=====================  Product Identification  =====================

MSDS NAME:NAVY GRAY, AL106U
NIIN:00N084448
MSDS Number: CGTDY
=== Responsible Party ===
Company:COURTAULDS COATINGS INC
Address:6003 ANTOINE DR
City:HOUSTON
State:TX
ZIP:77091
Country:US
Info Phone Num:713-682-1711
Emergency Phone Num:800-854-6813;800-424-9300(CHEMTREC)
CAGE:50411
=== Contractor Identification ===
Company:COURTAULDS COATINGS INC
Address:400 S 13TH STREET
Box:City:LOUISVILLE
State:KY
ZIP:40203-1714
Country:US
Phone:502-588-9651
CAGE:50411
Company:INTERNATIONAL PAINT INC. INTERNATIONAL
Address:6001 ANTOINE DR
Box:City:HOUSTON
State:TX
ZIP:77091
Country:US
Phone:800-589-1267/800-854-6813
CAGE:69827

=============  Composition/Information on Ingredients  =============

Name:CALCIUM CARBONATE
CAS:1317-65-3
RTECS #:EV9580000
Fraction by Wt: 25-50%
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
Fraction by Wt: 10-25%
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

Name:SUPDAT: STATIC CHARGE BUILDUP. THIS POWDER COATING IS DRY,
    FINELY GROUND ORGANIC POWDER W/NO APPRECIABLE VAPOR (ING 4)
RTECS #:9999999ZZ

Name:ING 3: PRESSURE @ ROOM TEMP. LIKE ALL POWDER COATINGS,
    PARTICLE SIZE DISTRIBUTION OF THIS PROD IS SUCH AS TO (ING 5)
RTECS #:9999999ZZ

Name:ING 4: FALL INTO CATEGORY OF "NUISANCE DUST", WHICH HAS
    TLV'S OF 5 MG/M3 RESPIRABLE DUST, 10 MG/M3 TOTAL DUST (ING 6)
RTECS #:9999999ZZ

Name:ING 5: & PEL'S OF 5MG/M3 RESPIRABLE DUST, 15 MG/M3 TOTAL
    DUST. THESE TLV'S & PEL'S APPLY TO THIS POWDERED PROD (ING 7)
RTECS #:9999999ZZ

Name:ING 6: EVEN WHEN NO HAZ INGREDS APPEAR. CALIFORNIA
    PROPOSITION 65: WARNING: THIS PROD CONTAINS CHEMICAL KNOWN (ING 8)
RTECS #:9999999ZZ

Name:ING 7: TO STATE OF CALIFORNIA TO CAUSE CANCER & BIRTH
    DEFECTS OR OTHER REPRODUCTIVE HARM.
RTECS #:9999999ZZ

Name:VENT: LIMITS SPECIFIED. B) REMOVE VOLATILES PRODUCED DURING
    CURE & DECOMP PRODS PRODUCED DURING WELDING OR (ING 10)
RTECS #:9999999ZZ

Name:ING 9: CUTTING ON SURFACES COATED WITH THIS PRODUCT.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHAL: POWDER MAY CAUSE
    IRRITATION OF RESPIRATORY TRACT IN SUSCEPTIBLE INDIVIDUALS. EYE
    CONT: CAUSES SEVERE IRRITATION. SKIN CONT: CAUSES IRRITATION.
    INGESTION: POWDER MAY CAUSE GASTRO-INTESTIN AL IRRITATION. REPEATED
    INHALATION IN EXCESS OF TLV/PEL OVER AN EXTENDED PERIOD OF TIME MAY
    RESULT IN (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: INJURY TO THE RESPIRATORY SYSTEM.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:GEN: IN ALL CASES OF DOUBT, OR WHEN SYMPS PERSIST, SEEK MED
    ATTN. INGEST: NEVER GIVE ANYTHING BY MOUTH TO UNCONSCIOUS PERSON.
    INHAL: REMOVE TO FRESH AIR. IF DISCOMFORT IS PRESENT/BREATHING IS
    ABSENT G ET MED ATTN IMMED. EYE CONT: FLUSH IMMED W/PLENTY OF WATER
    FOR @ LST 15 MINS UNTIL IRRIT SUBSIDES. IF IRRIT PERSISTS, GET MED
    ATTN. SKIN CONT: FLUSH W/LG AMTS OF WATER. USE SOAP IF AVAIL.
    (SUPDAT)

=====================  Fire Fighting Measures  =====================

Lower Limits:>30 G/CU M
Extinguishing Media:USE CARBON DIOXIDE, DRY CHEM, FOAM/WATER FOG UNLESS
    ALUMINUM AND/OR ZINC APPEAR IN INGREDS, IN WHICH CASE USE (SUPDAT)
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . DO NOT ALLOW POWDER TO BE DISPERSED INTO THE AIR WHILE
    EXTINGUISHING.
Unusual Fire/Explosion Hazard:WHEN SUSPENDED IN AIR AS DUST CLOUD, THIS
    PRODUCT IS POTENTIAL FIRE & EXPLOSION HAZARD. DECOMPOSITION AND
    COMBUSTION PRODUCTS MAY BE TOXIC.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNIT. AVOID INHAL OF
    DUST/VAPORS FROM HEATED PRODUCT. VENTILATE AREA. USE
    EXPLOSION-PROOF VACUUM EQUIPMENT FOR CLEAN UP.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:AVOID SKIN & EYE CONT. AVOID BRTHG
    DUST/VAP FROM HEATED PROD DURING CURE, CUTTING OPERATIONS/DURING
    BURNOFF.
Other Precautions:DO NOT USE NEAR SPKS, FLAMES/ANY OTHER IGNIT SOURCE.
    DUST CLOUDS ARE POTNTL FIRE & EXPLO HAZ. GROUND ALL EQUIP TO PVNT
    BUILDUP OF STATIC ELECTRICITY. SINCE REMOVAL OF SHRINK WRAPPING
    FROM CNTNRS CAN G ENERATE SPARKS OF STATIC (SUPDAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH APPRVD RESPIRATOR IN ACCORDANCE WITH
    29 CFR 1910.134 TO REMOVE PARTICLES (AND VAPS IF THERE IS OVEREXP
    TO VAPORS GENERATED DURING PROCESSING OF THIS PRODUCT).
Ventilation:PROVIDE SUFFICIENT VENT, IN VOL & PATTERN, TO: A) KEEP TLV
    OF HAZ INGREDS & LEL OF POWDER COATING ITSELF BELOW (ING 9)
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER .
    COVERALLS & HEAD PROTECTION ARE REC TO AVOID SKIN CONTACT.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXTING MEDIA: DRY CHEMICAL ONLY. FIRST AID PROC: REMOVE CONTAMD CLTHG
    (INCLUDING SHOES) & WASH BEFORE REUSE. IF IRRIT PERSISTS, GET MED
    ATTN. OTHER PREC: ELECTRICITY, ENSURE SUCH OPERATIONS ARE CARRIE D
    OUT IN SAFE AREA & IN SAFE MANNER. GROUNDING & BONDING OF CNTNRS IS
    REC WHEN TRANSFERRING POWDERS TO AVOID (ING 3)

==================  Physical/Chemical Properties  ==================

Spec Gravity:1.798
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT KNOWN
Appearance and Odor:FINE DRY POWDER.
Percent Volatiles by Volume:<1 WT

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
    VARIOUS HYDROCARBON FRAGMENTS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, AND
    FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***