hygienic Practices:OBSERVE GOOD SANITARY PRACTICES.
Supplemental Safety and Health
OTHER PREC: THESE HAZS ARE NOT BELIEVED TO BE PRESENT WHEN POWDERS ARE
    DISPERSED IN LIQ COATINGS. HOWEVER, PREC SHOULD BE CAREFULLY
    OBSERVED & NIOSH APPRVD RESPS SHOULD ALSO BE USED IF DRIED COATING
    I S SANDED/ABRADED IN SUCH A WAY AS TO PRODUCE DUST.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER
Percent Volatiles by Volume:72

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE REASOBALY FORESEEABLE.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:WHEN HEATED TO DECOMPOSITION, AS IN A
    FIRE OR IN WELDING, MAY PRODUCE TOXIC FUMES SUCH AS CARBON
    MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH LOCAL, STATE AND
    FEDERAL REGULATIONS. DO NOT INCINERATE CLOSED CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***