===================== Product Identification =====================
MSDS NAME:HENRY 430 CLEAR THIN-SPREAD FLOOR TILE ADHESIVE
NIIN:01-261-4187
Status Code:A
MSDS Number: CJJJX
=== Responsible Party ===
Company:HENRY W W CO
Box:3001
City:LANCASTER
State:PA
ZIP:17604
Country:US
Info Phone Num:717-396-2328;717-396-2935
Emergency Phone Num:800-255-3924
CAGE:11761
=== Contractor Identification ===
Company:HENRY W W CO
Box:3001
City:LANCASTER
State:PA
ZIP:17604
Country:US
Phone:717-396-2328;717-396-2935
CAGE:11761
============= Composition/Information on Ingredients =============
Name:VM & P NAPHTHA (PER MSDS:MAY VARY DEPENDING ON SOLVENT
SUPPLIER)
CAS:64742-89-8
Fraction by Wt: 2-3%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:300 PPM
OSHA STEL:400 PPM
ACGIH TLV:300 PPM
===================== Hazards Identification =====================
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE/SKIN:MAY CAUASE
DRYING/CRACKING OF SKIN, DEFATTING OF TISSUE, DERMATITS. CONTACT
W/EYES: IRRIT. INHAL: VM&P NAPHTHA MAY CAUSE IRESP TRACT IRRIT,
COUGHING, CNS EFFECTS-HEADACHE, DIZZINESS, DR OWSINESS, NAUSEA.
Effects of Overexposure:TARGET ORGANS: UPPER RESP TRACT, SKIN, EYES.
Medical Cond Aggravated by Exposure:ANY CONDITIONS GENERALLY AGGRAVATED
BY SOLVENTS, INCLUDING PRE-EXISTING UPPER RESP & LUNG DISEASE:
BRONCHITIS, EMPHYSEMA, ASTHMA, & EXISTING SKIN CONDITIONS.
======================= First Aid Measures =======================
First Aid:EYE: IMMED FLUSH W/PLENTY OF WATER FOR @LEAST 15 MINS. REMOVE
CONTACT LENSES.HOLD EYELIDS OPEN. GET IMMED MED ATTN. SKIN:REMOVE
CONTAMIN CLOTH/SHOES. WASH THOROUGHLY W/SOAP/WATER. IF IRRIT
PERSISTS, G ET MED ATTN. INHAL:REMOVE TO FRESH AIR. IF SYMPTOMS
PERSIST, GET MED ATTN. INGEST:DO NOT INDUCE VOMITING. GET IMMED MED
ATTN.
===================== Fire Fighting Measures =====================
Flash Point Method:SCC
Flash Point:>93.3C, 200.F
Autoignition Temp:Autoignition Temp Text:NP
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON, WATER SPRAY
Fire Fighting Procedures:PROTECT FIRE FIGHTERS FROM TOXIC PRODUCTS OF
COMBUSTION: WEAR SELF-CONTAINED BREATHING APPARATUS & FULL
PROTECTIVE GEAR.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
DUE TO PRESSURE BUILD UP. USE WATER TO COOL CONTAINERS TO PREVENT
THIS.
================== Accidental Release Measures ==================
Spill Release Procedures:VENTILATE AREA. CONTAIN SPILL. PREVENT FROM
ENTERING SEWER LINES OR WATERWAYS. USE ABSORBENT TO ASSIST WITH
PICK UP OF MATERIAL. SCRAPE UP PRODUCT & PLACE INTO CONTAINER.
RESIDUAL OF PRODUCT WHILE STI LL WET CAN BE CLEANED UP W/ WARM
SOAPY WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN AREA SUITABLE FOR COMBUSTABLE
MIXTURES. STORAGE TEMPERATURE IS BELOW 90 F. VAPORS ARE HEAVIER
THAN AIR. USE PRECAUTIONS THAT ARE COMMON W/ SAFE HANDLING OF
COMBUSTABLE LIQUIDS.
Other Precautions:WORK SITE ENVIRON:INITIAL POTENTIAL ADVERSE IMPACT ON
INDOOR AIR QUALITY DURING INSTALLATION PROCESS.NOTIFY MANAGMENT
NECESSITY TO MAINTAIN ADEQUATE VENTILATION W/OUT CAUSING SPREAD OF
CONTAMINANTS TO OTHER PARTS OF BUILDING.PERSONS SENSITIVE TO
ODORS/CHEMICALS ADVISED TO AVOID WORK AREA DURING PROC ESS.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:WITH ADEQUATE VENTILATION, RESP EQUIP SHOULD NOT
BE NEEDED. IF NOT, WEAR NIOSH APPROVED RESP EQUIP FOR ORGANIC
VAPORS.
Ventilation:USE NATURAL CROSS VENTILATION. LOCAL(MECH) PICK UP, AND/OR
GENERAL AREA (MECH) VENTILATION TO PREVENT ACCUMULATION OF VAPORS.
Protective Gloves:NORMAL USE:COTTON/LOOP-PILE GLOVES.
Supplemental Safety and Health
VENTILATION PATTERNS MUST REMOVE HEAVIER THAN AIR SOLVENT VAPORS FROM
THE LOWER LEVELS OF WORK SPACES. VENTILATION MUST BE SUFFICIENT TO
KEEP THE SOLVENT VAPOR CONCENTRATIONS BELOW TLV.
================== Physical/Chemical Properties ==================
Boiling Pt:=100.C, 212.F
Melt/Freeze Pt:M.P/F.P Text:NA
Decomp Temp:Decomp Text:NP
Spec Gravity:1
VOC Pounds/Gallon:49
pH:9.2,NON PHOTOCH
Viscosity:NP
Solubility in Water:DISPERSIBLE.
Appearance and Odor:BEIGE CREAMY PASTE, MILD SOLVENT ODOR.
Percent Volatiles by Volume:56-58@200F
Corrosion Rate:NP
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE KNOWN.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE, &
TOXIC VAPORS AND GASES COMMON TO THERMAL DEGREDATION OF ORGANIC
COMPOUNDS.
===================== Ecological Information =====================
Ecological:CONTAINS SPILLS, PREVENTING THEM FROM ENTERING SEWER LINES
OR WATERWAYS. DO NOT FLUSH UNUSED CONTENTS OR RESIDUE DOWN DRAINS.
==================== Disposal Considerations ====================
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT FLUSH UNUSED CONTENTS OR RESIDUE DOWN
DRAINS. DO NOT REUSE CONTAINER.
===================== Regulatory Information =====================
SARA Title III Information:THIS PRODUCT DOES CONTAIN CHEMICALS SUBJECT
TO THE REPORTING REQUIREMENTS OF SECTION 313 SARA III AND 40 CFR
372.
Federal Regulatory Information:ALL COMPONENTS ARE ON TSCA INVENTORY.
IPD PRODUCTS DO NOT CONTAIN ASBESTOS.
======================================================================
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|