=====================  Product Identification  =====================

MSDS NAME:CALSOL 810
NIIN:01-399-4846
Status Code:A
MSDS Number: CKQWK
=== Responsible Party ===
Company:CALOMET LUBRICANTS
Address:10234 HWY 157
City:PRINCETON
State:LA
ZIP:71087
Country:US
Info Phone Num:318-940-2421
Emergency Phone Num:318-940-2421
CAGE:TO746
=== Contractor Identification ===
Company:CALOMET LUBRICANTS
Address:10234 HWY 157
Box:City:PRINCETON
State:LA
ZIP:71087
Country:US
Phone:318-940-2421
CAGE:TO746

=============  Composition/Information on Ingredients  =============

Name:SEVERELY HYDROTREATED LIGHT NAPHTHENIC DISTILLATE
CAS:64742-53-6
RTECS #:PY8036000

Name:SEVERELY HYDROTREATED HEAVY NAPHTHENIC DISTILLATE
CAS:64742-52-5
RTECS #:PY8035000

=====================  Hazards Identification  =====================

Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:TESTS ON SIMILAR MATERIALS SHOW A LOW
    ORDER OF ACUTE TOXICITY. MAY CAUSE MILD REVERSIBLE EYE AND SKIN
    IRRITATION. PROLONGED SKIN EXPOSURE MAY CAUSE DERMATITIS OR OIL
    ACNE. BREATHING MISTS MAY CAUSE DI ZZINESS OR PULMONARY IRRITATION.
    INGESTION MAY CAUSE CRAMPS & DIARRHEA.
Explanation of Carcinogenicity:NON-CARCINOGENIC

=======================  First Aid Measures  =======================

First Aid:IN ALL CASES REMOVE SOURCE OF EXPOSURE.  INHALATION: NOT
    LIKELY TO OCCUR EXCEPT AS MIST.  REMOVE PATIENT TO FRESH AIR AND
    CONTACT A PHYSICIAN.  IF BREATHING IS DIFFICULT GIVE OXYGEN.  EYES:
    FLUSH IMME DIATELY WITH WATER FOR AT LEAST 15 MINUTES OR UNTIL
    IRRITATION SUBSIDES.  IF IRRITATION PERSISTS, CONSULT A PHYSICIAN. 
    SKIN: WASH THOROUGHLY WITH SOAP AND WATER.	IF IRRITATION OR RASH
    DEVELOPS, CONS ULT A PHYSICIAN.  INGESTION: DO NOT INDUCE VOMITING.
     CONSULT A PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:=150.C, 302.F
MAY IGNITE
Extinguishing Media:DRY CHEMICAL, CARBON DIOXIDE, WATER FOG AND FOAM. 
    NOTE: WATER, FOG AND FOAM MAY CAUSE FROTHING AND SPATTERING.
Fire Fighting Procedures:USE WATER SPRAY TO COOL CONTAINERS EXPOSED TO
    FLAMES.  FIRE FIGHTING PERSONNEL SHOULD WEAR RESPIRATORY PROTECTION
    (POSITIVE PRESSURE IF AVAILABLE).
Unusual Fire/Explosion Hazard:PRODUCT OF COMBUSTION INCLUDE FUMES,
    SMOKE AND CARBON MONOXIDE. MATERIAL MAY IGNITE AT OR ABOVE THE
    FLASH POINT IF IGNITION SOURCE IS PRESENT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SHUT OFF IGNITION SOURCES.  CONTAIN SPILL AND
    KEEP FROM ENTERING WATERWAYS OR SEWERS.  LARGE QUANTITIES CAN BE
    PUMPED.  SMALL QUANTITIES MAY BE SOAKED UP ON OIL ABSORBANTS. 
    CONSULT YOUR SPCO PLAN.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP AWAY FROM FLAMES, SPARKS OR HOT
    SURFACES.  NEVER USE A TORCH TO CUT OR WELD ON OR NEAR CONTAINER. 
    EMPTY OIL CONTAINERS CAN CONTAIN EXPLOSIVE VAPORS.
Other Precautions:NEVER WEAR OIL SOAKED CLOTHING.  LAUNDER OR DRY CLEAN
    BEFORE WEARING.  DISCARD OIL SOAKED SHOES.	AFFIX PROPER WARNING
    LABELS ON CONTAINERS IN ACCORDANCE WITH 29 CFR 1910.1200.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NORMALLY NOT REQUIRED IF ADEQUATE VENTILATION. 
    IF EXPOSURE LIMIT IS EXCEEDED, NIOSH/MSHA APPROVED APPARATUS IS
    REQUIRED.
Ventilation:IF MISTS ARE PRESENT, PROVIDE ADEQUATE VENTILATION TO
    CONTROL LEVEL BELOW THE PERMISSABLE EXPOSURE LIMIT.
Protective Gloves:OIL RESISTANT (NEOPRENE OR PLASTIC)
Other Protective Equipment:IF THERE IS A LIKELIHOOD OF OIL SPLASHING,
    AN OIL RESISTANT APRON SHOULD BE WORN TO PREVENT CLOTHING
    CONTAMINATION.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Boiling Pt:=260.C, 500.F
Vapor Pres:BELOW 0.5 ISOTENISCOPE
Vapor Density:ABOVE 5
Spec Gravity:0.9
Evaporation Rate & Reference:NEGLIGIBLE
Solubility in Water:NOT SOLUBLE
Appearance and Odor:CLEAR, PALE STRAW TO WATER WHITE LIQUID; MINERAL
    OIL ODOR

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.  NEVER PERMIT OIL TO GET IN AN OXYGEN REGULATOR.
Hazardous Decomposition Products:CARBON MONOXIDE AND OTHER COMBUSTION
    PRODUCTS OF HYDROCARBONS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE ACCORDING TO CURRENT LOCAL, STATE AND
    FEDERAL REGULATIONS.  MATERIALS MAY BECOME HAZARDOUS WASTE THROUGH
    USE.  IF PERMITTED, INCINERATION MAY BE PRACTICAL.	CONSIDER
    RECYCLING.

===================  MSDS Transport Information  ===================

Transport Information:DOT HAZARD CLASS: NON-HAZARDOUS

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***